Bedienungsanleitung S.E.P. BC90(1+1)

20 Seiten 1.75 mb
Download

Zur Seite of 20

Summary
  • S.E.P. BC90(1+1) - page 1

    BC 90 (1 1) + ® USE AND MAINTENANCE MANUAL GB ...

  • S.E.P. BC90(1+1) - page 2

    AS SEMBLING INSTRUCTION FOR MOTOR-MOWER BOX CONTENTS WEIGHT (kg) SICKLE BAR BAR MECHANISM MACHINE CONNECT SICKLE BAR POSITION THE HANDLEBAR TIGHTEN THE 4 SCREEW S1 S3 S2 S1 S2 46,5 ÷ 47 14 ÷ 21,5 9,8 ÷ 12,5 A B C S3 ...

  • S.E.P. BC90(1+1) - page 3

    MOTOR-MOWER BC 90 (1+1) BEFORE USING THE MOTOR -MOWER CAREFULL Y READ THE INSTRUCTIONS GIVEN IN THIS MANUAL ...

  • S.E.P. BC90(1+1) - page 4

    2 TA B L E O F CONTENTS Pa ge INTRODUCTI ON .................................................... 3 SAFETY REGULA TIONS ....................................... 3 GENERAL NOTICES ............................................. 3 STARTING THE ENGINE ...................................... 3 OPERATING OF THE MOTOR-MOWER ............... 4 OPERATING OF A TT ...

  • S.E.P. BC90(1+1) - page 5

    3 INTRODUCTION • This manual provides Use and Maintenance in- structions, technical specifications, and safety pre- cautions for motor -mower: − model BC 90 (1+1) in the versions with gasoline engines. • Fo r t h e s a k e o f cl arity and ease of identification, the different motor -mower models are identified in this manual by means of the ...

  • S.E.P. BC90(1+1) - page 6

    4 STARTING THE ENGINE • Disengage all control levers before starting the mo- tor . Keep your feet clear of the attachments fitted to the machine. • Do not run the engine in a closed ambient where the exhaust gases can collect. They contain car- bon monoxide that is highly toxic. • Do not interfere with safety device (engine shut- off). Do not ...

  • S.E.P. BC90(1+1) - page 7

    5 IDENTIFICA TION DA T A MOTOR-MOWER IDENTIFICATION The serial number is stamped on the engine side of the gear box of your motor -mower (see figure 1, item 1). ENGINE IDENTIFICATION Refer to the engine Operation and Maintenance Man- ual. EC MARKING The motor -mower is marked EC in compliance with the Directive of the European Community Council 89/ ...

  • S.E.P. BC90(1+1) - page 8

    5 IDENTIFICA TION DA T A MOTOR-MOWER IDENTIFICATION The serial number is stamped on the engine side of the gear box of your motor -mower (see figure 1, item 1). ENGINE IDENTIFICATION Refer to the engine Operation and Maintenance Man- ual. EC MARKING The motor -mower is marked EC in compliance with the Directive of the European Community Council 89/ ...

  • S.E.P. BC90(1+1) - page 9

    6 TECHNICAL SPECIFICA TIONS ENGINE The motor -mower may be fitted with the following en- gines: − HONDA GC 160; 4 stroke benzina; 3,7 kW (5 HP); 160 cm 3 . − L OMBARDINI LGA 226; 4 stroke benzina; 4 kW (5,4 HP); 220 cm 3 . STARTING Auto-winder device. CLUTCH Cone type in oil bath with control lever on handle- bars. GEARS One forward gears and o ...

  • S.E.P. BC90(1+1) - page 10

    7 SAFETY DEVICE The machine is fitted with an engine shut-off device to ensure maximum safety in machine operation: − Engine shut-off is an electrical device which stops the engine instantly if the handlebars are released. WAR NI NG Do not interfere with safety device (engine shut-off). Do not use the motor-mower if the safety device is missing o ...

  • S.E.P. BC90(1+1) - page 11

    8 MOTOR-MOWER CONTROLS See fig. 3. 1. Clutch lever . 2. Engine stop lever . 3. Gear lever . 4. PTO control lever . 5. Throttle control lever . 6. PTO instant adaptor . OPERA TING THE CONTROLS Clutch lever (See figure 4) − Lever (1) pulled up: clutch disengaged. − Lever (1) released: clutch engaged. Engine stop lever (See figure 4) − Lever (2) ...

  • S.E.P. BC90(1+1) - page 12

    9 Power Take Off (PTO) control lever The Power T ake Off (PTO) control lever engages the drive to the attachment. To e n g a ge and disengage drive, proceed as follows (see fig. 6): a. T urn throttle control lever to idle position. b. Pull up clutch lever . c. Pull PTO control lever (1) and release it when drive is engaged (see plate in detail A.) ...

  • S.E.P. BC90(1+1) - page 13

    10 OPERA TING THE MOTOR-MOWER STARTING THE ENGINE NOTE See the engine Operating and Maintenance manual for all information regarding the engine. CAUTION Oil bath air filter (if fitted) - When delivered new , there is no oil in the air filter . Before using your mo- tor -mower , add motor oil up to the marked level. a. Disengage all control levers b ...

  • S.E.P. BC90(1+1) - page 14

    11 MOUNTING THE 2 ND WHEEL (UPON REQUEST) To m o unt the 2 nd wheel kit, follow the below steps: a. Insert there spacer (3) into the wheel hexagon (1) and fix it by the safety pin (4). b. Install the second wheel (2) and fix it by its screw (6) and washer (5). − This procedure has to be done on both wheels. MAINTENANCE To e n s u r e c o n t inui ...

  • S.E.P. BC90(1+1) - page 15

    12 Every 300 hours Change the gearbox and transmission oil following the instructions given above in the paragraph cover- ing running in. POWER TAKE OFF Every 8 hours Grease the PTO (see figure 14, item 1). Also grease the PTO every time you fit a new attach- ment. CHECKS AND ADJUSTMENTS CLUTCH LEVER The clutch lever must have a free play of about ...

  • S.E.P. BC90(1+1) - page 16

    13 CUT TER BAR MOWER WAR NI NG • When you transport your machine, and when you finish work, always fit the knife guard over the cut- ter bar . • K eep your hands and feet clear of the cutter bar when in motion. • Do not operate the motor -mower in proximity of children and/or animals. • Stop the engine before cleaning the attachment. • St ...

  • S.E.P. BC90(1+1) - page 17

    14 b. Loosen lock nut (5) and turn wear plate adjuster screw (4) to obtain correct sliding movement of the knife. c. T i gh t e n ag ain the securing nut (5) and the screws (1) and (2). MOWING BAR E.S.M. type S NOTE The mowing bar type E.S.M. type S does not require any special adjustment as it is self-adjusting. Cutting height adjustment Proceed a ...

  • S.E.P. BC90(1+1) - page 18

    15 CUTTER BAR MOWERS MAINTENANCE MECHANICAL CON-ROD DRIVE Lubrication After the first 5 hours of work , and subsequently af- ter every 10 hours , grease the mower mechanism at points (1) and (2) as shown in fig.5. CAM MECHANISM MOVEMENT Lubrication Greasing or lubrication points are not available in this system; it is however suggested to clean the ...

  • S.E.P. BC90(1+1) - page 19

    GB San Martino in Rio, 01.1 1.2001 EC Certificate of Conformity According to ECC 89/392 Directives and successive modifications Declare on their own responsibility , that the machine V ALP ADANA 42018 SAN MAR TINO IN RIO (RE) IT AL Y S.p.A. S.E.P . BC 90 (1+1) A X00000 pr EN 12733 MOTOR-MOWER G30 H301096 H301754* BA00001* Brand: T ype: from machine ...

  • S.E.P. BC90(1+1) - page 20

    Edizione Giugno 2006 COD . 218984 M5 ® V ALP ADANA S.p.A. Società unipersonale appartenente al Gruppo Industriale Argo S.p.A. 42018 S. MARTINO IN RIO (RE) IT AL Y Via Don P asquino Borghi, 6 TEL . 0522 73.17.11 - F AX 0522 73.17.31 E-MAIL: infosep@sep.it - http://www .sep.it ...

Produzent S.E.P. Kategorie Lawn Mower

Dokumente, die wir vom Produzenten des Geräts S.E.P. BC90(1+1) erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen S.E.P.
- Bedienungsanleitungen BC90(1+1)
- Produktkarten S.E.P.
- Informationsbroschüren
- oder Energieetiketten S.E.P. BC90(1+1)
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung S.E.P. BC90(1+1).

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen S.E.P. BC90(1+1), Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen S.E.P. BC90(1+1). Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts S.E.P. BC90(1+1) ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts S.E.P. BC90(1+1), wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von S.E.P. BC90(1+1) hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von S.E.P. BC90(1+1) verständlich ist.

Eine gänzliche Bedienungsanleitung von S.E.P. sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von S.E.P. BC90(1+1) bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von S.E.P. BC90(1+1) befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich S.E.P. BC90(1+1), die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts S.E.P. BC90(1+1) - die uns die ersten Schritte während der Nutzung von S.E.P. BC90(1+1) erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit S.E.P. BC90(1+1) hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von S.E.P. BC90(1+1) im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich S.E.P. BC90(1+1)?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit S.E.P. BC90(1+1) nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit S.E.P. BC90(1+1) hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)