-
Echo SRM-261SB - page 1
T rimmer Att achment Operator's Manual MODEL 99944200545 FOR MODELS: SRM-2400SB SRM-260SB/261SB P AS-230/231 P AS-260/261 P AS-2601 P AS-265 X7702093800 X770001330 02/09 W ARNING Read rules for safe operation and instructions carefully. ECHO provides an Operator's Manual and a Safety Manual for Pro Attachment Series power source or Split ...
-
Echo SRM-261SB - page 2
2 I NTRODUCTION Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job- dependability. Read and understand this manual and the SAFETY MANUAL you found in the same package. You will find both easy to use and full of helpful operating tips and SAFETY messages. Maintenance ...................... ...
-
Echo SRM-261SB - page 3
T RIMMER A TT ACHMENT O PERA TOR ' S M ANUAL 3 Throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages preceded by symbols or key words. The following is an explanation of those symbols and key words and what they mean to you. S AFETY MANUAL SAFETY SYMBOLS AND IMPORT ANT INFORMA TION Sy ...
-
Echo SRM-261SB - page 4
4 4 Physical Condition Your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye Protection Wear eye protection that meets ANSI Z87.1 or CE requirements whenever you operate the unit. Han ...
-
Echo SRM-261SB - page 5
T RIMMER A TT ACHMENT O PERA TOR ' S M ANUAL 5 DANGER Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Read the Manuals • Provide all users of this equipment with the Operator’s Manual and Safety Manual for instructions on Safe Operat ...
-
Echo SRM-261SB - page 6
6 EQUIPMENT W ARNING Use this attachment with ECHO approved models only. Serious injury may result from the use of this attachment combined with a non approved ECHO product. • Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed. • Inspect shield for damage and ensure that the cut-off knife is securely in place ...
-
Echo SRM-261SB - page 7
T RIMMER A TT ACHMENT O PERA TOR ' S M ANUAL 7 1 2 3 4 D ESCRIPTION Locate this safety decal on your unit. The complete unit illustration, found in the "DESCRIPTION" section, will help you locate it. Make sure the decal is legible and that you understand and follow the instructions on it. If the decal cannot be read, a new one can be ...
-
Echo SRM-261SB - page 8
8 C ONTENTS The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, shield installation and other assembly may be necessary. After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing pa ...
-
Echo SRM-261SB - page 9
T RIMMER A TT ACHMENT O PERA TOR ' S M ANUAL 9 5 . Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation. 6 . Secure lower shaft assembly to coupler by tightening clamp ...
-
Echo SRM-261SB - page 10
10 REMOVE NYLON LINE HEAD 1 . Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool (C). 2 . Remove line head by turning it clockwise until head is completely off of shaft. 3 . Remove locking tool. C W ARNING The attachment will operate immediately when the engine starts and could result in loss of contro ...
-
Echo SRM-261SB - page 11
T RIMMER A TT ACHMENT O PERA TOR ' S M ANUAL 11 M AINTENANCE MAINTENANCE INTERV ALS Component/System Maintenance Procedure Skill Level Frequency Drive Shaft Grease 1 Every 25 hours of use Gear Housing Grease 1 Every 50 hours of use Screws/Nuts/Bolts Inspect/Tighten/Replace 1 Before each use LUBRICA TION Level 1. Tools Required: 8 & 13 mm O ...
-
Echo SRM-261SB - page 12
12 B C D Drive Shaft (Lower) IMPORTANT Lower and upper drive shaft must be lubricated with high tempera- ture automotive grease every 25 hours of operation, otherwise drive shaft assembly overheating and failure can result. 1 . Loosen two (2) screws (B) and remove center locating screw (C). Pull gear box and shield from drive shaft housing. 2 . Pul ...
-
Echo SRM-261SB - page 13
T RIMMER A TT ACHMENT O PERA TOR ' S M ANUAL 13 D C E CC F F B 3 . Use one piece of new nylon line (C) 6 m (20 ft.) long and thread through the molded loop (D) on the spool. Pull line tight and adjust so one end is 15 cm (6 in.) longer than the other. 4 . Hold the spool, opening toward you. Place index finger between the two strands and wind l ...
-
Echo SRM-261SB - page 14
14 MODEL ---------------------------------------------------- PAS Hi Torque Trimmer Attachment Shaft Length ------------------------------------------------ 864 mm (34.02 in.) Attachment Width ----------------------------------------- 176 mm (6.93 in.) Attachment Height ---------------------------------------- 245 mm (9.65 in.) Weight (dry) w/line ...
-
Echo SRM-261SB - page 15
T RIMMER A TT ACHMENT O PERA TOR ' S M ANUAL 15 NOTES ...
-
Echo SRM-261SB - page 16
ECHO, INCORPORA TED 400 O AKWOOD R OAD L AKE Z URICH , IL 60047-1564 WWW . ECHO - USA . COM DEALER? Call 1-800-432-ECHO or www .echo-usa.com CONSUMER PRODUCT SUPPORT 1-800-673-1558 8:30 - 4:30 Mon - Fri C.S.T. ADDITIONAL OR REPLACEMENT MANUALS Safety Manuals in English/Spanish or English/French are available, free of charge, from your ECHO dealer o ...
¿Tienes una pregunta acerca de Echo SRM-261SB?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Echo SRM-261SB, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Echo SRM-261SB probablemente compartirá una forma de solucionarlo.