Bedienungsanleitung Honda 08A06-3E1-300

18 Seiten 0.26 mb
Download

Zur Seite of 18

Summary
  • Honda 08A06-3E1-300 - page 1

    OPERA TING INSTRUCTIONS 6 DISC IN-DASH CD CHANGER P/N: 08A06-3 E1 -300 ...

  • Honda 08A06-3E1-300 - page 2

    Precautions ................................................................................................................... ................... 3 Proper Care of Y our CDs ....................................................................................................... .......... 5 CD Changer Operation ..................................... ...

  • Honda 08A06-3E1-300 - page 3

    Precautions VOLUME For your driving safety, keep the volume low enough to be aware of road and traffic conditions. LIQUIDS Do not place drinks or water on or near the unit, cas- settes or CDs. If liquids drop on the unit cassettes or CDs, it can cause damage. OUTSIDE CLEANING Use a soft cloth to clean the radio. Do not use kerosene, thin- ner or an ...

  • Honda 08A06-3E1-300 - page 4

    Precautions 4 CAUTIONS DURING PLAYBACK Playing a CD while driving on a very bumpy road may result in skips. This will not scratch the CD or damage the player. The noise level on CDs is much lower than on analog-type records or tapes. Therefore, before playing a CD, turn the volume down all the way then adjust the level by gradually turning the vol- ...

  • Honda 08A06-3E1-300 - page 5

    Pr oper Care of Y our CDs 5 - PROPER HANDLING Handle CDs as shown. Do not drop CDs. Hold CDs so you will not leave fingerprints on the surface. If the surface is scratched, it may cause the pickup to skip signal tracks. Do not put tape, paper, or gummed labels on the CD. Do not write on the CD. - KEEP Y OUR CDS CLEAN Fingerprints, dust or soil on t ...

  • Honda 08A06-3E1-300 - page 6

    Pr oper Care of Y our CDs 6 - NEVER A TTEMPT THE FOLLO WING Do not grip or pull out the CD while it is being pulled back into the player by the automatic reloading mechanism. - CA UTION FOR NEW CDS When a new CD is inserted into the player, the CD may fail to play after initial loading. This is caused by small bumps around the center hole and outsi ...

  • Honda 08A06-3E1-300 - page 7

    CD Changer Operation 7 LOADING THE CD (1 of 2) Disc status LED Disc Number Buttons CD Loading Slot Flashes green Flashes green and orange 1 EXPLANA TION OF THE HAND MARKS The CD Changer operates with the same controls used for the audio system. For operation, refer to the audio system section of the Owner’s Manual for your radio. Press momentaril ...

  • Honda 08A06-3E1-300 - page 8

    CD Changer Operation 8 LOADING THE CD (con’t) Disc status LED CD Loading Slot 2 Notes: • Repeat steps ¡ and ™ to load CDs in other disc numbers. • The unit may go into CD eject mode when it detects improper CD loading. Wait 2 seconds before inserting the CD for loading. Insert the CD with the label side up. • When loading is complete, LE ...

  • Honda 08A06-3E1-300 - page 9

    CD Changer Operation 9 SELECTING A CD Disc status LED Disc Number Buttons Flashes orange 1 Press one of the buttons (1–6) to select a desired CD for play. • Green LED indicates CDs are stored and orange LED indicates currently selected CD. • While CDs are being changed, the LED flashes orange until CD changing has been completed, then it ligh ...

  • Honda 08A06-3E1-300 - page 10

    CD Changer Operation 10 EJECTING THE CD (1 of 2) Disc status LED Disc Number Buttons Eject Button Lights green ≠ Flashes orange ≠ Lights orange 1 2 Then press eject button to eject the CD. • The LED flashes green and the CD is ejected. Press one of the buttons (1–6) to select the disc number for the CD you want to eject. ...

  • Honda 08A06-3E1-300 - page 11

    CD Changer Operation 11 EJECTING THE CD (con’t) Disc status LED Eject Button Disc Number Buttons Note: If you do not remove the ejected CD from the CD loading slot within about 15 seconds, it is automatically reloaded. If you press the eject button, or press the ejected CD’s disc number button (the Disc status LED that’s flashing green), the ...

  • Honda 08A06-3E1-300 - page 12

    CD Changer Operation 12 ILLUMINA TION Eject Button 3SEC 1 The illumination turns ON-OFF each time you press and hold the eject button for 3 seconds or longer. This product is equipped with illumination ON-OFF Function. ...

  • Honda 08A06-3E1-300 - page 13

    SHIPPING BRACKET Shipping bracket Caution card A bracket is attached to this unit to protect it from shocks during shipment. Be sure to remove this bracket before installing this unit in your car (before connecting). Be careful not to injure yourself on the edges or other parts of the bracket when removing it. Also, do not reinsert the shipping bra ...

  • Honda 08A06-3E1-300 - page 14

    In Case of Dif ficulty 14 If you encounter a problem, please review the items in the guide. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is proper- ly connected or consult your authorized Honda dealer. INITIAL PO WER UP SYMPTOM CAUSE SOLUTION No Function Functions OK but no sound ...

  • Honda 08A06-3E1-300 - page 15

    In Case of Dif ficulty 15 ERROR MODE E - 0 1 INDICATION CD Changer malfunction. Press the eject button, press one of the disc number buttons (1–6), switch the control unit source OFF once, or switch to another source other than CD and then switch back to CD. If performing any of these operations does not cancel the E-01 indication, consult your H ...

  • Honda 08A06-3E1-300 - page 16

    16 In Case of Dif ficulty SYMPTOMS ■ Skips. ■ Stuck on one track. ■ CD ejects during play. CAUSE Scratches. 1 Fingerprint marks or dust. (Unclean sur- face.) 2 SOLUTION • Handle CD by edge only. • Keep CD clean by using a cleaning kit specifically designed for CDs. • Load CD straight and level, not at an angle, to prevent further scratc ...

  • Honda 08A06-3E1-300 - page 17

    Switching the address setting 17 Disc Number Buttons 1 Notes: • When two or more CD Changers are connected, correct operation is not possible if the same address setting is used for more than one unit. Be sure to set addresses correctly as indicated above. To switch the address setting, turn the ignition switch from OFF to ACC while pressing one ...

  • Honda 08A06-3E1-300 - page 18

    C American Honda Motor Co., Inc. 2002 All Rights Reserved. REF. NO: CDX-MG6077ZH/UC 08A06-3E1-3000-81 < CRB1813-A > US Printed in Japan SPECIFICA TIONS General Power source .................. 13.2 V DC (10.8 – 15.2 V allowable) Grounding system ............................................... Negative type Standby current ................... ...

Produzent Honda Kategorie CD Player

Dokumente, die wir vom Produzenten des Geräts Honda 08A06-3E1-300 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Honda
- Bedienungsanleitungen 08A06-3E1-300
- Produktkarten Honda
- Informationsbroschüren
- oder Energieetiketten Honda 08A06-3E1-300
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Honda 08A06-3E1-300.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Honda 08A06-3E1-300, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Honda 08A06-3E1-300. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Honda 08A06-3E1-300 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Honda 08A06-3E1-300, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Honda 08A06-3E1-300 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Honda 08A06-3E1-300 verständlich ist.

Eine gänzliche Bedienungsanleitung von Honda sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Honda 08A06-3E1-300 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Honda 08A06-3E1-300 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Honda 08A06-3E1-300, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Honda 08A06-3E1-300 - die uns die ersten Schritte während der Nutzung von Honda 08A06-3E1-300 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Honda 08A06-3E1-300 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Honda 08A06-3E1-300 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Honda 08A06-3E1-300?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Honda 08A06-3E1-300 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Honda 08A06-3E1-300 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)