Bedienungsanleitung CrimeStopper EZ-10

12 Seiten 3.55 mb
Download

Zur Seite of 12

Summary
  • CrimeStopper EZ-10 - page 1

    EZ-30 / EZ-10 REMOTE ENGINE STARTING SYSTEM OPERATING INSTRUCTIONS INTRODUCTION **IMPORTANT NOTES:- FOR EZ-10 MODEL ONLY** The EZ-10 Model is for remote starting purposes only. It has NO keyless entry functions. Any information in this manual pertaining to remote keyless entry functions, door lock & door unlock applies only to the EZ-30 model. ...

  • CrimeStopper EZ-10 - page 2

    TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………………………2 Remote Control Diagrams………...……………………………………………………………………………...…….3 Remote Engine Control…………….…..………………? ...

  • CrimeStopper EZ-10 - page 3

    REMOTE CONTROL DIAGRAMS #1 #2 #3 LOCK ENGINE UNLOCK VEHICLE #2 FLA SHLIGHT ST A RT/ST OP EZ-30 Engine St a r t / St o p Flashlight Ve h i c l e #2 EZ-10 System EZ-30 SYSTEM The transmitter supplied with the EZ-30 system has 5 butt ons total. The button configuration of the EZ-30 is Factory-set and unchangeable. See Page 11 for additional informatio ...

  • CrimeStopper EZ-10 - page 4

    REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1 second. 2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on. 3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking. 4) Engine Starts and Runs. Parking ...

  • CrimeStopper EZ-10 - page 5

    REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system (EZ-30) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park. 4) Remote starter wi ...

  • CrimeStopper EZ-10 - page 6

    REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses . This mode will allow the vehicle to be left running and unattended without the ignition key in the switch preventing the ...

  • CrimeStopper EZ-10 - page 7

    TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the EZEE Start syst em to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely. This is handy for turbo cool-down without the need for expensive turbo ti mers. This mode requires the use o ...

  • CrimeStopper EZ-10 - page 8

    CONVENIENCE AND SAFETY FEATURES EZ-30 ONLY: KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to install. Press the Lock or Unlock transmitter ...

  • CrimeStopper EZ-10 - page 9

    CONVENIENCE AND SAFETY FEATURES BRAKE PEDAL RESET Prevents starting or shuts off a remote started vehicle w hen this circuit is active or activated. Prevents unauthorized tampering. This circuit s huts the system down immediately when brake pedal is pressed if the key is not in ignition and turned to the ON position. OEM ALARM INTERFACE This featur ...

  • CrimeStopper EZ-10 - page 10

    TRANSMITTER PROGRAMMING TRANSMITTER PROGRAM DIAGRAM: IGN OFF WAIT F O R 4 FLA SHE S PRESS 4 X's FLA SH 2, 3, or 4 X's (GRA Y WIRE GR OUNDED) EZ-30 IGN OFF PRESS PRESS LOCK BUTT ON EZ-10 COMPLETE ST A RT BUTT ON 10 ...

  • CrimeStopper EZ-10 - page 11

    2-VEHICLE OPERATION The EZ-30/10 systems can be used for 2 vehicle operation. A single remote can control a second vehicle with an identical system installed. There are some exceptions. See “Multi-Vehicle Notes” section below. VEHICLE #2 Press low er side button first, then you hav e 4 seconds to control v ehicle #2. Pressing the lower side but ...

  • CrimeStopper EZ-10 - page 12

    TROUBLESHOOTING: “BEFORE YOU CALL” SECTION UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START: The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Gray wire grounded). This is a safety feature of the unit. Check installation for faults and make sure hood is closed and latched and brake wire is not active. UNIT C ...

Produzent CrimeStopper Kategorie Automobile Alarm

Dokumente, die wir vom Produzenten des Geräts CrimeStopper EZ-10 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen CrimeStopper
- Bedienungsanleitungen EZ-10
- Produktkarten CrimeStopper
- Informationsbroschüren
- oder Energieetiketten CrimeStopper EZ-10
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung CrimeStopper EZ-10.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen CrimeStopper EZ-10, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen CrimeStopper EZ-10. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts CrimeStopper EZ-10 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts CrimeStopper EZ-10, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von CrimeStopper EZ-10 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von CrimeStopper EZ-10 verständlich ist.

Eine gänzliche Bedienungsanleitung von CrimeStopper sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von CrimeStopper EZ-10 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von CrimeStopper EZ-10 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich CrimeStopper EZ-10, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts CrimeStopper EZ-10 - die uns die ersten Schritte während der Nutzung von CrimeStopper EZ-10 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit CrimeStopper EZ-10 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von CrimeStopper EZ-10 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich CrimeStopper EZ-10?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit CrimeStopper EZ-10 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit CrimeStopper EZ-10 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)