-
Haier HDT18PA - page 1
Table Top Dishwasher User Manual Model # HDT18P A ON OFF OPEN CLOSE Rinse Hold Normal Heavy Vented Dry HDT18PA ...
-
Haier HDT18PA - page 2
GB IMPORT ANT SAFETY INSTRUCTIONS 1. Read all instructions before using the appliance. 2. Use this appliance only for its intended purpose as described in this use andcare guide. 3. Use only detergents recommended for use in this appliance and keep them out of the reach of children. 4. This appliance must be properly installed in accordance with th ...
-
Haier HDT18PA - page 3
2 faucets and let the hot water run for a few minutes. This will let the trapped hydrogen escape. During this process do not turn on an electric appliance,smoke, light a match/ lighter or use a flame to avoid an accident, as hydrogen gas is flammable and can explode. 20. Do not repair or replace any part of the appliance or attempt any ser vicing u ...
-
Haier HDT18PA - page 4
SAFETY INSTRUCTIONS ........................................................................... 1 OPERATING INSTRUCTIONS ...................................................................4 P arts and Features..........................................................................................4 Operations ...................................... ...
-
Haier HDT18PA - page 5
OPERA TING INSTRUCTIONS 4 Parts and Features 1 2 3 4 5 6 1. on/off button 2. dr y indicator light 3. wash cycle select buttons (normal / heavy / rinse et hold) 4. wash indicator light 5. door latch (to lock / unlock the door) 6. door ON OFF OPEN CLOSE Rinse Hold Normal Heavy Vented Dry HDT18PA GB ...
-
Haier HDT18PA - page 6
5 3 2 1 1. exhaut vent 2. power cord (115V -60Hz) ) 3. water inlet tube 4. drain hose 4 GB ...
-
Haier HDT18PA - page 7
6 8 9 1 1. water inlet 2. door seal 3. upper spray arm 4. lower spray arm 5. filter -located at the bottom of lower rack (not shown) 6. detergent dispenser 7. upper half rack 8. lower rack 9. silverware basket 7 2 3 4 5 6 GB ...
-
Haier HDT18PA - page 8
7 Push the button in to have power "ON". Push the button out to have the power "OFF". OPERA TIONS Power Button: When V ented dr y cycle is selected, the light comes onindicating that it is now dr ying. At the end of the cycle,the buzzer will beep indicating that dr y cycle is completed.Also, the machine will shut off automatical ...
-
Haier HDT18PA - page 9
8 Y our machine is equipped with automatic fault detection system. This convenience feature informs you of any faults during the operation. When fault occurs, the wash indicator light will flash and the buzzer will beep. Automatic Fault Alarm: Preparing to wash dishes: T o get best results, practice the following before you put dishware in the dish ...
-
Haier HDT18PA - page 10
9 T o get maximum cleaning result, follow the recommendations below before you start the dishwasher: Loading the lower & Upper half rack: Note: Do not wash any heat sensitive or any other items that are not designed for automatic dishwasher. Simply remove the basket out of the dishwasher to load silverware and place it back once you finish load ...
-
Haier HDT18PA - page 11
Use proper recommended amount of detergent for your wash loads. Pour in detergent into open compartment that is located on the inside of the door . Pouring Dishwasher Detergent: The amount of detergent to use depends on the type of water in your living area whether it is hard or soft and whether items are lightly or heavily soiled. W ater softness ...
-
Haier HDT18PA - page 12
11 Note: Use only manufacturer's recommended "Automatic Dishwasher Detergent" only for your dishwasher. Other types of detergents that are not for dishwasher use may cause oversudsing and foaming. Do not use detergents that are dried, caked or moist. These types of detergents will not dissolve properly and clean effectively. 1. Make ...
-
Haier HDT18PA - page 13
This cycle is used for rinsing partial loads that will be washed later . The total wash time for "Wash Only" cycle is approximately 6 minutes. Note: Do not use detergent with this cycle. Vented Dry (On/Off): Y ou can select this option at the beginning of the wash cycle to dr y your dishware items. Press the button in to have vented dry o ...
-
Haier HDT18PA - page 14
13 Y ou incoming water must be between at least 120 Degree F / 49 Degree C and most 150 Degree F / 66 Degree C but no more than 150 Degree F / 66 Degree C in order to have effective cleaning and prevent damage to your dishware. Note : We recommend that you select hot water instead of cold water from the faucet to reduce the time to heat up the wate ...
-
Haier HDT18PA - page 15
The following suggestions are recommended to prevent stains and films from dishware and utensils items: Tips to avoid stains and films: 14 Y ou must rinse all dishware, silverware, glassware and food containers right a way after use. Some citric based food products, coffee, tea and iron deposits in water can cause yellow or brown film on inside sur ...
-
Haier HDT18PA - page 16
15 Do not use abrasive, harsh cleaners, solvents, concentrated detergents or metal scouring pads to clean the inside of dishwasher. Use warm soapy water with soft brush or piece of cloth to clean the interior of a tub. Clean around the tub gasket with a damp cloth. When cleaning control panel, use a lightly dampened cloth around it then dr y thorou ...
-
Haier HDT18PA - page 17
Y ou must protect your dishwasher if it is lef t in an unheated place during the winter . Preventing Your Dishwasher from Freezing: Y ou must store the dishwasher at room temperature. Do not install or operate your dishwasher where the temperature is below freezing. If you just got a deliver y of a dishwasher when outside temperature is below freez ...
-
Haier HDT18PA - page 18
17 Check if the unit is plugged in. The plug may have come loose. Check if the electrical wall receptacle is of proper voltage. Check if circuit breaker needs to be reset or if the fuse needs to be replaced. Check if the unit is on "Off" mode. Check if the door is open. Y ou may have to close the door properly . Dishes are not dry: Dishwa ...
-
Haier HDT18PA - page 19
This is due to poor loading or overloading. Y ou need to be careful when loading. Do not overload. Y ou need to place glassware securely against pins. Make sure delicate items are on the side rack. We recommend that fine chinaware or cr ystalitems should be hand washed. Dishware chipped: Some of the sounds you will hear are normal. Noise: This is d ...
-
Haier HDT18PA - page 20
19 T oo much detergent used. Use the appropriate amount of detergent. Reduce amount of detergent used per load. The water temperature is too hot. Y ou need to lower water temperature. Use of old detergent. Avoid using old detergent. R ead expiration date. Use only fresh detergent. V ented dr y heat is too harsh on some dishware. Y ou may need to us ...
-
Haier HDT18PA - page 21
Drain hose may be removed from the back of the back of the unit. Check if the drain hose is removed.If may have come loose and need tk be tightened. Check the lecel of the drain hose.The drain hose should be positioned above the drain in order to drain properly. If the frain hose is bent or shrunken,it may affect water fraining. It water can not be ...
-
Haier HDT18PA - page 22
21 Scissors Phillips Screwdriver Standard Screwdriver Pliers Wrench T ape Measure Gloves Level Unpacking Your Dishwasher Tools and Materials Required Remove all packing materials including all adhesive tape holding the accessories inside and outside. Inspect and remove any remains of packing, tape or printed materials before using the dishwasher. I ...
-
Haier HDT18PA - page 23
Read install instructions carefully before installation . Caution: If , af ter completing these steps, you are unsure that unit is properly installed, contact a qualified installer . T o ensure that your appliance is properly in stalled it is recommended that it be installed by a cer tified installer . Installing Your Dishwasher: In order for this ...
-
Haier HDT18PA - page 24
23 Y our dishwasher is equipped with a gravity drain system. The drain hose should be positioned above the drain in order to drain properly. If the drain hose is bent or shrunken , it may affect water draining. If water can not be drained out smoothly, the dishwasher operation will be disturbedand it may stop in the middle of the cycle. Grounding I ...
-
Haier HDT18PA - page 25
Carry-In Service For 12 months from the date of original retail purchase, Haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. Full ONE Year Warranty: Limited W arranty NOTE: This warranty commences on the date the item was purchased and the original purchase receipt must be pr ...
-
Haier HDT18PA - page 26
IMPORTANT Do not Return This product To The Store If you have a problem with this product, please contact the “Haier Customer Satisfaction Center” At 1-877-337-3639. DATED PROOF OF PURCHASE REQUIRED FOR WARRANTY SERVICE 115V, 60Hz Made in China Haier America Trading, L.L.C. New York, NY 10018 Printed in China HDT18PA part #WD-9999-10 Issued: Ju ...
Haben Sie eine Frage bezüglich Haier HDT18PA?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Haier HDT18PA nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Haier HDT18PA hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.