Bedienungsanleitung Char-Broil 5101194

20 Seiten 2.84 mb
Download

Zur Seite of 20

Summary
  • Char-Broil 5101194 - page 1

    04201101 WARNING Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. Combustion by-products produced when using this product contain chemicals known to the State of California ...

  • Char-Broil 5101194 - page 2

    2 Installation Safety Precautions • • National Fuel Gas Code, NFPA 54 / ANSI Z223.1 NFPA/ANSI 58. National Electrical Code, ANSI / NFPA 70. Use appliance only with LP (propane) gas and the regulator/valve assembly supplied. Appliance installation must conform with local codes, or in their absence with . Handling and storage of LP cylinders must ...

  • Char-Broil 5101194 - page 3

    3 T o insure your satisfaction and for follow-up service, register your product online at: www .g rillr e gistr a tion.com Table of Contents Use and Care .................................... 2-10 Safety Symbols ...............................2 Cylinder Cylinder Cylinder Cylinder Cylinder Installation Safety Precautions ...................2 Limited ...

  • Char-Broil 5101194 - page 4

    D ANGER • NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cylinder beyond 80% full. • An over filled or improperly stored cylinder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property damage, serious injury or death. • ...

  • Char-Broil 5101194 - page 5

    • A frosty regulator indicates gas overfill. Immediately close LP cylinder valve and call local LP gas dealer for assistance. • Do not release liquid propane (LP) gas into the atmosphere. This is a hazardous practice. • T o remove gas from LP , contact an LP dealer or call a local fire department for assistance. Check the telephone directory ...

  • Char-Broil 5101194 - page 6

    Hold coupling nut and regulator as shown for proper connection to LP cylinder valve. C Straight 6. An additional one-half to three quarters turn is required to complete connection. Tighten by hand only - do not use tools. NOTE: do not use this Regulator! T urn the coupling nut clockwise to tighten to a full solid stop. The regulator will seal on th ...

  • Char-Broil 5101194 - page 7

    WARNING Ignitor Lighting 1. Open lid during lighting. 2. Press and turn the control knob to the position. 3. T urn knob rapidly . 4. If ignition does not occur in 5 seconds, turn the burner control knob , wait 5 minutes, and repeat lighting procedure. If ignition still does not occur , follow instructions. HI ROTARY IGNITOR OFF “Match Lighting” ...

  • Char-Broil 5101194 - page 8

    SOLUTION: Wait for appliance to cool. Clean burner often. Spiders and insects don’t care if your appliance is brand new or you just cleaned it. Use a hose with a nozzle attached. Forced water will wash out the web. Natural Hazard • Spiders CA UTION FACT: Sometimes spiders and other small insects climb into the burner tube. The spiders spin webs ...

  • Char-Broil 5101194 - page 9

    Job Routine Cleaning Fingerprints and Smears Stubborn Stains and Discoloration Grease and Blood Burnt-on or Baked-on Foods Grease and Oil Cleaning Agents* W arm W ater , Soap, Ammonia, Detergent 3M Stainless Steel Cleaner and Polish, Arcal 20, Lac-O-Nu, Lumin W ash, O’Cedar Cream Polish, Stainless Shine 3M Stainless Steel Cleaner and Polish, All ...

  • Char-Broil 5101194 - page 10

    Problem Burner will not light using ignitor . Burner will not match- light. Sudden drop in gas flow or low flame. Flames blow out. Flashback... (fire in burner tube). Unable to fill LP cylinder Possible Cause — Electrode and burner are wet. — Electrode is cracked or broken, “sparks at crack”. — Wire is loose or disconnected. — Wire is s ...

  • Char-Broil 5101194 - page 11

    ST OP! Missing a part? No need to go back to the store! The store where you made your purchase does not stock parts for this item. If you need parts, whether they are missing or damaged, call the Customer Service toll free Help Line. Call us and we will gladly ship the part you need FREE OF CHAR GE. Call Our Help Line T ools required for assembly: ...

  • Char-Broil 5101194 - page 12

    Parts Diagram A B C C D E F F G H I J K L L M M F N O 12 ...

  • Char-Broil 5101194 - page 13

    Assembly Step 1 Slide tool hooks onto one of the towel bars prior to assembly . Attach each towel bar using two . 1/4-20x3/4” machine screws DO NOT LIFT UNIT USING TOWEL BARS. 1/4-20x3/4” Machine Screw Qty: 4 Wrap/Body 55700670 Towel bar 55700667 Tool hook 1/4-20x3/4” Machine Screw Step 2 Feed burner tube through center hole of heat shield. A ...

  • Char-Broil 5101194 - page 14

    Step 3 Position rotary ignitor as shown below . Attach ignitor behind control panel using two . #8x1/2” self-tap screws #8x1/2” Self-Tap Screw Qty: 2 Rotary ignitor 55700666 #8x1/2” Self-Tap Screw Control panel 55700671 Step 4 Insert valve/hose through front opening and attach to control panel using two Screws may already be installed in valv ...

  • Char-Broil 5101194 - page 15

    Step 5 Align valve with burner tube. Figure A #10- 24x3/8” machine screws #10-24 hex/keps nuts #10x1/2” self-tap screw See for proper valve-to-burner engagement. Secure control panel to body at each end using two and two . Inside body , insert one through body into panel. It is helpful to have someone hold panel in position while attaching hard ...

  • Char-Broil 5101194 - page 16

    Step 8 Step 7 Lift body assembly and place onto base. Back/open-end of body assembly should face back of base. Back of base has locking casters, front has non-locking casters. Attach body assembly to base using nine and nine . #10-24x1/2” machine screws #10-24 hex/keps nuts #10-24x1/2” Machine Screw Qty: 9 #10-24 Hex/Keps Nut Qty: 9 #10-24x1/2? ...

  • Char-Broil 5101194 - page 17

    Cylinder valve must face to rear of cart once cylinder is attached. Failure to install cylinder correctly may allow gas hose to be damaged in operation, resulting in the risk of fire. CA UTION Step 9 Place cover assembly onto top. Align lower hinge holes with holes on back side of top. Secure using two . #8x1/2” self-tap screws #8x1/2” Self-Tap ...

  • Char-Broil 5101194 - page 18

    18 ...

  • Char-Broil 5101194 - page 19

    Please register your product online at: (If you register online, you do not need to send in this registration card.) WWW .GRILLREGISTRA TION.COM 19 ...

  • Char-Broil 5101194 - page 20

    Char-Broil, LLC • Columbus, GA 31902 • Assembly Instructions © 2005 ...

Produzent Char-Broil Kategorie Stove

Dokumente, die wir vom Produzenten des Geräts Char-Broil 5101194 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Char-Broil
- Bedienungsanleitungen 5101194
- Produktkarten Char-Broil
- Informationsbroschüren
- oder Energieetiketten Char-Broil 5101194
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Char-Broil 5101194.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Char-Broil 5101194, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Char-Broil 5101194. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Char-Broil 5101194 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Char-Broil 5101194, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Char-Broil 5101194 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Char-Broil 5101194 verständlich ist.

Eine gänzliche Bedienungsanleitung von Char-Broil sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Char-Broil 5101194 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Char-Broil 5101194 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Char-Broil 5101194, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Char-Broil 5101194 - die uns die ersten Schritte während der Nutzung von Char-Broil 5101194 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Char-Broil 5101194 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Char-Broil 5101194 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Char-Broil 5101194?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Char-Broil 5101194 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Char-Broil 5101194 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)