Bedienungsanleitung Cobra 29 LTD SE

21 Seiten 0.73 mb
Download

Zur Seite of 21

Summary
  • Cobra 29 LTD SE - page 1

    H o w t o U s e Y o u r C o b r a 2 9 L T D S E C ontents F eatures ..................................................................................................1 The CB St or y .........................................................................................A1 Industr y Canada Notice FC C Regulations and W arnings Included Accessories ...

  • Cobra 29 LTD SE - page 2

    Installation Installation Location 3 2 Mounting and Connection Mounting and Connection Hold the radio with the mounting bracket in the exact desired location. If there is no interference, remove the bracket and use it as a template to mark the location for the mounting screws. Location Plan location of transceiver and microphone bracket before star ...

  • Cobra 29 LTD SE - page 3

    Installation Installation 5 4 Note Connecting to an accessory fuse prevents the unit from being left on accidentally , and also permits operating the unit without running the engine. Note In positive ground vehicles the red wire goes to the chassis and the black wire is connected to the ignition switch. Note Before installing the CB radio, visually ...

  • Cobra 29 LTD SE - page 4

    Ignition Noise Interference Antennas Use of a mobile receiver at low signal lev els is normally limited by the presence of electrical noise. The primary source of noise in automobiles is from the alternator and ignition system. Typically , when signal level is adequate, the background noise does not present a serious problem. Also, when ex tremely ...

  • Cobra 29 LTD SE - page 5

    The CB/P A button should be in the CB position. Operation 9 Operation T urning On Setting Channel Selector 8 T urning On Make sure the power cord , an tenna and microphone are connected to their proper connectors before starting. Setting Channel Selector 2 EDITION 1 Rota te the O n/Off V olume kn ob cloc kwise to a normal listening level. Select on ...

  • Cobra 29 LTD SE - page 6

    Operation Operation Calibrate For SWR (Standing W ave Ratio) 11 10 Note Antenna Indicator LED will illuminate when TX if SWR is high. Note Calibration must be made in an open area (never in a garage). Vehicle doors must be closed. No one should be standing near the antenna. (See your antenna directions for more complete information). continued Swit ...

  • Cobra 29 LTD SE - page 7

    Operation 13 Operation 12 Note The reading will be slightly higher on Channels 1 and 40 compared to Channel 20. Note When switched to SWR position the meter needle should ideally be as far to the left as possible. Anything over 3 is not acceptable. The antenna indicator will light. A slight antenna height adjustment (higher or lower) may be require ...

  • Cobra 29 LTD SE - page 8

    The S/RF-SWR-CAL switch must be in the S/RF position to read the meter . Operation 15 Operation 14 1 S-Meter S-Meter Swings proportionately to strength of incoming signal when receiving. Switch to NOR to selec t desired channel. 1 Selecting A Channel Selecting A Channel NB-ANL/ANL/ OFF (Noise Blanker / Automatic Noise Limiter) Switch Note The RF no ...

  • Cobra 29 LTD SE - page 9

    Operation Operation 17 16 RF Gain Control Bright/Dim Switch RF Gain Control The RF Gain is used to optimize reception in strong or weak signal areas. Bright/Dim Switch Note The RF Gain is used to optimize reception in weak signal areas. Switch to BRT or DIM to control brightness of the channel indicator and multi-function meter for day or nighttime ...

  • Cobra 29 LTD SE - page 10

    Full clockwise rotation closes the gate allowing only very strong signals to enter . Full c ounterclockwise rotation opens the “ gate” allowing all signals in. T o achieve the Desired Squelch Setting (DSS), turn the Squelch control counterclockwise until you hear noise. Now turn the contr ol clockwise just until the noise stops. This is the DSS ...

  • Cobra 29 LTD SE - page 11

    Setting Dynamike® This controls the microphone sensitivity (outgoing audio level). T o Transmit 21 T o T ransmit T ransmit T alkBack 20 Setting Dynamike® Caution! Be sure the antenna is properly connected to the radio before transmitting. Prolonged transmitting without an antenna, or a poorly matched antenna, could cause damage to the transmitter ...

  • Cobra 29 LTD SE - page 12

    Operation Operation RF Meter 23 22 External Speaker RF Meter This meter swings proportionately to the RF output (outgoing signal) while transmitting. External Speaker The external speaker jack is used for remote receiver monitoring . The S/RF-SWR-CAL switch must be in the S/RF position. 1 Note The external speaker should have 8-ohm impedance and be ...

  • Cobra 29 LTD SE - page 13

    Operation Operation P A (Public Address) 25 24 P A (Public Address) Connect an external P A speak er to the P A jack on the rear panel. Set CB/P A switch to P A position. Push and hold microphone button and speak in a normal voice. Your v oice will now transmit on the P A speaker. Adjust P A speaker volume with the Dynamike® control. Note Speaker ...

  • Cobra 29 LTD SE - page 14

    T emporary Mobile Set-Up 27 Base Station Operation (From 120V AC House Current) T emporary Mobile Set-Up T emporary Mobile Op eration For temporary mobile operation you ma y want to purchase an optional automobile power adapter from your COBRA dealer . This adapter and a magnetic mount antenna allow you to quickly “install” your transceiver for ...

  • Cobra 29 LTD SE - page 15

    How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 29 28 The FCC gives these e xamples of permitted and prohibited messages for channel 9. These are only guidelines and not all-inclusive: Permitted Example Message Y es “Tornado sighted six miles north of town.” No “Post number 10. No tornado sighted.” Y es “Out of gas on I-95 at mile ...

  • Cobra 29 LTD SE - page 16

    How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 31 30 Code Meaning 10-29 Time is up for con tact 10-30 Does not conform to FC C rules 10-33 Emergency traffic 10-34 T rouble at this station 10-35 Confiden tial information 10-36 Corr ect time is 10-37 W recker needed at 10-38 Ambulance needed 10-39 Message delivered 10-41 T urn to channel 10- ...

  • Cobra 29 LTD SE - page 17

    29 L TD SE Specifications Frequency Ranges 33 32 G ENERAL C h a n n e l s ..........................C B -4 0C H Frequency Range . . . . . . . . . . . . . . . . . . CB - 26.965 to 27.405 MHz F requency T olerance . . . . . . . . . . . . . . . 0.005 % Frequency Control . . . . . . . . . . . . . . . . . PLL (phase lock lo op) Synthesizer Operating T e ...

  • Cobra 29 LTD SE - page 18

    Optional Accessories 35 Replacement DC Power Cord For in vehicle use 426-002-N-001 $7.50 Replacement Mounting Bracket For in vehicle use 251-353-9-001 $4.50 Replacement Thumb Screws For in vehicle use 634-081-9-001 $0.60 Replacement Microphone Bracket For in vehicle use 741-080-9-001 $0.45 Limited One Y ear W arranty 34 For Products Purchased in Ca ...

  • Cobra 29 LTD SE - page 19

    36 Optional Accessories cont. 4 Pin Replacement Dynamic Microphone HG M73 $19.95 4 Pin Noise Canceling Microphone HG M77 $30.95 Dynamic External Speaker HG S100 $21.95 Noise Canceling External Speaker HG S300 $28.95 Noise Canceling With T alk Back External Speaker HG S500 $32.95 Power Microphone HG M75 $25.95 Op tio na l Acc es sor ies • Y ou can ...

  • Cobra 29 LTD SE - page 20

    The Citizens Band lies between the shortwave broadcast and 10-meter Amateur radio bands, and was established by law in 1949. The Class D two-way communications service was opened in 1959. (CB also includes a Class A citizens band and Class C remote control frequencies.) Ind ustry C anad a Noti ce: Operation is subject to the following two condition ...

  • Cobra 29 LTD SE - page 21

    426-002 -N-001 Replaceme nt DC Powe r Cord $7.50 251-353 -9-001 Replacemen t Mounting Bra cket $4.50 634-081-9-001 Replacemen t Thumb Screws $0.60 741-080-9-001 Replacemen t Microphone Bracket $0.45 HG A1000 21” Base Loaded, Magnetic Mount Antenna $28.95 HG A1500 38” Base Loaded Magnetic Mount Antenna $39.95 HG M84 4 Pin Premium Noise-Cancellin ...

Produzent Cobra Kategorie Two-Way Radio

Dokumente, die wir vom Produzenten des Geräts Cobra 29 LTD SE erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Cobra
- Bedienungsanleitungen 29 LTD SE
- Produktkarten Cobra
- Informationsbroschüren
- oder Energieetiketten Cobra 29 LTD SE
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Cobra 29 LTD SE.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Cobra 29 LTD SE, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Cobra 29 LTD SE. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Cobra 29 LTD SE ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Cobra 29 LTD SE, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Cobra 29 LTD SE hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Cobra 29 LTD SE verständlich ist.

Eine gänzliche Bedienungsanleitung von Cobra sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Cobra 29 LTD SE bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Cobra 29 LTD SE befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Cobra 29 LTD SE, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Cobra 29 LTD SE - die uns die ersten Schritte während der Nutzung von Cobra 29 LTD SE erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Cobra 29 LTD SE hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Cobra 29 LTD SE im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Cobra 29 LTD SE?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Cobra 29 LTD SE nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Cobra 29 LTD SE hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)