Bedienungsanleitung Mio STANDARD

12 Seiten 0.16 mb
Download

Zur Seite of 12

Summary
  • Mio STANDARD - page 1

    Aquachlor  Salt Water Chlorinator Owners Manual Model Standard and Self Clean C Series II Manufactured in Australia By Monarch Pool Systems www.monarch poolsystems.com ...

  • Mio STANDARD - page 2

    2 Aquachlor  Salt Chlorinator Thankyou for purchasing a Quality Aquachlor Pool and Spa Product. Please read all information in this Manual carefully before installing or operating your AQUACHLOR  SALT CHLORINATOR. INDEX Page 2 Packing List Page 3 Installation Instructions Page 4 Pre Start Up Procedure Page 4-5 Operation of Aquachlor  Syste ...

  • Mio STANDARD - page 3

    3 INSTALLATION INSTRUCTIONS FOR AQUACHLOR C and SC INSTALLING THE POWER SUPPLY : Select a convenient well-ventilated location within one metre of filter equipment and mount the Power Supply vertically onto a post or wall 1.5 metres above ground level. Australian Standards requires that the Power Supply shall not be located within 3 meters of the po ...

  • Mio STANDARD - page 4

    4 PRE - START UP PROCEDURE : Before operating your Aquachlor  Chlorinator please ensure the following items have been added to your pool: • SALT - Load salt into the pool at a minimum rate of 40kg per 10,000 litres (0.4%). Connect vacuum system and slowly vacuum until salt dispersal is complete. Place vacuum head into deepest end of pool and a ...

  • Mio STANDARD - page 5

    5 BAR METER WARNING LED REASON/ACTION Off Green 1. Start – up delay functioning. 2. System Control set below max. Cell is turned off. (Refer System Control page 7). Off Red 1. Gas detected. Check pump/pipes for damage. 2. Gas sensor not connected to cell 4 or 5 LEDs on Green System operating normally 1 to 5 LEDs on Red 1. Salt level too low. Add ...

  • Mio STANDARD - page 6

    6 If the Cell is OFF and you wish to check its operation, simply turn the System Control to MAX and the Cell will turn ON. Once checked, adjust the System Control back to the desired position and after a few minutes the Cell will turn OFF again. To turn the Cell OFF, simply turn the System Control to MIN. This will be convenient for backwashing. WA ...

  • Mio STANDARD - page 7

    7 Terminal Block the coloured wires from your pool light are connected. The Light Transformer is for use with 12volt pool lights, maximum power is 150Watt. Please Note: Only one light can be connected to each light transformer. If more than one light is required please refer to your Aquachlor  dealer. SAFETY NOTICE IMPORTANT Certain local electr ...

  • Mio STANDARD - page 8

    8 Aquachlor  C Standard Aquachlor  SC Self Clean C Standard Systems Model C Replacement Cell Model to order SC Self Clean Systems Model SC Replacement Cell Model to order 260 260 250 250 390 390 330 330 520 520 SC SYSTEMS Please Note that unless you have extreme water conditions the Cell should not become scaled and you should not have to cle ...

  • Mio STANDARD - page 9

    9 Stabiliser should be added at the rate of 500 grams for every 10,000 litres of water. To add, place the required amount in a stocking and tie a brick to it. Place the stocking in front of the return jet. It will dissolve in 2 – 3 days. Stabiliser should be maintained at a level of 30 – 50 ppm. Before adding more stabiliser, have your pool wat ...

  • Mio STANDARD - page 10

    10 The Aquachlor  unit has a built in warning system to minimise damage resulting from insufficient salt levels, however, the ultimate responsibility is on the owner to ensure adequate salt levels are maintained all year round. 4. RUNNING TIMES: If you run your chlorinator for 24 hours a day, or for long periods, the Cell life will be greatly re ...

  • Mio STANDARD - page 11

    11 Aquachlor Model C (Standard) Aquachlor Model SC (Self Clean) Productio n maximum grams/hou r (100%) Production * grams/hour (65% equivalent) Chlorine produce d over 8 hours grams (100%) Equivalent in dry granulated chlorine grams (65%) Equivalent in liquid chlorine litres (12%) 220 250 16.0 24.6 128 197 1.07 260 20.0 30.8 160 246 1.33 330 25.0 3 ...

  • Mio STANDARD - page 12

    12 IMPORTANT: ALWAYS INSIST ON GENUINE AQUACHLOR REPLACEMENT PARTS. If it is necessary to replace the Electrolytic Cell, beware of “look alikes”. Only the Genuine Aquachlor Cell is designed and warranted to operate with the Aquachlor Power Supply. SERIOUS DAMAGE MAY RESULT TO THE ELECTRONICS INSIDE THE UNIT IF COPY ELECTRODES ARE USED AND WILL ...

Produzent Mio Kategorie Water Dispenser

Dokumente, die wir vom Produzenten des Geräts Mio STANDARD erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Mio
- Bedienungsanleitungen STANDARD
- Produktkarten Mio
- Informationsbroschüren
- oder Energieetiketten Mio STANDARD
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Mio STANDARD.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Mio STANDARD, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Mio STANDARD. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Mio STANDARD ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Mio STANDARD, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Mio STANDARD hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Mio STANDARD verständlich ist.

Eine gänzliche Bedienungsanleitung von Mio sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Mio STANDARD bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Mio STANDARD befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Mio STANDARD, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Mio STANDARD - die uns die ersten Schritte während der Nutzung von Mio STANDARD erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Mio STANDARD hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Mio STANDARD im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Mio STANDARD?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Mio STANDARD nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Mio STANDARD hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)