-
John Deere PC20577 - page 1
AutoTrac Universal Steering Kit INSTALLATION INSTRUCTIONS PC20577 22MAR06 (ENGLISH) AutoTrac Universal Steering Kit John Deere Ag Management Solutions PC20577 (22MAR06) COPYRIGHT 2006 DEERE & COMPANY Moline, Illinois All rights reserved A John Deere ILLUSTRUCTION Manual PC20577-19-22MAR06 ...
-
John Deere PC20577 - page 2
...
-
John Deere PC20577 - page 3
Installation Instructions OUO6050,000128E –19–08SEP05–1/1 Recognize Safety Information T81389 –UN–07DEC88 This is a safety-alert symbol. When you see this symbol on your machine or in this manual, be alert to potential for personal injury. Follow recommended precautions and safe operating practices. OUO6050,0001491 –19–18OCT05–1/1 I ...
-
John Deere PC20577 - page 4
Installation Instructions OUO6050,00012B1 –19–13OCT05–1/1 AutoTrac Universal Kit PC8747 –UN–08SEP05 A—Steering Wheel/Motor D—ATU Cover Used with G—Tapered Spline Shaft K—Anti-Rotational Brackets Assembly Anti-Rotation Bracket (M) Bushing for Consoles B—AutoTrac Universal E—Steering Wheel Knob (Used H—Straight Spline Shaft L? ...
-
John Deere PC20577 - page 5
Installation Instructions OUO6050,0001293 –19–08SEP05–1/1 Install GreenStar Common Components Install StarFire Receiver, GreenStar Display, Mobile Processor, and GreenStar wiring harness (if needed). (See GREENSTAR WIRING HARNESS AND STARFIRE CAB BRACKET installation instructions.) NOTE: If routing GreenStar harness through right-hand console ...
-
John Deere PC20577 - page 6
Installation Instructions OUO6050,000128D –19–20OCT05–2/2 PC8715 –UN–07SEP05 A—Tapered Bushing B—Straight Spline Bushing C—Snap Ring 2. Select proper bushing according to splines on removed steering wheel. Insert the bushing with the correct spline type into center of steering wheel/motor assembly and install snap ring to hold bushi ...
-
John Deere PC20577 - page 7
Installation Instructions OUO6050,00012BA –19–13OCT05–1/2 Installing Clamp and Rod Anti-Rotation Bracket PC8750 –UN–19OCT05 Ex. - JD4XX0, JD8X60, JD8X70 Series Tractors A—U-bolt, Saddle, Spacer, B—Anti-Rotation Rod C—Screws E—Screw Pillow-Block and Nuts Assembly D—Cover IMPORTANT: To allow steering wheel to telescope normally, i ...
-
John Deere PC20577 - page 8
Installation Instructions OUO6050,00012BA –19–13OCT05–2/2 PC8751 –UN–08SEP05 Ex. - JD4XX0, JD8X60, JD8X70 Series Tractors A—Lock Washer C—Washer E—Washer G—Cap B—Nut D—Telescoping Knob F—Telescoping Rod Nut IMPORTANT: Tighten all hardware to proper torque according to vehicle manufacturer’s specifications. 5. Position stee ...
-
John Deere PC20577 - page 9
Installation Instructions OUO6050,00012B9 –19–14OCT05–1/2 Installing Straight Anti-Rotation Bracket PC8752 –UN–08SEP05 Ex. - JD6XX0, Small Frame JD7XX0 Tractors A—Anti-Rotation Bracket D—Lock Washer G—Telescoping Knob I—Telescoping Rod Nut B—Steering Unit E—Nut H—Washer J—Cap C—Screw (2 Used) F—Washer Continued on next ...
-
John Deere PC20577 - page 10
Installation Instructions OUO6050,00012B9 –19–14OCT05–2/2 PC8755 –UN–20OCT05 Anti-Rotation Bracket for JD6XX0, Small Frame JD7XX0 Tractors 1. Attach anti-rotation bracket (A) to steering unit (B) with screws (C). Use slots to move bracket snug against column. 2. Position steering unit on steering column. NOTE: Hardware (D), (E), (F), (H), ...
-
John Deere PC20577 - page 11
Installation Instructions OUO6050,00012B8 –19–14OCT05–1/2 Installing Angled Anti-Rotational Bracket PC8753 –UN–08SEP05 Ex. - Large Frame JD7XX0, JD8XX0, JD9XX0 A—Anti-Rotation Bracket D—Lock Washer G—Telescoping Knob I—Telescoping Rod Nut B—Steering Unit E—Nut H—Washer J—Cap C—Screw (2 Used) F—Washer Continued on next ...
-
John Deere PC20577 - page 12
Installation Instructions OUO6050,00012B8 –19–14OCT05–2/2 PC8754 –UN–19OCT05 Anti-Rotation Bracket for Large Frame JD7XX0, JD8XX0, JD9XX0 1. Attach anti-rotation bracket (A) to steering unit (B) with screws (C). Use slots to move bracket snug against column. 2. Position steering unit on steering column. NOTE: Hardware (D), (E), (F), (H), ...
-
John Deere PC20577 - page 13
Installation Instructions OUO6050,0001471 –19–20OCT05–1/2 Connect ATU Harness to GreenStar Harness PC8718 –UN–19OCT05 Routing and Installation View A—AutoTrac Universal Connection Location for the CAN Bus Extension B—AutoTrac Universal Connection Location for the Implement Connector Depending on your vehicle’s harness configuration, ...
-
John Deere PC20577 - page 14
Installation Instructions OUO6050,0001477 –19–20OCT05–1/1 ATU Harness Connection Locations Depending on your vehicle’s configuration, refer to one of the following sections for additional harness connection information. • Harness connection location in GreenStar Ready tractor side consoles • Harness connection location for implement con ...
-
John Deere PC20577 - page 15
Installation Instructions OUO6050,0001291 –19–20OCT05–2/6 PC8719 –UN–23AUG05 NOTE: Some vehicles may allow enough space for connectors to slide down between window and side console. OUO6050,0001291 –19–20OCT05–3/6 PC8774 –UN–14OCT05 2- and 4- pin Connectors A—2-pin Connector B—4-pin Connector 3. Locate and disconnect GreenSt ...
-
John Deere PC20577 - page 16
Installation Instructions OUO6050,0001291 –19–20OCT05–4/6 PC8775 –UN–14OCT05 4. Connect AutoTrac Universal harness to 2- and 4-pin connectors as shown. IMPORTANT: Be sure to make all 4 connections as shown in photo at right. OUO6050,0001291 –19–20OCT05–5/6 PC8732 –UN–30AUG05 NOTE: See machine’s Technical Manual for removing an ...
-
John Deere PC20577 - page 17
Installation Instructions OUO6050,0001294 –19–20OCT05–1/4 Harness Connection Location for Implement Connectors PC8730 –UN–19OCT05 A—AutoTrac Universal Connection Location for the Implement Harness OUO6050,0001294 –19–20OCT05–2/4 PC8780 –UN–18OCT05 A—2-pin connector B—4-pin connector C—Implement Connector NOTE: FOR TRACTO ...
-
John Deere PC20577 - page 18
Installation Instructions OUO6050,0001294 –19–20OCT05–4/4 PC8720 –UN–23AUG05 3. Route AutoTrac Universal harness through back of cab window and connect to AutoTrac Universal Steering motor. OUO6050,0001472 –19–13OCT05–1/2 Connecting to a GreenStar Harness Terminator PC8778 –UN–14OCT05 A—Terminator B—2-pin Connector C—4-pin ...
-
John Deere PC20577 - page 19
Installation Instructions OUO6050,0001472 –19–13OCT05–2/2 PC8779 –UN–18OCT05 3. Connect ATU harness into terminator connectors and remaining GreenStar harness connectors into the remaining ATU harness connectors as shown. OUO6050,0001473 –19–19OCT05–1/2 Connect Seat Switch Harness PC8777 –UN–18OCT05 A—Seat Switch Harness Conne ...
-
John Deere PC20577 - page 20
Installation Instructions OUO6050,0001473 –19–19OCT05–2/2 PC8721 –UN–23AUG05 2. Connect seat switch harness connector to seat switch. This harness includes two sets of connectors, use only the set of connectors that corresponds with the vehicle’s seat switch. Disregard the unused set. NOTE: Seat Switch is found on lower backside of the ...
-
John Deere PC20577 - page 21
Installation Instructions OUO6050,0001476 –19–18OCT05–1/1 Activating AutoTrac Universal PC8782 –19–19OCT05 AutoTrac Universal has to be activated by a 3-digit activation code the first time that it is powered up. The code can be attained by: • Calling the AMS Customer Care Center at 1-888-GRN-STAR (888-476-7827). • Logging onto www.st ...
-
John Deere PC20577 - page 22
Installation Instructions OUO6050,00012B3 –19–08SEP05–1/1 System Setup (See GREENSTAR GUIDANCE PARALLEL TRACKING AND AUTOTRAC ASSISTED STEERING SYSTEMS Operator’s Manual for system setup.) PC20577 (22MAR06) 20 Installation Instructions 032206 PN=22 ...
¿Tienes una pregunta acerca de John Deere PC20577?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con John Deere PC20577, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con John Deere PC20577 probablemente compartirá una forma de solucionarlo.