Bedienungsanleitung Chauvet SCAN LED 300

20 Seiten 1.62 mb
Download

Zur Seite of 20

Summary
  • Chauvet SCAN LED 300 - page 1

    User Manual ...

  • Chauvet SCAN LED 300 - page 2

    CHAUVET®, 2010, All Rights Reserved Information and specifications in this User Manual are s ubject to change without notice. CHAUVET® assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. Author: Anthony Chiappone Revision: 01 Release Date: 10-08-2 010 T ABLE OF C ONTENTS 1. BEFORE YOU BEGIN ...... ...

  • Chauvet SCAN LED 300 - page 3

    1. Before You Begin 3 10/25/2010 10:23 AM 1. B EFORE Y OU B EGIN What is included • 1 x Intimidator™ Scan LED 300 • 1 x Mounting bracket kit • 1 x Power Cord • 1 x Warranty Card • 1 x User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are pres ...

  • Chauvet SCAN LED 300 - page 4

    1. Before You Begin 4 10/25/2010 10:23 AM Safety Instructions • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. • Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher t han ...

  • Chauvet SCAN LED 300 - page 5

    2. Introduction 5 10/25/2010 10:23 AM 2. I NTRODUCTION Product Dimensions ...

  • Chauvet SCAN LED 300 - page 6

    2. Introduction 6 10/25/2010 10:23 AM Product Overview Bracket Adjustment Knob DMX In DMX Out Power Out Fuseholde r Power In Voltage Selection Switch (115/230 V AC) Safety ...

  • Chauvet SCAN LED 300 - page 7

    3. Setup 7 10/25/2010 10:23 AM 3. S ETUP AC Power This fixture is switchable and runs on either 115 VAC, 60 Hz or 230 VAC, 50 Hz power. Before powering on the unit, make sure the line voltage to which you are connecting it matches the current setting on the voltage selection switch. To determine the power requirements for a pa rticul ar fixture, se ...

  • Chauvet SCAN LED 300 - page 8

    3. Setup 8 10/25/2010 10:23 AM Mounting Orientation The Intimidator™ Scan LED 300 may be mounted in any position provided there is adequate room for ventilation. Rigging Be sure that the structure can support the wei ght of the fixture. Pl ease see the “Technical Specifications” section of this m anual for a detailed weight listing. Mount the ...

  • Chauvet SCAN LED 300 - page 9

    4. Operating Instructions 9 10/25/2010 10:23 AM 4. O PERATING I NSTRUCTIONS Using the Control Panel Access control panel functions using the four butto ns located directly underneath the LED display on the included wired remote. B UTTON F UNCTION <MODE ESC> Used to scroll through the current operating mode, as well as back out of the current ...

  • Chauvet SCAN LED 300 - page 10

    4. Operating Instructions 10 10/25/2010 10:23 AM Operation DMX Operation This is the operating mode which will allow for c ontrol with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this ...

  • Chauvet SCAN LED 300 - page 11

    4. Operating Instructions 11 10/25/2010 10:23 AM Sound-Active This fixture has a preprogramme d, sound triggere d chase. Access this via the control panel on the front of th e fixture. Adjust the microphone s ensitivity from the control panel. Please see the char t below for further explanation. 1. Press <MODE/ESC> until one of the standalone ...

  • Chauvet SCAN LED 300 - page 12

    4. Operating Instructions 12 10/25/2010 10:23 AM DMX Channel Values 11-CH Mode C HANNEL V ALU E F UNCTION C HANNEL V ALUE F UNCTION 1 000 Ù 255 Pan 0°~180° 7 000 Ù 015 016 Ù 127 128 Ù 239 240 Ù 255 Gobo Rotation Stop Rotate Coun ter-clockwise (sl ow Ù fast) Rotate Clockw ise (slow Ù fast) Gobo bounce 2 000 Ù 255 Tilt 0°~90° 3 000 Ù 006 ...

  • Chauvet SCAN LED 300 - page 13

    4. Operating Instructions 13 10/25/2010 10:23 AM 7-CH Mode C HANNEL V ALU E F UNCTION C HANNEL V ALUE F UNCTION 1 000 Ù 255 Pan 0°~180° 6 000 Ù 015 016 Ù 127 128 Ù 239 240 Ù 255 Gobo Rotation Stop Rotate Coun ter-clockwise (sl ow Ù fast) Rotate Clockw ise (slow Ù fast) Gobo bounce 2 000 Ù 255 Tilt 0°~90° 3 000 Ù 006 007 Ù 013 014 Ù 0 ...

  • Chauvet SCAN LED 300 - page 14

    5. Appendix 14 10/25/2010 10:23 AM 5. A PPENDIX General Troubleshooting S YMPTOM P OSSIBLE C AUS E ( S ) P OSSIBLE A CTION ( S ) Breaker/Fuse keeps blowing • Excessive circuit load • Check total load placed on the electrical circuit. • Short circuit along the power wires • Check for a short in the electrical wiring (internal and/or external ...

  • Chauvet SCAN LED 300 - page 15

    5. Appendix 15 10/25/2010 10:23 AM DMX Primer There are 512 channels in a DMX connection. A fixt ure capable of receiving DMX will require one or a number of sequential channels. The user must assign a starting address on the fi xture that indicates the first channel reserved in the cont roller. There are many different types of DMX controllable fi ...

  • Chauvet SCAN LED 300 - page 16

    5. Appendix 16 10/25/2010 10:23 AM Cable Connectors Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Do not allow contact be twe en the common and the fixture’s ch assis ground. Grounding the common can caus e a ground loop, and y our fixture may perform erra tically. Test cables with an ohm meter to ...

  • Chauvet SCAN LED 300 - page 17

    5. Appendix 17 10/25/2010 10:23 AM 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX output connector, you will ne ed to use a 5-pin t o 3-pin adapter. The char t bel ow details a proper cable c onversion: 3-P IN TO 5-P IN C ONVERSION C HAR T Conductor 3-Pin Female (Output) 5-Pin Male (Input) Ground/Shield Pin 1 Pin 1 Data ( ...

  • Chauvet SCAN LED 300 - page 18

    5. Appendix 18 10/25/2010 10:23 AM General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output perform ance and can cause ...

  • Chauvet SCAN LED 300 - page 19

    T ECHNICAL S PECIFICATIONS WEIGHT & DIMENSIONS Length .............................................................................................................. 11 in (27 9 mm) Width ................................................................................................................ 10 in (2 54 mm) Height ....................... ...

  • Chauvet SCAN LED 300 - page 20

    C ONTACT U S World Wi de General Information CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 fax: 954.929.5560 toll free: 800.762.1084 Technical Support CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 (Press 4) fax: 954.929.5560 ( Attention: Service) World Wide Web www.chauvetlighting.com ...

Produzent Chauvet Kategorie Home Safety Product

Dokumente, die wir vom Produzenten des Geräts Chauvet SCAN LED 300 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Chauvet
- Bedienungsanleitungen SCAN LED 300
- Produktkarten Chauvet
- Informationsbroschüren
- oder Energieetiketten Chauvet SCAN LED 300
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Chauvet SCAN LED 300.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Chauvet SCAN LED 300, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Chauvet SCAN LED 300. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Chauvet SCAN LED 300 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Chauvet SCAN LED 300, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Chauvet SCAN LED 300 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Chauvet SCAN LED 300 verständlich ist.

Eine gänzliche Bedienungsanleitung von Chauvet sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Chauvet SCAN LED 300 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Chauvet SCAN LED 300 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Chauvet SCAN LED 300, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Chauvet SCAN LED 300 - die uns die ersten Schritte während der Nutzung von Chauvet SCAN LED 300 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Chauvet SCAN LED 300 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Chauvet SCAN LED 300 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Chauvet SCAN LED 300?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Chauvet SCAN LED 300 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Chauvet SCAN LED 300 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)