-
Wayne-Dalton 9700 - page 1
GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...
-
Wayne-Dalton 9700 - page 2
2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. FLAG ANGLES (AS REQUIRED): A1. Fully Adjustable (F .A.) Flag Angles A2. Quick Install (Q.I.) F ...
-
Wayne-Dalton 9700 - page 3
I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...
-
Wayne-Dalton 9700 - page 4
5/16” x 1 5/8” Hex head lag screws (as required) 1/4”-20 x 9/16” Track bolts (as required) (2) 5/16”-18 x 3/4” Carriage bolts 1/4”-14 x 5/8” Self tapping screws (as required) Cotter pin 5/16” x 1-1/4” Clevis pin Door Section Identification Graduated end and center hinges are always pre-attached at the top of each section (excep ...
-
Wayne-Dalton 9700 - page 5
Weatherstrips Level header Finished Door width Jambs Backroom Plumb jambs Finished Door Height Nail Headroom Header board 2”x 6” lumber preferred Suitable mounting surface 2”x 6” lumber minimum Weather- strips Weather- strips Jamb Quick Install track Fully Adjustable track Jamb 1/8” to 1/4” Min. Side room Clearance is 3 1/2” Min. Side ...
-
Wayne-Dalton 9700 - page 6
INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . NOTE: Reference TDS 160 for general garage door terminology at www.dasma.com . Quick Install Flag Angles T ools: None ...
-
Wayne-Dalton 9700 - page 7
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Cable Drum Assemblies and T rack Rollers T ools: None 5 NOTE: Refer to door section identification ...
-
Wayne-Dalton 9700 - page 8
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com sticker , with the lower alignment sticker on right hand side, on the back of door . Keep sec- tion ...
-
Wayne-Dalton 9700 - page 9
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Horizontal T racks/Q.I Flag Angles T ools: Ra tchet wrench, 9/16” Socket, 9/16” Wrench, level, ...
-
Wayne-Dalton 9700 - page 10
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Owner’ s Manual. NOTE: If you are not installing the idrive ® opener on your garage door , you m ...
-
Wayne-Dalton 9700 - page 11
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com (2) 5/16” x 1-5/8” Lag screws T orqueMaster ® spring tube Center bracket bushing assembly Secu ...
-
Wayne-Dalton 9700 - page 12
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com WINDING SPRING TURN CHART 7’-6” 17 7’-9” 17-1/2 8’-0” 18 Securing Drum Wraps T ools: St ...
-
Wayne-Dalton 9700 - page 13
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Horizontal tracks Door edges 3/4” To 7/8” 3/4” To 7/8” Balancing Door T ools: Ra tchet wren ...
-
Wayne-Dalton 9700 - page 14
T orqueMaster ® Plus Reset Instructions T ools: Ra tchet wrench, 5/8” Socket, 3” Socket extension, 5/8” Wrench, (2) Vice clamps, Step ladder IMPORT ANT : THE DRA WBAR OPERA TOR FORCE SETTINGS MUST BE ADJUSTED ACCORDING TO THE MANUF ACTURER’S INSTR UCTIONS. SOME LIGHTER WEIGHT DOORS ARE DESIGNED TO OPERA TE WITH A SINGLE COUNTERBALANCE SPRI ...
-
Wayne-Dalton 9700 - page 15
Pull Down Rope T ools: Power drill, 1/8” Drill bit, T ape measure W ARNING W ARNING DO NOT INST ALL PULL DOWN ROPE ON DOORS WITH OPERA TORS. CHILDREN MA Y BECOME ENT ANGLED IN THE ROPE CAUSING SEVERE OR F A T AL INJURY . Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1 ...
-
Wayne-Dalton 9700 - page 16
Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmosphere for a period of time. Slight chalking may also occ ...
-
Wayne-Dalton 9700 - page 17
Lifetime limited warranty Model 9700 Subject to the terms and conditions contained in this Lifetime Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the sections of the door , which is described at the top of this page, for as long as you own the door against: i) Peeling, cracking, or chalking of the original factory-a pplied coating o ...
-
Wayne-Dalton 9700 - page 18
AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...
¿Tienes una pregunta acerca de Wayne-Dalton 9700?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Wayne-Dalton 9700, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Wayne-Dalton 9700 probablemente compartirá una forma de solucionarlo.