-
Hearth and Home Technologies 4100I-GD-B - page 1
DO NOT DISCARD THIS MANUAL NOTICE • Important operating and maintenance instructions included. • Leave this manual with party responsible for use and operation. • Read, understand and follow these instructions for safe installation and operation. DO N O T DIS C AR D WA RN ING If the information in these ins truc tio ns i s n ot f oll owed ...
-
Hearth and Home Technologies 4100I-GD-B - page 2
4100-I ACT WOOD INSERT Page 2 September 1, 2008 R 250-7201E and Welcome to the Quadra-Fire Family ! Hearth & Home T echnologies welcomes you to our tradition of excellence! In choosing a Quadra-Fire appliance, you have our assurance of commitment to quality , durability , and performance. This commitment begins with our research of the market, ...
-
Hearth and Home Technologies 4100I-GD-B - page 3
Page September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R SAFETY & OVER VIEW OF APPLIANCE Dimensions ----------------------------------------------------- 4 Minimum Clearances to Combustibles ------------------ 5 Listings ---------------------------------------------------------- 6 Chimney Height & Draft and 2-10- Rule -------------- ...
-
Hearth and Home Technologies 4100I-GD-B - page 4
4100-I ACT WOOD INSERT Page 4 September 1, 2008 R 250-7201E DIMENSIONS T OP VIEW SIDE VIEW FRONT VIEW 20-7/8" (50mm) 0 o 10-7/8" (276mm) 21-5/8" (549mm) 7-7/8" (200mm) 16-1/4" (41mm) C L 24" (610mm) 0" (762mm) 12-1/8" (08mm) 9-5/16" (15mm) 45-/4" (1 162mm) A B 0-7/8" (78 ...
-
Hearth and Home Technologies 4100I-GD-B - page 5
Page 5 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R Hearth Extension A B C D F E Insert SideW all Maximum Mantel Depth - 10" (254mm) Fascia or T rim Mantel Thermal Protection USA & Canada USA CANADA A Sidewall to Stove 15" (381mm) 15" (381mm) B Mantel to Stove 26" (660mm) 23" (584mm) C T op Trim to Stove 20" ...
-
Hearth and Home Technologies 4100I-GD-B - page 6
4100-I ACT WOOD INSERT Page 6 September 1, 2008 R 250-7201E A VOID FIRE: T o ensure that insulation or any other com- bustible material does not contact the chimney , a chimney inside the house must have at least 2 inches (51mm) of air space clearance around t he chimney . A chimney outside the house must have at least one inch (25mm) clearance to ...
-
Hearth and Home Technologies 4100I-GD-B - page 7
Page 7 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R IF INST ALLING THIS MODEL T O A MASONRY CHIMNEY , AL W A YS BE SU RE TH E CHI MNEY IS IN G OO D CON DITI ON AND THA T I T MEET S THE MIN IMU M ST ANDAR DS OF THE ? ...
-
Hearth and Home Technologies 4100I-GD-B - page 8
4100-I ACT WOOD INSERT Page 8 September 1, 2008 R 250-7201E Floor Ceiling Caulk Floor (second Story) Non-Combustible Firestopping Material clearance from exterior 2 inch (51mm ) A chimn ...
-
Hearth and Home Technologies 4100I-GD-B - page 9
Page 9 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R 1. An outside air inlet must be provided for combustion and must remain clear of leaves, debris, ice and/or snow . It must be unrestricted while unit is in use to prevent room air starvation which can cause smoke spillage and an inability to maintain a re. Smoke spillage can also set of ...
-
Hearth and Home Technologies 4100I-GD-B - page 10
4100-I ACT WOOD INSERT Page 10 September 1, 2008 R 250-7201E MASONR Y FIREPLACE USING DIRECT -CONNECT METHOD ? ...
-
Hearth and Home Technologies 4100I-GD-B - page 11
Page 1 1 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R F ACTOR Y -BUIL T ZERO CLEARANCE FIREPLACE Listed Liner Mantel SEAL DAMPER AREA OR FACE SEAL ? ...
-
Hearth and Home Technologies 4100I-GD-B - page 12
4100-I ACT WOOD INSERT Page 12 September 1, 2008 R 250-7201E Leveling Bolts Sheet Metal Shims Place under leveling bolts and slide insert into place Leveling Bol t Reach between side of insert and outer skin cut-out view This product shipped with two leveling bolts, and two sheet metal guides for ease in sliding the insert into place when using the ...
-
Hearth and Home Technologies 4100I-GD-B - page 13
Page 1 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R SECURING LINER T O CHIMNEY RING There are two options to secure the liner to the chim- ney ring: Option One: If there is enough room on the top of the insert to work, hand bend the two tabs upward 90°. Secure the liner with the supplied hex ...
-
Hearth and Home Technologies 4100I-GD-B - page 14
4100-I ACT WOOD INSERT Page 14 September 1, 2008 R 250-7201E P ANEL SET and CAST TRIM SET 1. Remove contents from box being careful not to scratch or damage cast trim pieces. 2. Lay the panel set face down on protective covering to prevent scratching the painted surface. . Secure panel set together with screws provided. ? ...
-
Hearth and Home Technologies 4100I-GD-B - page 15
Page 15 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R BLOWER CORD LOCA TION & BLOWER CONTROL BOX WITH SWITCH Remove Bolt Remove Bolt Remove 4 screws, lift motor from housing This insert comes standard with a blower , installed at the factory with blower cord on right side of insert (as you face the unit). The blower cord can also be inst ...
-
Hearth and Home Technologies 4100I-GD-B - page 16
4100-I ACT WOOD INSERT Page 16 September 1, 2008 R 250-7201E ? ...
-
Hearth and Home Technologies 4100I-GD-B - page 17
Page 17 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R WOOD SELECTION AND STORAGE B urn only dry seasoned wood. Dry , well-seasoned wood will not only minimize the chance of creosote formation but will give you the most efcient heat output. Even dry wood contains at least 15% moisture by weight and should be burned hot enough to keep the c ...
-
Hearth and Home Technologies 4100I-GD-B - page 18
4100-I ACT WOOD INSERT Page 18 September 1, 2008 R 250-7201E 1 . Leave fan of f until your insert is hot and a good coal bed is established, approximately 0 minutes after fuel is lit. 2. The fan may be left on througho ...
-
Hearth and Home Technologies 4100I-GD-B - page 19
Page 19 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R Start-Up Air Control Primary Air Control OPEN - PUSH IN CLOSE - PULL OUT BURNING PROCESS In recent years there has been an increasing concern about air quality . Much of the blame for poor air quality has been placed on the burning of wood for home heating. ...
-
Hearth and Home Technologies 4100I-GD-B - page 20
4100-I ACT WOOD INSERT Page 20 September 1, 2008 R 250-7201E MAINTENANCE CARE AND CLEANING OF PLA TED SURF ACES IMPORT ANT : Y ou must clean all the ngerprints and oils from the plated surfaces before ring the insert for the rst time. Use warm soapy water and a soft rag, glass cleaner and a paper towel, or vinegar and a paper towel to remo ...
-
Hearth and Home Technologies 4100I-GD-B - page 21
Page 21 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R 2 " 2-1/4" 1 1 2 2 4 4 4 4 4 4 4 4 4 4 6 6 4 4 5 5 5 The rebox is lined with high quality rebrick which has excep - tional insulating properties. There is no need ...
-
Hearth and Home Technologies 4100I-GD-B - page 22
4100-I ACT WOOD INSERT Page 22 September 1, 2008 R 250-7201E EXPLODED VIEWS 14.0" 10.0" 21-1/2" Ceramic Blanket 1 2 3 4 5 6 7 8 9 10 1 1 12 13 14 15 16 18 17 20 19 Item Description Item Description Item Description 1 Ashcatcher 8 Bafe, Fiberboard 15 Flue T ab 2 Blower , 180 cfm ...
-
Hearth and Home Technologies 4100I-GD-B - page 23
Page 2 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R IMPORT ANT : THIS IS DA TED INFORMA TION. The most current information is located on the Quadra-Fire web site at www . . When ordering, supply serial and model numbers to ensure correct part. Service Parts and Accessories Item # Part Description A ...
-
Hearth and Home Technologies 4100I-GD-B - page 24
4100-I ACT WOOD INSERT Page 24 September 1, 2008 R 250-7201E 27 25 30 29 31 23 20 21 22 28 24 Item # Part Description Alphabetical Order Accessories Part No. Cast T rim Set, Matte Black, 5 pc 81 1-090 Panel Set Standard, 0-1/2” h x 44-/4” w (order cast trim separately) 81-2010 Panel Set, Larg ...
-
Hearth and Home Technologies 4100I-GD-B - page 25
Page 25 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R Date of Service Performed By Description of Service ...
-
Hearth and Home Technologies 4100I-GD-B - page 26
4100-I ACT WOOD INSERT Page 26 September 1, 2008 R 250-7201E W arranty Policy Hearth & Home T echnologies (“HHT”) and its respective brands extends the following warranty for HHT gas, wood, pellet and electric ...
-
Hearth and Home Technologies 4100I-GD-B - page 27
Page 27 September 1, 2008 4100-I ACT WOOD INSERT 250-7201E R HHT’s obligation under this warranty does not extend to damages resulting from: (1) installation, operation or maintenance of the appliance not in accordance with the installation instructions; operating instructions and the list - ing agent identication label furnished with t ...
-
Hearth and Home Technologies 4100I-GD-B - page 28
R September 1, 2008 Page 28 • Do NOT discard this manual. • Important operating and maintenance instructions included. • Read, understand and follow these instruci- tons for safe installation and operation. • Leave this manual with party responsible for use and operation. CAUTION This product may be covered by one or more of the following p ...
¿Tienes una pregunta acerca de Hearth and Home Technologies 4100I-GD-B?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Hearth and Home Technologies 4100I-GD-B, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Hearth and Home Technologies 4100I-GD-B probablemente compartirá una forma de solucionarlo.