-
Sharp AF-R50CX - page 1
AF-S50CX AF-S60CX AF-R50CX AF-R55CX AF-R60CX AF-R70CX ROOM AIR CONDITIONER INSTALLATION AND OPERATION MANUAL PAGE CONTENTS This INSTALLATION AND OPERATION MANUAL explains the proper use of your new Sharp Air Conditioner. Read these instructions carefully before installing or operating your air conditioner. The INSTALLATION AND OP- ERATION MANUAL sh ...
-
Sharp AF-R50CX - page 2
2 To aid in answering questions if you call for service or for reporting loss or theft, please record below the model and serial number located on the right side of the unit. FOR YOUR PROTECTION TO PHONE: Dial 1-800-BE-SHARP (237-4277) for: SERVICE (for your nearest Sharp Authorized Servicer) PARTS (for your Authorized Parts Distributor) ACCESSORIE ...
-
Sharp AF-R50CX - page 3
3 SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new ...
-
Sharp AF-R50CX - page 4
4 INST ALLA TION INSTRUCTIONS Before beginning installation, read these instructions carefully. Use the enclosed MOUNTING KIT for proper installation. The mounting kit is designed for wooden sill double or single hung sash-type windows. Minimum opening (Without mounting kit) 17 23 / 32 " (450mm) Window opening from stool to lower sash bottom m ...
-
Sharp AF-R50CX - page 5
5 11 10 9 8 6 7 3 4 5 1 2 11 10 9 8 7 6 5 4 3 2 1 ACCESSORIES No. Accessories Q'ty Right closure assembly 1 Left closure assembly 1 Window sash foam seal 1 1. Screw driver (medium size Phillips) 2. Tape measure or ruler 3. Knife or scissors INST ALLA TION INSTRUCTIONS 6 7 2 2 SUGGESTED T OOLS Window sash foam seal 1 (adhesive type) Bottom gask ...
-
Sharp AF-R50CX - page 6
6 Insert the right closure assembly and the left closure assembly into the top angle and the bottom channels. Secure the right and left closure to the cabinet with six of the provided screws. (L= 13 / 32 ", 10mm) 2 3 Open the window sash and place the air conditioner on the sill. Balance the unit on the sill and close the window sash securely ...
-
Sharp AF-R50CX - page 7
7 1/2 inches (13mm) Indoor side Indoor side 7 8 Secure the top angle of the unit and the top of the closure assemblies to the sash with three of the provided screws. (L=1", 25.4mm) And secure the bottom of the closure assemblies to the sill with two of the provided screws. (L=1", 25.4mm) 9 Cut the window sash foam seal to the proper lengt ...
-
Sharp AF-R50CX - page 8
8 IMPORTANT: Points to keep in mind when using your air conditioner. • Install the air conditioner by following the installation instructions given in the previous section of this manua l. • Make sure the unit is the correct capacity for the area you want to cool. • Do not modify any part of this product. • Do not insert objects into any pa ...
-
Sharp AF-R50CX - page 9
9 PRECAUTIONS • Allow 3 minutes for the compressor to restart cooling. If you turn the air conditioner off and immediately restart it, allow three minutes for the compressor to restart cooling. There is an electronic device in the unit that keeps the compressor off three minutes for protection. • If a power failure occurs during use, allow 3 mi ...
-
Sharp AF-R50CX - page 10
10 1 Receiver window for remote control signal 2 Display 3 SELECTOR indicator 4 SELECTOR pad 5 TEMPERATURE setting pad ---- Lower temp. ---- Raise temp. P ARTS NAMES UNIT CONTROL P ANEL 1 Front Cabinet 2 Air Inlet (Indoor Side) 3 Horizontal Louvers 4 Vertical Louvers 5 Air Outlet (Indoor Side) 6 Control Panel 7 Rear Cabinet 8 Air Inlet (Outdoor sid ...
-
Sharp AF-R50CX - page 11
11 HOW TO OPERA TE --- Lower temp. --- Raise temp. Touch POWER ON/OFF pad. • The unit is preset at 74 ° F and HIGH COOL. This will show in the display when the power is first turned on. • POWER indicator and SELECTOR in- dicator (COOL) will light. To turn off the unit, touch POWER ON/OFF pad again . • POWER indicator and SELECTOR indicator w ...
-
Sharp AF-R50CX - page 12
12 T O CHANGE F AN SPEED AND OPERA TION MODE During operation Touch SELECTOR pad and select the operation mode and fan speed. • SELECTOR indicator and display will light in order as you touch. HOW TO OPERA TE NOTES ON OPERA TION MODE: SELECTOR DISPLAY HIGH COOL MED COOL LOW COOL HIGH FAN MED FAN LOW FAN • The latest operation mode will be memor ...
-
Sharp AF-R50CX - page 13
13 HOW TO OPERA TE ENERGY SA VER T O CHANGE AIR FLOW DIRECTION Horizontal louvers Adjust UP/DOWN air flow The horizontal louvers are used to adjust the UP / DOWN direction of air flow, and the vertical louvers are used to adjust the LEFT / RIGHT direction of air flow for uniform and efficient cooling of the room. During normal operation, the thermo ...
-
Sharp AF-R50CX - page 14
14 HOW TO OPERA TE ON TIMER OPERA TION (If you wish to start the operation 6 hours and 30 minutes later, set the delay time as shown above.) 1 Touch the TIMER ON/OFF pad to set the delayed start time. • The time setting will change as you touch the pad. The display will change as follows; • The timer will be set, 5 seconds after the TIMER ON/OF ...
-
Sharp AF-R50CX - page 15
15 HOW TO OPERA TE OFF TIMER OPERA TION • This unit has a built-in timer that can be programmed to shut the unit off up to 12 hours in advance. You can set the timer to stop in increments of 30 minutes (0.5 hours) up to 9.5 hours in advance of the stop time, or in 1 hour increments from 10 to 12 hours in advance of the stop time. • The unit wil ...
-
Sharp AF-R50CX - page 16
16 Remove the battery compartment cover. Insert the batteries in the compartment, making sure the and polarities are properly aligned. Replace the cover. HOW TO OPERA TE INST ALLING BA TTERIES Use two size-AAA (R03) batteries. Battery compart- ment cover NOTES: • The battery life is approximately one year with normal use. • When you replace the ...
-
Sharp AF-R50CX - page 17
17 POWER TEMP. TEMP. SELECTOR SET TIMER/OFF ON/OFF • The time setting will change as you push the button. The display will change as follows; • The last OFF time setting is memorized by the unit and will appear on the display when the button is pushed. • The timer will be set, 5 seconds after the SET TIMER/OFF button is pushed for the last ti ...
-
Sharp AF-R50CX - page 18
18 CLEANING AND MAINTENANCE CLEANING THE FIL TER If the filter is clogged with dust, the amount of air flow will be reduced, resulting in poor cooling performance. The filter should be cleaned every 10 days. At the beginning of every cooling season or after a long period of inactivity, clean the filter before starting the unit. 1 CLEANING OF THE FR ...
-
Sharp AF-R50CX - page 19
19 BEFORE CALLING FOR SER VlCE IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECK THE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose? • Is the fuse blown or the circuit breaker tripped? • Did you restart the unit within 3 minutes after a power fail ...
-
Sharp AF-R50CX - page 20
SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 SHARP CORPORATION Osaka, Japan Printed in Thailand TINSEA292JBRZ 01LO TL 1 ...
¿Tienes una pregunta acerca de Sharp AF-R50CX?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sharp AF-R50CX, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sharp AF-R50CX probablemente compartirá una forma de solucionarlo.