Bedienungsanleitung Chauvet DMX-690

23 Seiten 0.38 mb
Download

Zur Seite of 23

Summary
  • Chauvet DMX-690 - page 1

    Snapshot Ok on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle DMX-690 Intimidator S pot 2.0 HTI™ USER MANUAL Chauvet, 3000 N 2 9 th Ct, Hollywood, FL 3 3020 U.S.A. (800) 762-1084 – (954 ) 929-1115 FAX (954) 929-5560 www.chauvetlightin g.com ...

  • Chauvet DMX-690 - page 2

    T ABLE OF C ONTENTS 1. BEFORE YOU BEGIN ....................................................................................................................................................... 3 W HAT IS INCLUDED .......................................................................................................................................... ...

  • Chauvet DMX-690 - page 3

    1. B EFORE Y OU B EGIN What is included ¾ 1 x Intimidator Spot 2.0 HTI™ ¾ 150W HTI Lamp ¾ Power Cord ¾ W arranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Noti fy the shipper im ...

  • Chauvet DMX-690 - page 4

    Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product. • Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that the y also receive this instruction booklet. • Always make sure that you are c ...

  • Chauvet DMX-690 - page 5

    2. I NTRODUCTION Features • 6 to 8-channel DMX-512 moving yoke • Pan: 540° / tilt: 270° • Variable strobe/shutter • Color wheel: 7 colors + white Rainbow color spin effect • Rotating gobo wheel: 7 interchangeable, rotating gobos + open 5 metal, 2 dichroic gobos Gobo wheel spin effect • Variable motorized dimmer (0 – 100%) Additional ...

  • Chauvet DMX-690 - page 6

    Product Overview Control Panel DMX Output Connector Yoke Rear of Base AC Power Input & F use H o l der Easy Controller Connector DMX Input Connector Base Head Focusing Lens Voltage Selector Sw itch Intimidator Spot 2.0 HTI Manual 6 2007-01-24/09 :36 ...

  • Chauvet DMX-690 - page 7

    3. S ETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. A 150W HTI lamp is included. Warning! When replacing th e lamp, please wait 15 minutes after p owering down to allow th e unit to cool down! Always disconnect from main power prior to lamp replacement. Do not touch the envelope (glass area) of the bul b wi ...

  • Chauvet DMX-690 - page 8

    Lamp Alignment How- To Often, after a new installation of a lamp, you will fi nd that there is an uneven fiel d of light or what is refered to as a hot spot. This is due to the most intense point of the lamp source not being positioned optimally within the reflector. Lamp alignment screw s There are three lamp alignment screws provided at the base ...

  • Chauvet DMX-690 - page 9

    Replacing Gobos 1) Remove the four screws indicated in figure A to remove the back of the head. Figure A Figure B Figure C Figure D 2) Remove the four screws indicated in figure B to remove the front of the head. 3) Orient the fixture so that it looks like the fixture in figure C. 4) Remove the glue from the gobo (figure D ) using tweezers. 5) Remo ...

  • Chauvet DMX-690 - page 10

    Fixture Linki ng You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run synchronized shows on two or more fixt ures set to a master/slave operating mode. The combined number of channels required by all the fixt ures on a serial data link determines the number of fixtures the data link can su ...

  • Chauvet DMX-690 - page 11

    3-PIN TO 5-PIN CON VERSION CHART th a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin adapter. CHAUVET Model No: DMX5M , or DMX5F. 3 P IN TO 5 P IN C duc 3 Pin Female (output) 5 Pin Male (Input) Note! If you use a controller wi The chart below details a proper cable conversion: ONVERSION C HART Con tor Ground/Shield Pin 1 Pin 1 Da ...

  • Chauvet DMX-690 - page 12

    Mounting ORIENTATION This fixture may be mounted in any position pr ovided there is adequate room for ventilation. RIGGING Hanging Clamp It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After ...

  • Chauvet DMX-690 - page 13

    4. O PERATING I NSTRUCTIONS Navigating the Control Panel Access control panel functions using the four pa nel buttons located directly underneath the LCD Display. NOTE: The display will turn off after 30 seconds if no buttons are pushed. MODE /ESC Button Function <MODE/ESC> Used to access the menu or to scroll through to p-level menu items. & ...

  • Chauvet DMX-690 - page 14

    Menu Map Intimidator Spot 2.0 HTI Manual 14 2007-01-24/09 :36 ...

  • Chauvet DMX-690 - page 15

    Menu Functions User Configurations M ENU O PTION D ESCRIPTION DMX: The fixture will be controlled by a DMX signal coming from a DMX controller. The starting ad dress must be selected, and can be set using the up and down buttons. Automatic – Master Unit: Sets t he fixture to Master status for Master-Slave operation and the built in programs will ...

  • Chauvet DMX-690 - page 16

    TO CHANGE THE PAN RANGE : 1) Press <MODE/ESC> until , , or is displayed.. 2) Use the <UP> and <DOWN> buttons to scroll through the thre e opti ons. is 540°; is 360°; is 180° Note: These settings onl y apply if the fixture is in master/slave or stand-al one modes. These setti ngs will not affec t a fixture operating in DMX mod e ...

  • Chauvet DMX-690 - page 17

    Operation Stand-Alone Mode ( Sound-Active, Auto Mode, E asy Controller): This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto Mode. 1) Press <MO DE/ESC> until , , , or is displayed. 2) Use the <UP> and <DOWN> buttons to scroll through until the desired mode is displa yed and press th ...

  • Chauvet DMX-690 - page 18

    DMX Mode This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with DMX, please read the DMX Primer on page 21. 1) Press <MODE/ESC> until is displayed. 2) Use the <UP> and <DOWN> buttons to select the desired address a nd press the <ENTER> button. DMX Channel Values (16-bit mode) C ...

  • Chauvet DMX-690 - page 19

    DMX Channel Values (8-bit mode) C HANNEL V ALU E F UNCTION 1 000 Ù 255 Pan 0 – 540 (1 28 = halfway point) 2 000 Ù 255 Tilt 0 – 270 (1 28 = halfway point) 3 000 Ù 108 109 Ù 133 134 Ù 249 250 Ù 255 Shutter and Dimmer Closed Closed > Open Open Strobe (Fast > Slow) Open 4 000 Ù 015 016 Ù 031 032 Ù 047 048 Ù 063 064 Ù 079 080 Ù 095 ...

  • Chauvet DMX-690 - page 20

    General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers & Chaser Auto shut off Check f an thermal switch reset 9 Beam is very dim or not bright Clean optical system or replace lamp Check 220/110v switch for proper setting 9 Breaker/Fuse keeps blowing Check total load placed on device 9 Chase is too s ...

  • Chauvet DMX-690 - page 21

    Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A. ) Support (Email): tech@chauvetlighting.com Telephone: (954) 929-1115 - (Pre ss 4) Fax: (954) 929-5560 - (Att ention: Service) Website: http://www.chauvetlighting.com 5. A PPENDIX DMX Primer There are 512 channels in a DMX-512 connection. Channels may be assigned i ...

  • Chauvet DMX-690 - page 22

    Returns Proced ure Returned merchandise must be sent prepaid and in t he original packing, call tags will not be issued. Package must be clearly labeled with a Return Merc handise Author ization Number (RA #). Products returned without an RA # will be refused. Call CHAUVET and reque st RA # prior to shipping the fixture. Be prepared to provide the ...

  • Chauvet DMX-690 - page 23

    Technical Specifica tions WEIGHT & DIMENSIONS Length......................................................................................................................... ..... 16 in (406 mm) Width .......................................................................................................................... ..... 10 in (254 mm) H ...

Produzent Chauvet Kategorie Security Camera

Dokumente, die wir vom Produzenten des Geräts Chauvet DMX-690 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Chauvet
- Bedienungsanleitungen DMX-690
- Produktkarten Chauvet
- Informationsbroschüren
- oder Energieetiketten Chauvet DMX-690
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Chauvet DMX-690.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Chauvet DMX-690, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Chauvet DMX-690. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Chauvet DMX-690 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Chauvet DMX-690, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Chauvet DMX-690 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Chauvet DMX-690 verständlich ist.

Eine gänzliche Bedienungsanleitung von Chauvet sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Chauvet DMX-690 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Chauvet DMX-690 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Chauvet DMX-690, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Chauvet DMX-690 - die uns die ersten Schritte während der Nutzung von Chauvet DMX-690 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Chauvet DMX-690 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Chauvet DMX-690 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Chauvet DMX-690?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Chauvet DMX-690 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Chauvet DMX-690 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)