-
Cleveland Range KDP - page 1
Operators Manual Installation, Operation & Service Floor Model Direct Steam Kettles MODELS : KDL, KDL-T , KDL-SH, KDL-TSH, KDP , KDP-T SE95007 Rev . 6 1333 East 179th St., Cle v eland, Ohio , U .S .A. 44110 Phone: (216) 481-4900 F ax: (216) 481-3782 Visit our web site at www .clev elandrange .com Clev elan d ™ Enodis ...
-
Cleveland Range KDP - page 2
Shut off pow er at main fuse disconnect prior to ser vicing. Ensure kettle is at room temperature and pressure gauge is showing z ero or less prior to removing any fittings . Inspect unit daily f or proper operation. 0 Do not fill kettle abo v e recommended le v el marked on outside of k ettle. Surf aces ma y be e xtremely hot! Use protectiv e equi ...
-
Cleveland Range KDP - page 3
GENERAL Installation of the unit must be accomplished by qualified installation personnel working to all applicable local and national codes. Improper installation of pr oduct could cause injury or damage. This unit is built to comply with applicable standards for manufacturers. Included among those appr oval agencies are: UL, NSF , ASME/Ntl.Bd., C ...
-
Cleveland Range KDP - page 4
STEAM All steam plumbing to and from the kettle and steam boiler should be thoroughly cleaned and inspected for dirt and debris before final connection to the kettle are made. Check the rating plate for the maximum steam pressur e that your kettle is rated for . If the steam supply pressur e exceeds the rated pressur e, a pressur e reducing valve i ...
-
Cleveland Range KDP - page 5
STEAM REQUIREMENTS FOR KETTLES Kettle Cap. Kettle 25 psi Steam 265°F 40 psi Steam 287°F 80 psi Steam 302°F U .S. Gal. Dia. Lbs./Hr . Hp./Hr . Lbs./Hr . Hp./Hr . Lbs./Hr . Hp./Hr . 40 26" 100 3 120 4 150 4.5 60 29.5" 150 4.5 190 5.5 230 7.0 80 33" 210 6.0 260 7.5 300 9.0 100 36" 260 7.5 320 9.5 390 11.0 125 40" 320 9.5 40 ...
-
Cleveland Range KDP - page 6
OPERA TING INSTRUCTIONS CLEVELAND STEAM COOKING EQUIPMENT IS INTENDED FOR COMMERCIAL USE ONL Y BY PR OFESSIONALL Y TRAINED PERSONNEL. General Parts Drawing ITEM # DESCRIPTION 1. Steam Inlet V alve Opens and closes the steam supply to the kettle. 2. Hand Wheel Used for tilting the kettle up or down. Some units have an optional Power Tilt Control Swi ...
-
Cleveland Range KDP - page 7
OPERA TION 1. Ensure that ther e is an adequate steam supply to the kettle. 2. For optimum perfor mance on free-standing floor model tilting kettles, open drain cock to drain condensate from the kettle’ s jacket, then close drain cock before applying steam to a cold kettle. 3. If the kettle is equipped with a tangent draw-off valve, ensure that i ...
-
Cleveland Range KDP - page 8
CARE AND CLEANING Cooking equipment must be cleaned regularly to maintain its fast, efficient cooking performance and to ensure its continued safe, r eliable operation. The best time to clean is shortly after each use (allow unit to cool to a safe temperature). W ARNINGS ➩ Do not use detergents or cleansers that are chloride based or contain quat ...
-
Cleveland Range KDP - page 9
ST AINLESS STEEL EQUIPMENT CARE AND CLEANING (Suppied courtesy of Nafem. For more information visit their web site at www .nafem.org) Contrary to popular belief, stainless steels ARE susceptible to rusting. Corrosion on metals is everywhere. It is r ecognized quickly on iron and steel as unsightly yellow/orange rust. Such metals are called “activ ...
-
Cleveland Range KDP - page 10
F AUCET ASSEMBL Y ITEM P ART DESCRIPTION QTY . NO . NO . 3/4" Spouts 1. KE50825-2 KDL-60/80/100-T , KDP-60/80-T . . . . . . . . .1 KE50825-3 KDL-25/40-T , KDP-25/30/40-T . . . . . . . . . .1 KE50825-7 KDL-40/60/80-TSH, . . . . . . . . . . . . . . . . . .1 KE50825-5 ALL ST A TIONAR Y KETTLES . . . . . . . . . . .1 2. F A95022 Retaining Ring . . ...
-
Cleveland Range KDP - page 11
STEAM CONTROL ASSEMBLIES ITEM NO . P ART NO . DESCRIPTION QTY . 1. KE51892 Retaining ring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 2. KE51888 W asher . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 3. F A11501 V alve knob s ...
-
Cleveland Range KDP - page 12
CONTROL CONSOLE COMPONENTS - HAND TIL T ITEM NO . P ART NO . DESCRIPTION QTY . 1. F A11134 Screw , #1-24 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 2. F A11501 Screw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 3. SE ...
-
Cleveland Range KDP - page 13
CONTROL CONSOLE COMPONENTS - HAND TIL T ...
-
Cleveland Range KDP - page 14
ITEM NO . P ART NO . DESCRIPTION QTY . 1. KE55057-10 Gear Box Lid (25-60 gallon) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 KE55057-3 Gear Box Lid (80 gallon & up) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 2. F A11134 Screw , 10-24 x 3/8" SS . . . . . . . . . . . . . ...
-
Cleveland Range KDP - page 15
CONTROL CONSOLE COMPONENTS - POWER TIL T ITEM NO . P ART NO . DESCRIPTION QTY . 8. SE00028 Steam Inlet Knob Assembly (Item no. 7 included) . . . . . . . . . . . . . . . . . . . . . . .1 9. KE50441 Tilt Shaft . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 10. F A95008 Locknut, 3/4-16 ...
-
Cleveland Range KDP - page 16
HINGE ASSEMBL Y 1 5 3 2 13 12 6 4 7 11 8 10 9 9 ITEM NO . P ART NO . DESCRIPTION QTY . Hinge Assembly 1. - 11 KE50597-1 25 - 40 Gallon, 20 Gallon Full Jacketed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 KE50597-2 60 - 80 Gallon, 30 - 40 Gallon Full Jacketed . . . . . . . . . . . . . . . . . . . . . . . . . . .1 KE50597-3 100 - 1 ...
-
Cleveland Range KDP - page 17
1 2 3 4 5 6 7 T ANGENT DRA W-OFF V AL VE ITEM NO. P ART NO. DESCRIPTION QTY . 1. - 7. KE50973 2” DRAW-OFF ASSEMBL Y . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 KE50972-B 3” DRA W-OFF ASSEMBL Y . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 1. F A95049 WING NUT , TD-2 . . ...
-
Cleveland Range KDP - page 18
PRESSURE RELIEF V AL VE TESTING PROCEDURE The pressur e relief valve must be checked at least twice a year as part of the normal maintenance per formed. 1. With the kettle empty , fully open the steam valve and allow the kettle to preheat. 2. Stand to the side of the pressur e relief valve discharge tube and pull valve open for a maximum of one sec ...
-
Cleveland Range KDP - page 19
TROUBLESHOOTING GUIDE This section contains information intended for use by Authorized Service Personnel only . PROBLEM A / Kettle heats too slowly or does not come to a boil. Probable Cause Remedy 1. Inadequate steam flow . Check for correct steam using chart below . If kettle is connected to a steamer and powered by a generator the units should b ...
¿Tienes una pregunta acerca de Cleveland Range KDP?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Cleveland Range KDP, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Cleveland Range KDP probablemente compartirá una forma de solucionarlo.