-
Roland TDA-700 - page 1
OWNER’S MANUAL Thank you, and congratulations on your choice of the Roland TDA-700 V-Drums amplifier. Before using this unit, carefully read the sections entitled: “IMPORTANT SAFETY INSTRUCTIONS” (page 2), “USING THE UNIT SAFELY” (page 3–5), and “IMPORTANT NOTES” (page 6). These sections provide important information concerning the ...
-
Roland TDA-700 - page 2
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral ...
-
Roland TDA-700 - page 3
3 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual. .......................................................................................................... 002a • Do not open or perform any internal modifica- tions on the unit. ............................................. ...
-
Roland TDA-700 - page 4
4 015 • Do not force the unit ’ s power-supply cord to share an outlet with an unreasonable number of other devices. Be especially careful when using extension cords — the total power used by all devices you have connected to the extension cord ’ s outlet must never exceed the power rating (watts/amperes) for the extension cord. Excessive l ...
-
Roland TDA-700 - page 5
5 • To avoid injury, avoid placing hands at points indicated by the arrows in the following figure. fig.01 • Wrap the AC cord around the cord hook when trans- porting or storing the unit. fig.02 • In order to obtain optimum performance from this equipment, avoid allowing the areas indicated by the arrows in the figure below to become obstruct ...
-
Roland TDA-700 - page 6
6 IMPORTANT NOTES 291b In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2 and 5, please read and observe the following: Power Supply 301 • Do not use this unit on the same power circuit with any device that will generate line noise (such as an electric motor or variable lighting sy ...
-
Roland TDA-700 - page 7
7 Introduction Main Features FFP Technology This amplifier relies on Roland ’ s own innovative FFP technology. By digitally processing the input signal, it provides response that is geared perfectly toward amplification of the V-drums sound. At the same time, it achieves sonic pressure that surpasses the size and wattage of the cabinet. Bi-amp Sy ...
-
Roland TDA-700 - page 8
8 Panel Descriptions Front Panel fig.20 CHANNEL CONTROL ............. * When using in “Stereo Link” (p. 14) configuration, the controls explained here work only on the main unit. ● CH 1/V-DRUMS 1. VOLUME Knob Sets the volume for CH1. Rotating the knob clockwise increases the volume. 2. V-DRUMS SHAPE Switch Setting this switch to ON lets you a ...
-
Roland TDA-700 - page 9
9 Panel Descriptions MASTER CONTROL ................ 6. EQUALIZER The TDA-700 comes with a three-band equalizer. BASS Knob This adjusts the tone of the bass range. MIDDLE Knob This adjusts the tone of the middle range. TREBLE Knob This adjusts the tone of the treble range. 7. MASTER MASTER VOLUME Knob This adjusts the total volume level of the unit ...
-
Roland TDA-700 - page 10
10 Panel Descriptions Rear Panel fig.21 CHANNEL INPUT ................... 10 . V-DRUMS IN Jack This is an input that accepts a stereo signal from the V- Drums module through a single jack. Connection is made simple using just one stereo phone cable to the module ’ s headphone output. 11 . Input Jacks These jacks are for connecting a V-Drums sound ...
-
Roland TDA-700 - page 11
11 Connect your TDA-700 Refer to the following diagram and connect the TDA-700 to the external equipment you are using. fig.30-1 * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. * The pin assignment for the XLR type connectors is as ...
-
Roland TDA-700 - page 12
12 Connect your TDA-700 Volume settings when using V-Drums sound module For best possible sound quality, set the volume of the V-Drums sound module and TDA-700 as follows. 1. When PHONES on the V-Drums sound generator is connected to the TDA-700 ’ s V-DRUMS IN , set the V- Drums generator ’ s PHONES VOLUME to the center position. When the V-Dru ...
-
Roland TDA-700 - page 13
13 Connect your TDA-700 Adjust the direction of TDA-700 to suit the environment in which you are using it. ● When using TDA-700 as a personal monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . Try several positions and angles until you find the most comfortable setup. ● When using TDA-700 as a monitor for the whole band . . . . . . . ...
-
Roland TDA-700 - page 14
14 Connect your TDA-700 Stereo Link Stereo playback is enabled simply by connecting two TDA-700 units with a single audio cable (phone type). This function is called “ Stereo Link. ” As the channel control section is designed to accept stereo signals, connection of sound sources is needed only at the main unit, thus enabling channel volumes to ...
-
Roland TDA-700 - page 15
15 Connect your TDA-700 The following shows the placement of V-Drums KIT and the TDA-700 in a Stereo Link configuration. ● When using TDA-700 as a personal monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . Place the main unit to your right. Try several positions and angles until you find the most comfortable setup. ● When using TDA- ...
-
Roland TDA-700 - page 16
16 Proper Use of the Casters Attaching and Removing the Casters You can attach or remove the casters as shown in the following figure. Be sure to remove all the casters when accidental movement may be dangerous, such as when setting up the TDA-700 on stage, or when transporting it in a vehicle. This is a heavy piece of equipment. To prevent injury ...
-
Roland TDA-700 - page 17
17 Appendices Block Diagram fig.50 POWER AMP POWER AMP TWEETER WOOFER V-DRUMS SHAPE BASS MIDDLE TREBLE EQUALIZER MIXER CH1 / V-DRUMS CH 2 LINK IN PHONES LINE OUT LINK OUT CH 3 FFP HF LF MASTER VR PHONES SPEAKER LINE OUT OUTPUT SEL OUTPUT SEL CH 1 VR CH 2 VR CH 3 VR DSP BOTTOM PUNCH POWER INJECTION ...
-
Roland TDA-700 - page 18
18 Appendices Specifications Rated Power Output 300 W (LF 240 W + HF 60 W) Nominal Input Level (1 kHz) CHANNEL INPUT (CH1 – CH3): -20 dBu STEREO LINK INPUT: +4 dBu Nominal Output Level (1 kHz) LINE OUT: +4 dBu (XLR type, Phone type) STEREO LINK OUTPUT: +4 dBu * 0 dBu = 0.775 Vrms Speakers 38 cm (15 inches) x1 Horn Tweeter x 1 Controls CHANNEL CON ...
-
Roland TDA-700 - page 19
This product complies with the requirements of European Directives EMC 89/336/EEC and LVD 73/23/EEC. For EU Countries For Canada This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil num é rique de la classe B respecte toutes les exigences du R è glement sur le mat é riel b ...
-
Roland TDA-700 - page 20
xxxxxxxx ’ 00-xx-xx-xxx ...
Haben Sie eine Frage bezüglich Roland TDA-700?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Roland TDA-700 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Roland TDA-700 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.