Bedienungsanleitung Metra Electronics Automobile Parts

16 Seiten 1.16 mb
Download

Zur Seite of 16

Summary
  • Metra Electronics Automobile Parts - page 1

    © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION 1-800-221-0932 axxessinterf ace.com INST ALLA TION INSTRUCTIONS FOR PART ASWCST ALK The ASWCST ALK is the newest addition to the Axxess steering wheel control solution, allowing you to add steering wheel control options to your vehicle. Using an aftermarket radio that is equipped with a steering ...

  • Metra Electronics Automobile Parts - page 2

    T OOLS REQUIRED FOR INST ALLA TION •Cutting T ool •T ape •Crimping T ool •Connectors (I.E. butt-connectors, bell caps, ECT…) • Female Spade Connectors IGNITION TERMINALS WIRE CUTTER M3.5 M2.6 M3 M5 M4 ISO 6 2.5 1.5 *Impor tant: Please chec k steering shroud before drilling to mak e sure you hav e enough depth. *After mar k et r adio mus ...

  • Metra Electronics Automobile Parts - page 3

    ASWCST ALK ASSEMBL Y 1. Remove and drill a 3/8 hole in the steering wheel shroud. 2. Select desired length rod and thread a 3/8 hex nut on to the shorter threaded section. 3. Run the four wires from the ASWCST ALK through the rod of choice and screw it into the ASWCST ALK 4. T ake the twist on cover , run the wires through, and twist the cap on to ...

  • Metra Electronics Automobile Parts - page 4

    Wiring Of ASWCST ALK And Interface 1. Connect the BLACK wires of the ASWCST ALK and the BLACK wire of the interface to ground. Y ou may use the same ground point that is used for the radio. 2. Connect the GREEN/ORANGE and BLACK/GREEN wires of the ASWCST ALK to the corresponding wires on the interface. 3. Connect the RED wire to 12 volt accessory 4. ...

  • Metra Electronics Automobile Parts - page 5

    Programming the ASWCST ALK * If this is the rst time the ASWCST ALK is being installed: 1. T urn the ignition on; the led will start ashing rapidly which means the interface is looking for the ASWCST ALK and the radio. Go to step 3. OR * If the ASWCST ALK was installed before: 1. T urn the ignition on, the led will ash slowly 2. Hold down ...

  • Metra Electronics Automobile Parts - page 6

    4. The ASWCST ALK is now congured for the right side. T roubleshooting the Auto Detect Mode So you tried the auto detect feature and at the end the led did not stay on solid red, it started ashing, or the steering wheel controls did not function properly . That means the interface did not detect the ASWCST ALK or the proper radio. Follow thes ...

  • Metra Electronics Automobile Parts - page 7

    • Long ashes represent the wire(s) that are connected to the interface • 3rd led ash is the Green/Orange wire on the interface • 5th led ash is the Black/Green wire on the interface If during the auto detect sequence there was no long led ash, just short ones, the interface was not connected to the correct wire on the ASWCST ALK o ...

  • Metra Electronics Automobile Parts - page 8

    1. V olume up 2. V olume down 3. Seek up 4. Seek down 5. Mode (source) 1. V olume up 2. V olume down 3. Seek up 4. Seek down 5. Mode (source) Remapping the ASWCST ALK Let’s say you have the ASWCST ALK programmed to your radio and you want to change the button assignment for the steering wheel controls. For instance you would like Seek Up to be Mu ...

  • Metra Electronics Automobile Parts - page 9

    NOTES: • The interface must have detected the ASWCST ALK and radio it is attached to before you can remap any buttons. • Y ou can only start the remapping of the steering wheel controls process within the rst 20 seconds of turning the ignition key on. If you wait longer then the 20 seconds you will have to turn the ignition off then back on ...

  • Metra Electronics Automobile Parts - page 10

    5. Source/Mode 6. Mute 7. Preset Up 8. Preset Down 9. Power 10. Band 1 1. Play/Enter 12. PTT (Push T o T alk) 13. On Hook 14. Off Hook 15. Fan Up 16. Fan Down 17. T emp Up 18. T emp Down * Note: Remember not all radios will have all these commands. Please refer to the radios’ owners manual for specic commands recognized by the radio. For insta ...

  • Metra Electronics Automobile Parts - page 11

    After the 18th button is programmed or skipped the led will go out and the remapping is completed. If for any reason after remapping the steering wheel controls you want to go back to the original steering wheel control settings, follow the step in “IF the ASWCST ALK was installed before”. Manually Setting The Radio T ype 1. Within the rst 2 ...

  • Metra Electronics Automobile Parts - page 12

    programmed Kenwood. 5) Here is the chart to show how many presses of the V olume Up button is needed for which radio you are trying to program: 1st led ash is for Eclipse 2nd led ash is for Kenwood 3rd led ash is for Clarion 4th led ash is for Sony and Dual 5th led ash is for JVC 6th led ash is for Pioneer and Jensen 7th led as ...

  • Metra Electronics Automobile Parts - page 13

    NO TES ...

  • Metra Electronics Automobile Parts - page 14

    NO TES ...

  • Metra Electronics Automobile Parts - page 15

    NO TES ...

  • Metra Electronics Automobile Parts - page 16

    REV . 8/22/1 1 1-800-221-0932 axxessinterf ace.com © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION INST ALLA TION INSTRUCTIONS FOR PART ASWCST ALK K NO WLEDGE IS P OW ER E nhance your installation and fabrication skills by enrolling in the most re cognized and re spected mobile electronics school in our industry . Log onto www .installerinsti ...

Produzent Metra Electronics Kategorie Automobile Parts

Dokumente, die wir vom Produzenten des Geräts Metra Electronics Automobile Parts erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Metra Electronics
- Bedienungsanleitungen Automobile Parts
- Produktkarten Metra Electronics
- Informationsbroschüren
- oder Energieetiketten Metra Electronics Automobile Parts
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Metra Electronics Automobile Parts.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Metra Electronics Automobile Parts, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Metra Electronics Automobile Parts. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Metra Electronics Automobile Parts ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Metra Electronics Automobile Parts, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Metra Electronics Automobile Parts hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Metra Electronics Automobile Parts verständlich ist.

Eine gänzliche Bedienungsanleitung von Metra Electronics sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Metra Electronics Automobile Parts bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Metra Electronics Automobile Parts befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Metra Electronics Automobile Parts, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Metra Electronics Automobile Parts - die uns die ersten Schritte während der Nutzung von Metra Electronics Automobile Parts erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Metra Electronics Automobile Parts hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Metra Electronics Automobile Parts im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Metra Electronics Automobile Parts?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Metra Electronics Automobile Parts nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Metra Electronics Automobile Parts hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)