-
Lowrance electronic LWX-1 - page 1
L WX-1 Satellite W eather Radio Module Installation Instructions WEA THER WEA THER 988-0158-13A ...
-
Lowrance electronic LWX-1 - page 2
Copyright © 2009 Navico All rights reserved. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance Electronics. Lowrance® is a registered trademark of Navico. Navico may nd it necessary to change or end our policies, regulations and special offers at ...
-
Lowrance electronic LWX-1 - page 3
1 This document covers the installation and status/diagnostic indicators available for the Lowrance L WX-1. It also details how to activate a SIRIUS subscription. L WX-1 package include: Main Components: Antenna Receiver (AR) pre-congured for a mast mount 1. AR Interconnect Cable (attached to AR) connects to IM • Interface Module (IM) 2. IM Po ...
-
Lowrance electronic LWX-1 - page 4
2 L WX-1 Installation Options The L WX-1 can be mounted in three basic congurations: AR Mast Mount (factory-installed option) 1. AR Flush Mount with cable routed through the mounting surface 2. (e.g. deck) AR Flush Mount with cable routed on top of the mounting surface 3. ...
-
Lowrance electronic LWX-1 - page 5
3 1. AR Mast Mount Installation The L WX-1 AR is shipped in the retail box factory-congured for a mast mount. T o use AR Mast Mount Installation: Loosen the four AR Bolts & Nuts (a couple of counter-clockwise 1. turns on each). The AR Mast Boot will loosen, allowing the AR Mast Mount to turn. 2. Insert the AR Interconnect Cable into the Ante ...
-
Lowrance electronic LWX-1 - page 6
4 2. AR Flush Mount Installation (through deck) AR Flush Mount with cable routed through the deck. T o use AR Flush Mount through-deck installation: Remove the four AR Bolts & Nuts (the AR Cover and AR Base are 1. factory tted – DO NOT A TTEMPT T O SEP ARA TE THEM) Use the AR Gasket as a template to mark where the AR Mounting 2. Screws and ...
-
Lowrance electronic LWX-1 - page 7
5 3. AR Flush Mount Installation (above deck) In this AR Flush Mount installation, the cable is routed out the back of the L WX-1. This installation is the same as AR Flush Mount through-deck Installation, except the AR Interconnect Cable is routed under the L WX-1 and out the back above the deck instead of through the deck. T o use AR Flush Mount ...
-
Lowrance electronic LWX-1 - page 8
6 IM Installation W ith all of the AR installation options, it is recommended that the IM is mounted/ installed below deck. T o install the IM: Open the IM enclosure by unscrewing the two IM Enclosure Screws 1. on the front panel Insert the male RJ45 2. connector on the end of the AR Interconnect Cable into the female RJ45 connector in the middle o ...
-
Lowrance electronic LWX-1 - page 9
7 L WX-1 Status Indicators The L WX-1 status indicators are the two LEDs on the Interface Module. The IM in- dicators are to be used to obtain connectivity with the end-user device, where more detailed problem diagnosis is available. Power LED indicates L WX-1 Power: LED OFF 1. — No power to the Interface Module LED ON (solid green) 2. — Power ...
-
Lowrance electronic LWX-1 - page 10
8 If LED blinks ON/OFF three times during the power-up cycle and then turns OFF , an Ethernet loop back connector should be connected to the IM Network Cable and the L WX-1 should be power cycled. If the blinking during power-up does not recur , then the IM Network Cable is good, and the end-user device should be checked. When IM Network Cable is p ...
-
Lowrance electronic LWX-1 - page 11
9 T o activate a SIRIUS subscription: After the L WX-1 module is installed, locate the label on the front ap 1. of the L WX-1 carton Record your ESN number (SIRIUS ID) and contact SIRIUS at 1-800- 2. 869-5480. SIRIUS Marine W eather service can only be activated by phone. Access SIRIUS status screen to make sure subscription (Weather 3. Status, ...
-
Lowrance electronic LWX-1 - page 12
10 L WX-1 Diagnostic Report The following information is shown in the Diagnostic Report retrievable by the Chartplotter . T o view the Diagnostic report, access the SIRIUS Status screen and press MENU . L WX-1 System Information Name Description Example L WX-1 Software V ersion Software version L WX-1 is running L WX200807280148 L WX-1 Revision Lev ...
-
Lowrance electronic LWX-1 - page 13
11 SIRIUS Module Information Name Description Example Radio Activation Status - Data Indicates the activation status of the SIRIUS Radio Module. The rst value indicating an active subscription. Parameter 1 — indicates is set to ‘1’ when there are subscribed channels. Parameter 2 — provides a bit mask for the individualized, enabled and a ...
-
Lowrance electronic LWX-1 - page 14
12 Radio Signal Strength Indicates the signal strength received by the SIRIUS Radio Module. The value is in the range of 0-3 with 3 being maximum. V alues are dened as follows: 0 = no signal 1 = weak signal 2 = good signal 3 = excellent signal 2 Radio Channel – Data Indicates the tuned data channel for the SIRIUS Radio Module 199 Radio SIRIUS ...
-
Lowrance electronic LWX-1 - page 15
13 NA VICO LIMITED TWO-YEAR LOWRANCE W ARRANTY “W e,” “our ,” or “us” refers to NA VICO, the manufacturer of this Lowrance product. “Y ou” or “your” refers to the rst person who purchases this product as a consumer item for personal, family or household use. W e warranty this product against defects or malfunctions in materia ...
-
Lowrance electronic LWX-1 - page 16
www .lowrance.com 988-0158-13A Pub. 012809 © Copyright 2009 All Rights Reserved Navico ...
¿Tienes una pregunta acerca de Lowrance electronic LWX-1?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Lowrance electronic LWX-1, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Lowrance electronic LWX-1 probablemente compartirá una forma de solucionarlo.