-
Sharp DS 24D - page 1
T ABLE OF CONTENTS AB OUT THIS B OOK .......................................................... 1 THINGS Y OU SHOULD KNOW ............................ 2–5 OUTSIDE CALLS Making an Outside Call ...................................................................... 6 Answering an Outside Call ......................................................... ...
-
Sharp DS 24D - page 2
CUSTOMIZING Y OUR KEYSET AME P assword .................................................................................. 30 Select Ring T one ................................................................................ 30 Change Y our P asscode .................................................................... 30 Set Answer Mode ............ ...
-
Sharp DS 24D - page 3
ABOUT THIS B OOK Y our DS 24D keyset is the most visible part of your telephone system. Please take the time to study this guide and to become familiar with the op- eration of your keyset. Keep this guide handy . Y ou may need to look up in- structions for infrequently used features. Learning to use your keyset correctly will make everyday telephon ...
-
Sharp DS 24D - page 4
3 Y our outside calls will light green on your keyset and red on other keysets. Y ou never lose sight of your calls while they are on hold. They stay right where you put them and are identified with a green flashing light. Some simple rules to remember: • Any steady LED indicates the line or feature is in use. • A fast flashing green LED indica ...
-
Sharp DS 24D - page 5
5 DS 24D KEYSET 4 SYSTEM TONES The system provides several tones to assist you. Some of these tones are already familiar to you. Intercom Dial T one —A steady tone that indicates you can begin dialing. DIAL TONE—CONTINUOS CONTINUOUS Ringback T one —Indicates the station you dialed is ringing. RINGBACK TONE — 400 ms ON/200 ms OFF/400 ms ON/2 ...
-
Sharp DS 24D - page 6
7 NOTE: If the Hot K eypad feature has been turned off, you must first lift the handset or press the SPEAKER key before dialing. RECALL DIAL TONE Press the NEW button to disconnect your existing call, wait for dial tone and then make a new call on the same line. NOTE: If this button does not appear on your keyset, the FLASH key may be programmed to ...
-
Sharp DS 24D - page 7
BUSY ST A TION CALLBACK When you call another station and receive a busy signal: • Press the CBK key or dial 44 . • When the busy station becomes free, your keyset will ring. • Lift the handset or press SPEAKER to call the now idle station. NOTES: 1. A callback will be canceled if not answered within 30 seconds. If you have set a callback, yo ...
-
Sharp DS 24D - page 8
• If you do not answer this recall within a pre-programmed period of time, it will go to the system operator . CONSUL T A TION HOLD When you are talking on an outside line and it is necessary to consult with another extension: • Press the TRANSFER key; you will receive transfer dial tone. Y our call is placed on transfer hold. • Dial the exte ...
-
Sharp DS 24D - page 9
13 TRANSFER TO VOICE MAIL This feature is used to send a call directly to a voice mailbox. Y our keyset must have a correctly programmed VT key to accomplish this. T o transfer a call directly to a voice mailbox: • While on a call, press the VT key and dial the mailbox number . • Hang up when dialing is completed. CALL W AITING If an outside ca ...
-
Sharp DS 24D - page 10
FORW ARD NO ANSWER T o forward calls to another station when you do not answer: • Dial 603 plus the extension or group number . • Receive confirmation tone and hang up. NOTE: If the Hot K eypad feature has been turned off, you must first lift the handset or press the SPEAKER key before you begin dialing. FORW ARD BUSY/NO ANSWER If you have both ...
-
Sharp DS 24D - page 11
17 DIALING FEA TURES SPEED DIALING Y ou can dial a preprogrammed telephone number stored in the system-wide speed dial list of numbers 500–799 or from your personal list of numbers 00–49: • With the handset on-hook, press the SPD key or dial 16 . • Dial the desired speed dial number . • The telephone number is automatically dialed for you ...
-
Sharp DS 24D - page 12
2. The saved telephone number is stored in memory until you save anoth- er number . 3. Redial does not apply to intercom calls. CHAIN DIALING Y ou may manually dial additional digits following a speed dial number or chain as many speed dial numbers together as required: • After the first speed number is dialed, press SPD again and dial anoth- er ...
-
Sharp DS 24D - page 13
MEET ME P AGE • Lift the handset. • Press the Meet Me P age ( MMPG ) key or dial 54 . • Dial the desired zone number . • After the attention tone, instruct the paged person to dial 56 . • Press WAIT or TRANSFER . • Remain off-hook until the person dials 56 from any phone. • The paged person will be automatically connected with you. CA ...
-
Sharp DS 24D - page 14
23 PROGRAMMED MES SAGES When you will be away from your phone for any length of time, you can leave a programmed station message. Display stations calling you will see this message and be informed of your status or follow your instructions. • Dial 48 plus any of the message codes ( 01–30 ) listed on the back of this user guide. • T o cancel a ...
-
Sharp DS 24D - page 15
APPOINTMENT REMINDER/ALARM CL OCK This feature works like an alarm clock. Use it to remind yourself of an ap- pointment later in the day (TODA Y ONL Y) or as a daily reminder every day (DAIL Y). Y ou can set up to three alarms. Each one can be either a TODA Y ONL Y or a D AIL Y alarm. When the alarm rings, you will hear three short rings repeated t ...
-
Sharp DS 24D - page 16
NOTE: Depending on speaker volume and the acoustics of your office, it may be advisable to turn the group listening feature off before hanging up. This will eliminate a momentary squeal. ACCOUNT CODES When equipped with optional equipment, your system will allow calls to be charged to a specific account: • During any outside C.O . call, press the ...
-
Sharp DS 24D - page 17
29 • Dial 53 plus the group number plus 0 to exit the group or 1 to enter the group. Repeat as necessary . NOTE: If the Hot K eypad feature has been turned off, you must first lift the handset or press SPEAKER key . The IN/OUT key can include an extender to indicate the specific group that this key will affect. This means that if you are in multi ...
-
Sharp DS 24D - page 18
SET ANSWER MODE Y ou can receive internal calls in one of three modes (see Answering Intercom Calls under Intercom Calls for descriptions): • While on-hook, press TRANSFER and then dial 103 . • Dial 0 for Ringing, 1 for Auto Answer or 2 for V oice Announce. • Press TRANSFER to store your selection. NOTE: When your keyset is programmed for Aut ...
-
Sharp DS 24D - page 19
33 DISPLA Y FEA TURES INTERACTIVE DISPLA Y KEYS The three keys below the display are substitutes for dedicated feature keys and access codes. Pressing one of these keys has the same effect as press- ing a programmable key . These keys are called soft keys as their functions are not fixed. They change to present you with the best options for that ca ...
-
Sharp DS 24D - page 20
A UTO TIMER Display keyset users may have the timer automatically start when they answer incoming calls or after a short delay on an outgoing call. • With the handset on-hook, press TRANSFER and then dial 110 . • Dial 11 to turn the auto timer on or 10 to turn it off. • Press TRANSFER to store your selection. TIMER FUNCTION Display keyset use ...
-
Sharp DS 24D - page 21
ST A TION NAMES Y ou can assign an 11 character name to your keyset. This allows other dis- play keyset users to call you using the directory dial feature. T o program a station name: • Press TRANSFER and then dial 104 . • Enter the 11 character name using the procedure described in Alarm Reminder Messages . • Press TRANSFER to store the name ...
-
Sharp DS 24D - page 22
39 VIEWING THE NEXT CALLER ID CALL In the event that you have a call waiting or a camped-on call at your keyset, you can press the NEXT key to display the Caller ID information associated with the call in queue at your keyset. Either the CID name or CID number will show in the display depending on your Name/Number selection. T o view Caller ID info ...
-
Sharp DS 24D - page 23
41 Press SCROLL and then press STORE to save this number in a person- al speed dial bin. NOTES: 1. Each keyset defaults with ten review bins. Please see your system ad- ministrator to determine the number of bins assigned to your keyset. 2. Y our system must have LCR correctly programmed to allow you to DIAL numbers from the review list or to STORE ...
-
Sharp DS 24D - page 24
PERSONAL SPEED DIAL NUMBERS CODE NAME TELEPHONE NUMBER 25 _________________________ _________________________ 26 _________________________ _________________________ 27 _________________________ _________________________ 28 _________________________ _________________________ 29 _________________________ _________________________ 30 _________________ ...
¿Tienes una pregunta acerca de Sharp DS 24D?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sharp DS 24D, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sharp DS 24D probablemente compartirá una forma de solucionarlo.