Bedienungsanleitung Sears 200.71450

16 Seiten 0.32 mb
Download

Zur Seite of 16

Summary
  • Sears 200.71450 - page 1

    OWNER’S MANUAL Model No. 200.71450 Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. 50/15/2 AMP MANU AL BA TTER Y CHARGER 225/125 AMP ENGINE ST ARTER with BA TTERY TESTER CAUTION: Read and Follow All Safety Rules and Operating Instructions Before Every Use of this Product. ...

  • Sears 200.71450 - page 2

    1 Sch 517 T able Of Contents Warranty .................................................................... 1 Important Safety Instructions .................................. 2 Parts .......................................................................... 3 Before Using Your Battery Charger ........................ 4 Assembling your charger ...... ...

  • Sears 200.71450 - page 3

    2 Sch 517 – SAVE THESE INSTRUCTIONS – w •Read all instructions and cautions printed on the battery charger, battery, and vehicle or equipment using battery. •Use charger only on lead-acid type rechargeable batteries, such as those used in cars, trucks, trac- tors, airplanes, vans, RV’s, trolling motors, etc. This charger is not intended t ...

  • Sears 200.71450 - page 4

    3 Sch 517 Pa r t s This section shows an illustration of your battery charger. Use it to become familiar with where all the parts are located, and what they look like. Wiring diagram Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Part Number 3599000286 3899000391 3899000408 90026001 399900065 2299000614 93026429 0099000063 0099000080 52 ...

  • Sears 200.71450 - page 5

    4 Sch 517 B e fo r e Using Y our B a t ter y C h ar g e r It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground and connect the power cord, and prepare to charge a battery. Assembling your charger It is important to fully assemble your charger before use. Follow these instructions for easy a ...

  • Sears 200.71450 - page 6

    5 Sch 517 3. Tap the other axle cap onto the opposite end of the axle and place the axle assembly onto the bottom of the charger. Place one end of the bracket into slot, then place the axle assembly under each bracket. Fasten the other side of the brackets using the two 10-32 screws provided. To attach the handle: Turn the charger right side up ont ...

  • Sears 200.71450 - page 7

    6 Sch 517 A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly grounded outlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualified electrician. DANGER: Before using an adapter as illustrated, be certain that the center screw of the outlet plate is grounded. The ...

  • Sears 200.71450 - page 8

    7 Sch 517 Preparing your battery to be charged It is important that you read and follow these guidelines while you are preparing to charge your battery. • Make sure that you have a 12 volt or 6 volt lead-acid battery. Set the volt/amp selector switch to match the voltage rating of the battery to be charged. • Clean the battery terminals. Be car ...

  • Sears 200.71450 - page 9

    8 Sch 517 Using Y our Bat ter y Charger To obtain the best results from your battery charger, you must know how to use it properly. This section will tell you how to set the controls, and how you can charge a battery while it is still in the vehicle, or you can remove it and then charge it. Follow the instructions below depending on how you choose ...

  • Sears 200.71450 - page 10

    9 Sch 517 The “START” area of the ammeter indicates a high rate of current being drawn by the battery. For example, when cranking an engine, the needle will be at the far right side of the “START” area since the starter will be drawing up to 225 amps from the charger. VOLTMETER: To obtain an accurate reading of your battery’s voltage befo ...

  • Sears 200.71450 - page 11

    10 Sch 517 Charging your battery Charging your battery in the vehicle: 1. Arrange the power cord and charging cords care- fully in order to avoid damage that could be caused by the hood, door, or moving engine parts. 2. Keep clear of the fan blades, belts, pulleys, and other parts that can cause injury. 3. Check the polarity of the battery posts us ...

  • Sears 200.71450 - page 12

    11 Sch 517 Charging your battery outside the vehicle: 1. Remove battery from vehicle, making sure to dis- connect grounded terminal first with all power turned off to the vehicle. REMEMBER: A marine battery should be removed and charged on shore unless special equipment designed for marine use is available. Hydrogen gas emissions can create an expl ...

  • Sears 200.71450 - page 13

    12 Sch 517 15 AMP NR NR 1½ - 2 2 - 2½ 2½ - 4½ 2½ 3½ 4 4½ 2 AMP 2 - 4 4 - 10 11 - 14 14 - 18 18 - 35 18 27 30 33 Calculating charge time The Chart Method Use the following table to more accurately determine the time it will take to bring a battery to full charge. First, identify where your battery fits into the chart. • Small batteries — ...

  • Sears 200.71450 - page 14

    13 Sch 517 Using the engine start feature Your battery charger can be used to jump start your car if the battery is low. Follow these instructions on how to use the engine start feature. 1. Set the timer knob to the OFF position. Then follow the instructions for how to connect the charger to the battery in the section “Charging your battery while ...

  • Sears 200.71450 - page 15

    14 Sch 517 If the above solutions do not eliminate the problem... call toll-free from anywhere in the U.S.A. 1-800-SEARS-64 (1-800-732-7764) 7 am to 4:30 pm CST Monday through Friday POSSIBLE CAUSE Clamps are not making a good connection. 2 amp charge rate is being used. AC cord and/or extension cord is loose. Poor electrical connection. Battery se ...

  • Sears 200.71450 - page 16

    When requesting service or ordering parts, always provide the following information: • Product T ype • Model Number • Part Number • Part Description OWNER’S MANUAL Model No. 200.71450 For the repair or replacement par ts you need Call 7 am - 7 pm, 7 days a week 1-800-366-P ART (1-800-366-7278) For the location of a Sears Repair Ser vice C ...

Produzent Sears Kategorie Battery Charger

Dokumente, die wir vom Produzenten des Geräts Sears 200.71450 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Sears
- Bedienungsanleitungen 200.71450
- Produktkarten Sears
- Informationsbroschüren
- oder Energieetiketten Sears 200.71450
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Sears 200.71450.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Sears 200.71450, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Sears 200.71450. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Sears 200.71450 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Sears 200.71450, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Sears 200.71450 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Sears 200.71450 verständlich ist.

Eine gänzliche Bedienungsanleitung von Sears sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Sears 200.71450 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Sears 200.71450 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Sears 200.71450, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Sears 200.71450 - die uns die ersten Schritte während der Nutzung von Sears 200.71450 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Sears 200.71450 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Sears 200.71450 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Sears 200.71450?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Sears 200.71450 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Sears 200.71450 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)