Bedienungsanleitung GSW POWER VENTED GAS FIRED WATER HEATER

18 Seiten 0.58 mb
Download

Zur Seite of 18

Summary
  • GSW POWER VENTED GAS FIRED WATER HEATER - page 1

    “SUPERFLUE” ® POWER VENTED GAS FIRED WATER HEATER INSTALLATION AND OPERATING INSTRUCTIONS Read these instructions thoroughly before starting TABLE OF CONTENTS I) Introduction ..................................................................................................................................... 2 II) Air Requirement .............. ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 2

    - 1 - ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 3

    - 2 - I) Introduction We thank you for choosing a GSW / John Wood Water Heater. Your satisfaction with this product is very important to us. This gas-fired water heater has been developed to produce potable hot water and may also be used in combination with space heating applications. The “Superflue”  series is designed to vent the products ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 4

    - 3 - the aged, or the disabled where water temperatures exceed 125 ° F (52 ° C). Use anti-scald valves in the hot water system to reduce the risk of scalding at points of use such as lavatories, sinks and bathing facilities. Such precautions must be followed when this heater is operated in combination with dishwashing or space heating applicatio ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 5

    - 4 - Locate near a floor drain and in an area where leakage of the tank or water piping will not result in damaging adjacent areas or lower floors of the structure. Where such a location is not available, a suitable drain pan must be installed under this water heater. This pan shall be 1½ “ (40 mm) deep and a diameter that is a minimum of 2&quo ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 6

    - 5 - Air Requirements for Canadian Installations Canadian Codes allow for the use of a single air supply source. Canadian customers and authorities having jurisdiction may use the sizing listed in Table 1. Check Local Codes. When using a single air supply, the duct shall terminate within 1 foot (30 cm) above and within 2 feet (60 cm) horizontally ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 7

    - 7 - III) EXHAUST VENTING IMPORTANT: READ THIS SECTION BEFORE PROCEEDING. The Superflue  series is designed to exhaust the products of combustion to the outdoors using a sealed vent pipe system. Required materials and vent sizing are described in Table 2. Refer to figure 6 to determine the exhaust vent termination position. Plan the layout from ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 8

    - 8 - Ensure that there is no movement of the clamped assembly once it is completed. IV) Water Pipe Connections Water piping and fittings should be installed as shown in Figure 8. 1 . Close main water supply and drain the piping system where water heater is to be connected. 2 . Water heater “inlet” and “outlet” are identified in the top cov ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 9

    - 11 - WARNING Exposure to a higher gas supply pressure may cause damage to the control, resulting in explosion or fire. Consult your local gas supplier and gas authorities. DO NOT PUT INTO SERVICE IF OVER-PRESSURIZATION HAS OCCURRED. Use gas piping of adequate sizing to ensure full gas input. All piping must comply with all local codes. In the abs ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 10

    - 12 - Important: in locations where a sump pump failure, flooding or exposure to water may be present, a ground fault receptacle is recommended. VI) Lighting and Operating Instructions WARNING READ BEFORE PROCEEDING If you do not understand and follow these instructions, a fire or explosion may result. This Superflue  Water Heater is equipped w ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 11

    - 13 - Initial Start Up 1 . With all gas valves closed and the power cord NOT plugged into an electrical outlet, make sure that the water heater is filled with water and that the cold water supply valve is open. 2 . Open the manual shut off valve in the gas supply line and turn the water heater’s gas control switch to the “ON” position. Wait ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 12

    - 14 - is on the rating plate and the label on the side of the gas valve control. Poor flames can also be caused by incorrect gas pressures or burner orifice size, inadequate or contaminated air, a restriction in the venting system, or dirt entering the gas supply. These conditions must be corrected to prevent a possible safety hazard. • For unit ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 13

    - 15 - • Check that you have not just run out of hot water due to heavy demand. If this is a routine problem, it may indicate an under-sized water heater. • Have your gas company check input rate and water heater operation • The E.C.O. may have tripped open (LED indicator on constantly). See E.C.O. below. Energy Cut-off Control (E.C.O.) This ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 14

    - 16 - water should stop instantly. Warning: WATER WILL BE HOT and water flow can be forceful. If the valve does not function properly, it must be replaced. In systems where the relief valve discharges periodically, this may be due to thermal expansion or to a thermostat that is operating at too high a temperature. In a closed water system, an expa ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 15

    - 17 - VIII) COMBINATION POTABLE WATER HEATING AND SPACE HEATING (COMBO HEATING) This section serves as a guide for the installation and use of “Combo” heating systems utilizing a domestic water heater which has been specifically approved for such use. It is written for those knowledgeable in the required trades and professionals involved in th ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 16

    - 18 - 3) Install air bleed valves at the highest points to purge air from the system. ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 17

    - 19 - ...

  • GSW POWER VENTED GAS FIRED WATER HEATER - page 18

    - 20 - ...

Produzent GSW Kategorie Water Heater

Dokumente, die wir vom Produzenten des Geräts GSW POWER VENTED GAS FIRED WATER HEATER erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen GSW
- Bedienungsanleitungen POWER VENTED GAS FIRED WATER HEATER
- Produktkarten GSW
- Informationsbroschüren
- oder Energieetiketten GSW POWER VENTED GAS FIRED WATER HEATER
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung GSW POWER VENTED GAS FIRED WATER HEATER.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen GSW POWER VENTED GAS FIRED WATER HEATER, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen GSW POWER VENTED GAS FIRED WATER HEATER. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts GSW POWER VENTED GAS FIRED WATER HEATER ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts GSW POWER VENTED GAS FIRED WATER HEATER, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von GSW POWER VENTED GAS FIRED WATER HEATER hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von GSW POWER VENTED GAS FIRED WATER HEATER verständlich ist.

Eine gänzliche Bedienungsanleitung von GSW sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von GSW POWER VENTED GAS FIRED WATER HEATER bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von GSW POWER VENTED GAS FIRED WATER HEATER befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich GSW POWER VENTED GAS FIRED WATER HEATER, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts GSW POWER VENTED GAS FIRED WATER HEATER - die uns die ersten Schritte während der Nutzung von GSW POWER VENTED GAS FIRED WATER HEATER erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit GSW POWER VENTED GAS FIRED WATER HEATER hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von GSW POWER VENTED GAS FIRED WATER HEATER im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich GSW POWER VENTED GAS FIRED WATER HEATER?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit GSW POWER VENTED GAS FIRED WATER HEATER nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit GSW POWER VENTED GAS FIRED WATER HEATER hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)