Bedienungsanleitung KitchenAid KD-27A

16 Seiten 0.79 mb
Download

Zur Seite of 16

Summary
  • KitchenAid KD-27A - page 1

    KD-27A SERIES DISHWASHERS INSTALLATION INSTRUCTIONS FORM 4171083 (153138) 3-86 ...

  • KitchenAid KD-27A - page 2

    THIS PAGE INTENTIONALLY LEFT BLANK ...

  • KitchenAid KD-27A - page 3

    BEFORE STARTING: Please read these installation instructions COMPLETELY AND CAREFULLY. They will save you time, work, and help to ensure optimum dishwasher performance. For Replacement Installation - Review these complete instructions to be sure that previous connections are compatible. For New Installations - Plumbing and electrical connections mu ...

  • KitchenAid KD-27A - page 4

    SPECIFICA T/O/ W Electrical Operating Load Maximum Protective Device Size Minimum Circuit Size Water Temperature Water Pressure (Flowing) Cabinet Opening 115 volts 60 hertz 1 phase 13.5 amperes 15 amperes 15 amperes 140°F or lower depending on model (refer to Use & Care Guide) 20 to 120 psi 337/1grr to 35” high 24” wide 23’/2” deep (mi ...

  • KitchenAid KD-27A - page 5

    1 CHOOSING THE LOCA T/ON For easy access to plumbing, it is most convenient to have your dishwasher located near the kitchen sink. Any built-in dishwasher must be fully enclosed on the top, both sides, and the back. Therefore, the cabinet space below your kitchen counter is probably the best location. If the dishwasher is being installed at the end ...

  • KitchenAid KD-27A - page 6

    2 PREPARING THE LOCATION Access holes in the cabinets, floor, or rear wall for the hot water supply line, drain line, and electrical supply must be located within the shaded area in Fig. 3 in order to avoid interference with the dishwasher frame or other components. HOT WATER SUPPLY LINE WARNING: PLUMBING CONNECTIONS MUST COMPLY WITH APPLICABLE SAN ...

  • KitchenAid KD-27A - page 7

    For service convenience, a shut-off valve (not supplied) should be installed in the supply line in a readily accessible location (such as beneath the sink) and a union (not supplied) should be installed in the supply line near the dishwasher fill valve. - CAUTION - To prevent heat damage to the fill valve, ALL solder connections must be made BEFORE ...

  • KitchenAid KD-27A - page 8

    ELECTRICAL SUPPLY WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL CODES. WARNING: DISCONNECT ELECTRICAL POWER SUPPLY. The electrical supply must be a 115 volt, 15 amp, properly grounded, positioned as shown in Fig. 8, and should be installed by a qualified electrician. No other applianc ...

  • KitchenAid KD-27A - page 9

    3 PLACING THE DISHWASHER IN ITS LOCATION The adjustable kickboard and lower panel (Fig. 9) must be removed for access to dishwasher connections. Remove the kickboard (5) by removing the two screws (one with lock washer) that secure it. Remove two screws (1) and pull out the bottom of lower panel to unhook tabs (2) from frame. Remove the lower panel ...

  • KitchenAid KD-27A - page 10

    To maintain dishwasher position and alignment, locate the adjustable brackets at the upper tank corners as shown in Fig. 13 and secure them to the counter top with self drilling flat head wood screws (supplied). CAUTION :Make sure screw heads will not interfere with the top of the door. If these brackets are not compatible with your countertop, the ...

  • KitchenAid KD-27A - page 11

    5 CONNECTING THE DRAIN LINE Remove the red plug from the dishwasher check valve and use a hose clamp (not supplied) to connect the prepared drain line directly to the dishwasher check valve (Fig. 15). Make sure there are no sharp bends or kinks anywhere in the drain line which might restrict water flow. Fig. 15 Fig. 16 6 CONNECTING THE ELECTRlCAL S ...

  • KitchenAid KD-27A - page 12

    7 FlNAL CHECK LIST Open the dishwasher door and remove all cardboard, and literature. DO NOT remove the white plastic plug buttons (Fig. 17) from sides of door or the white plastic bumpers on front corners of the lower rack. DO NCrr remove the two spring retainers (Fig. 18) attached to the tank water heater if dishwasher is so equipped. Fig. 17 Fig ...

  • KitchenAid KD-27A - page 13

    8 FRONT PANEL VARIATIONS Vari-Front Panel Pack - All KitchenAid dishwashers are equipped with reversible front panels. If you wish to change the color of your dishwasher panels, consult your Use and Care Guide for instructions on how to reverse these panels. Custom Panels - If custom wood or decorator front panels are to be used, they should be I/, ...

  • KitchenAid KD-27A - page 14

    9 SEASONAL STORAGE - CAUTION - To protect against possible rupture of the fill valve, water lines leading to the diwasher, as well as water lines in the dishwasher MUST BE PROTECTED AGAINST FREEZING. Such ruptures are not covered by the warranty. For installation where the dishwasher is to be left unused and subjected to freezing temperatures, it m ...

  • KitchenAid KD-27A - page 15

    THIS PAGE INTENTIONALLY LEFT BLANK ...

  • KitchenAid KD-27A - page 16

    KitchenAid Major Appliances FORM 4171083 (153138) 3-86 PRINTED IN U.S.A. ...

Produzent KitchenAid Kategorie Dishwasher

Dokumente, die wir vom Produzenten des Geräts KitchenAid KD-27A erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen KitchenAid
- Bedienungsanleitungen KD-27A
- Produktkarten KitchenAid
- Informationsbroschüren
- oder Energieetiketten KitchenAid KD-27A
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung KitchenAid KD-27A.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen KitchenAid KD-27A, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen KitchenAid KD-27A. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts KitchenAid KD-27A ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts KitchenAid KD-27A, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von KitchenAid KD-27A hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von KitchenAid KD-27A verständlich ist.

Eine gänzliche Bedienungsanleitung von KitchenAid sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von KitchenAid KD-27A bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von KitchenAid KD-27A befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich KitchenAid KD-27A, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts KitchenAid KD-27A - die uns die ersten Schritte während der Nutzung von KitchenAid KD-27A erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit KitchenAid KD-27A hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von KitchenAid KD-27A im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich KitchenAid KD-27A?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit KitchenAid KD-27A nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit KitchenAid KD-27A hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)