-
NewAir AK-200 - page 1
Please read and save these instructions. AK-200BK KEGERATOR OWNER'S MANUAL AK-200 SER IES ...
-
NewAir AK-200 - page 2
1 CONTENTS The rating data indicated on the energy label is based on the testing condition of installing the un - extended air exhaust duct without adaptor A & B ( The duct and the adaptor A & B are listed in the accessories chart of the Instruction Manual ). N O T E .............................................................. ........... ...
-
NewAir AK-200 - page 3
2 SAFETY PRECAUTIONS Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: Use this appliance only for its intended purpose as described in this operation manual. This appliance must be properly installed in accordance with the installation instruction ...
-
NewAir AK-200 - page 4
3 SAFETY PRECAUTIONS This appliance is not intended for use by young children or infirm persons without supervision. This appliance is NOT A TOY! Y oung children should be supervised to ensure that they do not play with this appliance. When transporting the refrigerator , keep the unit in the upright position. Do not tilt the appliance beyond 45° ...
-
NewAir AK-200 - page 5
4 SAFETY PRECAUTIONS Impor tant Safety Precautions of CO 2 (Carbon Dio xide) Gas Co 2 gas can be dangerous! CO cylinders contain high-pressure compressed 2 gas, which can be hazardous if not handled properly . Make sure you read and understand all the procedures for the CO cylinders before installation. 2 Always connect the CO cylinder to a regulat ...
-
NewAir AK-200 - page 6
5 SA VE THESE INSTRUCTIONS For Future Use Risk of child entrapment! Before throwing away your old appliance: ● T ake off the doors. ● Leave the shelves or other accessories in place so that children may not easily become trapped inside. (Note: If the refrigerator has been placed in a horizontal or tilted position for any period of time, please ...
-
NewAir AK-200 - page 7
6 you are still unsure whether the kegerator has been properly installed, we recommend that you contact a qualified installer . Note: Allow the kegerator to stand in an upright position for at least 8 hours before plugging in the unit. This is very important! Once the unit is laid on its side, the refrigera nt in the refrigeration system is shi ...
-
NewAir AK-200 - page 8
Also, See Illustrations E & F on pages 12 & 13, showing the hose connections to CO 2 regulator and the regulator to the beer tap. Installing the Guardr ail Follow the steps below to install the guardrail. 1. Place the guardrail on top of the cabinet. 2. Align all support feet of the guardrail with the holes on the top of the unit. Installin ...
-
NewAir AK-200 - page 9
DANGER! CO can be dangerous! CO cylinders contain high-pressured gas, which can be 2 2 hazardous if handled improperly . They must be handled with care. Tapping the Beer Keg – Installing Keg Tap (Single-Valve Type Barrel) Follow these steps below to tap the beer keg. Make sure the black pull handle of the tap is in the closed (up) position before ...
-
NewAir AK-200 - page 10
Illustration A Black Rubber Washer Installed in Wing Nut Illustration B Then Attach to CO2 Bottle Connector f i g .1 f i g .2 f i g .3 f i g .4 f i g .5 C on n e c t t o t h e Beer Line T ube Black pull handle Keg Coupler Connect to C O2 G a s Line Tube OCKWISECL R N T U Beer Keg Neck Lift Upright B ee r K e g Keg Support Operating Your Kegerator D ...
-
NewAir AK-200 - page 11
Note: It is normal to see condensation form on the faucet. It is caused by the difference of temperature between the cold beer and the inside of the faucet when beer is flowing through the line. Cleaning & Maintenance Flushing the tubes Follow the steps below to clean the keg tap and hoses. (See Illustration on the right.) Turn off CO completel ...
-
NewAir AK-200 - page 12
Important Safety Message for Draft Beer Dispensing Safety devices should be installed in the following places: A. On or directly downstream from the CO regulator. B. On the tapping device C. In-line in the pressure system Note: Locations A and B noted above are preferable. If possible, they should be built into the CO regulator and tapping device s ...
-
NewAir AK-200 - page 13
I l l u s t r a t i o n D I l l u s t r a t i o n E 12 SPECIAL SAFETY INFORMA TION ...
-
NewAir AK-200 - page 14
I l l u s t r a t i o n F QUICK ASSEMBL Y INSTRUCTIONS Installing Casters 1. Remove all items from inside cabinet. 2. Lay kegerator on its side. 3. Install four casters, making sure the two locking casters are up front 4. Stand kegerator up on casters and allow Freon to settle for at least 8 hours before plugging in. *All O-rings and rubber washers ...
-
NewAir AK-200 - page 15
refrigerator . 3. Sit tower down onto opening and turn counter clockwise to lock. Install Guardrail 1. Place guardrail (10) over rubber inserts on refrigerator cabinet and push down to secure. Connecting regulator and coupler (Illustrations on page 9) 1. Make sure regulator valve and CO tank valve are off by turning clockwise. 2. Connect regulator ...
-
NewAir AK-200 - page 16
15 QUICK ASSEMBL Y INSTR UCTIONS Band 6 ...
-
NewAir AK-200 - page 17
LIMITED MANUF ACTURER'S WARRANTY This appliance is covered by a limited manufacturer's warranty . For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditio ...
¿Tienes una pregunta acerca de NewAir AK-200?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con NewAir AK-200, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con NewAir AK-200 probablemente compartirá una forma de solucionarlo.