-
Pelco BB5T - page 1
Pelco • 3500 Pelco Way, Clovis • CA 93612-5699 USA • www.pelco.com In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150 International Customers: Tel (1-559) 292-1981 or FAX (1-559) 348-1120 ® BB5A/BB5T Series Back Box Installation/ Operation Manual C1488M-B (2/99) ...
-
Pelco BB5T - page 2
2 Pelco Manual C1488M-B (2/99) REVISION HISTOR Y Manual # Date Comments C1488M 6/98 Original version. C1488M-A 9/98 Rev A. Revised the manual to incorporate Spectra™ Lite material. C1448M-B 2/99 Rev B. Revised the input power ratings, certifications, and operating temperatures. Revised model numbers for Spectra Lite™. CONTENTS Section Page 1.0 ...
-
Pelco BB5T - page 3
Pelco Manual C1488M-B (2/99) 3 1.0 GENERAL 1.1 IMPORT ANT SAFEGUARDS AND W ARNINGS Prior to installation and use of this product, the following W ARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes. 2. Unless the unit is specifically marked as a NEMA T ype 3, 3R ...
-
Pelco BB5T - page 4
4 Pelco Manual C1488M-B (2/99) 1.2 REGULA TOR Y NOTICES NOTE: This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of the FCC rules. These limits are de- signed to provide reasonable protection against harmful interference in a residen- tial installation. This equipment generates, uses, ...
-
Pelco BB5T - page 5
Pelco Manual C1488M-B (2/99) 5 Figure 1. Back Box Parts COMPASS TOOL SAFETY BRACKET CONDUIT FITTING & LOCK NUT T -RAIL CLIP 1.3 UNP ACKING INSTRUCTIONS Unpack and inspect all parts carefully . Be sure to save the shipping box and any inserts. They are the safest material in which to make future shipments. If an item appears to have been damaged ...
-
Pelco BB5T - page 6
6 Pelco Manual C1488M-B (2/99) 2.0 DESCRIPTION The BB5A Series back boxes are used with the SD5 Series of Spectra™ (Software V ersion 3.0) domes and SD5A Series of Spectra II™ domes. The BB5T Series back boxes are used with the SD5T Series of Spectra™ Lite domes. The BB5A-F and BB5T -F are for indoor installation in hard ceilings or standard ...
-
Pelco BB5T - page 7
Pelco Manual C1488M-B (2/99) 7 3.0 INST ALLA TION FOR IN-CEILING MODELS This manual covers the installation of the BB5A-F , BB5A-PB, BB5A-PG, BB5A-PG-E, BB5T -F , BB5T -PG, and BB5T -PG-E back boxes only . For complete installation and operating instructions for the SD5 Series of Spectra™ (Software V ersion 3.0) domes, refer to manual C1456M-D; f ...
-
Pelco BB5T - page 8
8 Pelco Manual C1488M-B (2/99) 3.1.2 Suspended Ceiling 1. Remove the ceiling tile from the ceiling. 2. Locate the center point to drill a hole in the tile. 3. Drill a hole in the ceiling tile using a 3/32-inch drill bit. 4. Remove the compass tool from the parts bag (refer to Figure 2). Press the stud of the compass tool into the hole in the ceilin ...
-
Pelco BB5T - page 9
Pelco Manual C1488M-B (2/99) 9 Figure 4. Installing Back Box Figure 5. Fastening Back Box HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILING TILE HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILING TILE ...
-
Pelco BB5T - page 10
10 Pelco Manual C1488M-B (2/99) Figure 6. Wiring Diagram for Spectra™ (V er . 3.0) and Spectra II™ THUMBSCREW Figure 7. Wiring Diagram for Spectra™ Lite CONTROL (RS-422) 7 +5 to +24 VDC EXTERNAL RELA Y (WIRING EXAMPLE) ...
-
Pelco BB5T - page 11
Pelco Manual C1488M-B (2/99) 11 T able B. 24 V AC Wiring Distances The following are the recommended maximum distances for 24 V AC with a 10- percent voltage drop. (T en percent is generally the maximum allowable voltage drop for AC-powered devices.) W ire Gauge 20 18 16 14 12 10 30 vA 94 ft 150 ft 238 ft 380 ft 603 ft 960 ft (28 m) (45 m) (72 m) ( ...
-
Pelco BB5T - page 12
12 Pelco Manual C1488M-B (2/99) 3.3 BACK BOX INST ALLA TION 1. Suspended Ceiling Only (for hard ceiling, go to step 2) – Install the ceiling tile with the back box. Attach a T -rail clip on each side of the ceiling tile as shown in Figure 5. 2. Install a safety chain or cable (not supplied) that will support up to 16 pounds (7.3 kg). Fasten one e ...
-
Pelco BB5T - page 13
Pelco Manual C1488M-B (2/99) 13 3.4 BACK BOX CONNECTIONS Depending on the type of dome, refer to either Figure 10 or 1 1 to attach the wiring to the interconnect circuit board inside the back box. Also refer to Figure 6 or 7 if necessary . 1. Earth Ground - Connect earth ground to the middle connector on the power connector . 2. Power - Connect 24 ...
-
Pelco BB5T - page 14
14 Pelco Manual C1488M-B (2/99) From controller T o 4-Wire terminal on circuit board RX- TX- RX+ TX+ TX- RX- TX+ RX+ 4. Control - If you are using a Coaxitron ® controller , control signals will be trans- mitted over the video coax. If you are using RS-422 (P or D) control signals, connect the control lines from the controller to the circuit board ...
-
Pelco BB5T - page 15
Pelco Manual C1488M-B (2/99) 15 4.0 INST ALLA TION FOR PENDANT MODELS 4.1 PENDANT -MOUNT INST ALLA TION 1. Install the pendant dome mount. Refer to the instructions provided with the mount. If the mount is outdoors, make sure it is properly sealed to keep mois- ture out. 2. Bring the wiring for the dome through the mount. Refer to Section 3.2, WIR- ...
-
Pelco BB5T - page 16
16 Pelco Manual C1488M-B (2/99) 5.0 TROUBLESHOOTING Symptom: LED does not light. If the red power LED on the door of the interconnect circuit board in the back box does not light: 1. T urn off power . 2. Open the door to the interconnect circuit board and check the fuse. Refer to Figure 10 for the location of the fuse. If the fuse is bad, replace i ...
-
Pelco BB5T - page 17
Pelco Manual C1488M-B (2/99) 17 6.0 SPECIFICA TIONS MECHANICAL Construction Back box: Aluminum Cable Entry In-Ceiling: .75" (1.91 cm) conduit fitting Pendant: Through 1.5" (3.81 cm) NPT pendant mount Dimensions: See Figure 12 ELECTRICAL Input Voltage: 18-30 VAC, 24 VAC nominal Input Power In-ceiling: 30 vA Indoor pendant: 30 vA Outdoor pe ...
-
Pelco BB5T - page 18
18 Pelco Manual C1488M-B (2/99) Figure 12. SD5 Series Dimension Drawing 6.60 (16.76) 5.25 (13.34) 3.25 (8.26) 7.25 (18.13) 8.25 (20.96) 5.90 (14.99) In-Ceiling Dome Pendant Dome NOTE: V ALUES IN P ARENTHESES ARE CENTIMETERS, ALL OTHERS ARE INCHES. 5.90 (14.99) 10.90 27.69 6.75 (17.15) 8.52 (21.64) 5.83 (14.80) TOP PORTION OF BACK BOX IS REMOVABLE F ...
-
Pelco BB5T - page 19
Pelco Manual C1488M-B (2/99) 19 NOTES ...
-
Pelco BB5T - page 20
20 Pelco Manual C1488M-B (2/99) 7.0 W ARRANTY AND RETURN INFORMA TION Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. Endura and ExSite are trademarks of Pelco. © Copyright 1999, Pelco. All rights reserved. WARRANTY Pelco will repair or replace, without charge, any merchandise proved defect ...
¿Tienes una pregunta acerca de Pelco BB5T?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Pelco BB5T, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Pelco BB5T probablemente compartirá una forma de solucionarlo.