-
Cabletron Systems 9W111-08 - page 1
MMAC-Plus ™ 9W111-08 Eight Port WAN Router User’s Guide ...
-
Cabletron Systems 9W111-08 - page 2
...
-
Cabletron Systems 9W111-08 - page 3
i Notice Notice Cabletron Systems r eserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletr on Systems to determine whether any such changes have been made. The hardwar e, firmware, or softwar e described in this manual is subject to ...
-
Cabletron Systems 9W111-08 - page 4
ii Notice FCC Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference r eceived, including interference that may cause undesir ed operation. NOTE: This equipment has been tested and found to c ...
-
Cabletron Systems 9W111-08 - page 5
iii Notice DOC Notice This digital apparatus does not exceed the Class A limits for radio noise emissions fr om digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le présent appareil numérique n’émet pas de br uits radioélectriques dépassant les limites applicables aux appareils num? ...
-
Cabletron Systems 9W111-08 - page 6
iv Notice ...
-
Cabletron Systems 9W111-08 - page 7
v Contents Chapter 1 Intr oduction Features........................................................................................................................... 1-1 Related Manuals ............................................................................................................ 1-4 Getting Help ..................................... ...
-
Cabletron Systems 9W111-08 - page 8
Contents vi ...
-
Cabletron Systems 9W111-08 - page 9
1-1 Chapter 1 Intr oduction The 9W1 1 1-08 W AN Router module, shown in Figure 1-1, is a eight port W ide Area Net r outer . Up to eight front panel network connections can be made to this module and they can be routed to any other port and to any other MMAC-Plus module via the FNB bus. Features Processor The 9W1 1 1-08 is equipped with an advanced ...
-
Cabletron Systems 9W111-08 - page 10
Introduction 1-2 Management Information Base (MIB) Support All concentrator modules provide MIB support including the following: • IETF FDDI MIB • IETF MIB II LANVIEW LEDs The 9W1 1 1-08 uses LANVIEW: the Cabletron Systems built-in visual diagnostic and status monitoring system. W ith LANVIEW LEDs, you can quickly identify the device, port, and ...
-
Cabletron Systems 9W111-08 - page 11
1-3 F eatures Figure 1-1. The 9W111-08 Module MMAC PLUS ...
-
Cabletron Systems 9W111-08 - page 12
Introduction 1-4 Related Manuals The manuals listed below should be used to supplement the procedur es and technical data contained in this manual. MMAC-Plus Installation Guide MMAC-Plus Operations Guide MMAC-Plus 9C300-1 Environmental Module User ’ s Guide MMAC-Plus 9C214-1 AC Power Supply User ’ s Guide Cisco Systems R4500 manuals - CRM-DOC o ...
-
Cabletron Systems 9W111-08 - page 13
2-1 Chapter 2 Installing the MMA C-Plus Module The MMAC-Plus module may be installed into any of the 14 slots that are available. T o install, follow the steps below: 1. Remove the blank panel, covering the slot that the module is being mounted in. All other slots must be covered, if modules ar e not being installed, to ensure pr oper airflow and ...
-
Cabletron Systems 9W111-08 - page 14
Installing the MMA C-Plus Module 2-2 Figure 2-1. Installing the MMAC-Plus Module 7 FLNK 8 FLNK FLNK 10 FLNK INS 11 FLNK INS 12 RX TX RX TX RX Circuit Card Card Guides Metal Back-Panel Jack for ESD wrist strap Plastic T abs W arning: Ensure that the circuit card is between the card guides . Lock do wn the top and bottom plastic tabs at the same time ...
-
Cabletron Systems 9W111-08 - page 15
2-3 The Reset Switch The Reset Switch The Reset switch is located on the front panel, under the top plastic tab, as shown in Figure 2-2. It serves two functions: • Pressing the Reset switch twice within thr ee seconds causes the processor to reset. • Pressing and holding the switch on for thr ee or more seconds causes the module to shutdown. Pr ...
-
Cabletron Systems 9W111-08 - page 16
Installing the MMA C-Plus Module 2-4 Setting the FNB Switch The 9W1 1 1-08 module can attach to ether FNB-1 or FNB-2. Figure 2-3 shows the location of the FNB switch, SW201. When this switch is up (toward the top of the module) the 9W1 1 1-08 attaches to FNB-2. When down, it attaches to FNB-1. Figure 2-3. Location of the FNB Switch Local Management ...
-
Cabletron Systems 9W111-08 - page 17
2-5 Local Management Console T able 2-1. T erminal Setup Requirements Menu Function Selection Display Columns 80 Columns Setup: Controls Interpret Controls Auto Wrap No Auto Wrap Text Cursor Cursor General Mode 7 Bit Control Setup: Cursor Keys Normal Cursor Keys Communications Setup: Transmit Transmit = 9600 Receive Receive = Transmit XOFF any opti ...
-
Cabletron Systems 9W111-08 - page 18
Installing the MMA C-Plus Module 2-6 An RJ-45 connector provides a COM interface to the management terminal. Figure 2-4 shows the pinouts. Figure 2-4. Console Cable Pinouts Connect the console to the module as follows: 1. Attach the male RJ-45 connector to the COM port of the 9W1 1 1-08. 2. Attach the female end (25-pin or 9-pin, as applicable) to ...
-
Cabletron Systems 9W111-08 - page 19
3-1 Chapter 3 Operation The 9W1 1 1-08 W AN Router module is a eight port W ide Ar ea Net router . Up to eight front panel network connections can be made to this module and they can be routed to any other port and to any other MMAC-Plus module via the FNB bus. Figure 3-1. 9W111-08 Block Diagram CPU WAN port WAN port FNB-1 or FNB-2 System Diagnosti ...
-
Cabletron Systems 9W111-08 - page 20
Operation 3-2 Fle xible Netw ork Bus (FNB) The FNB consists of two dual FDDI networks, the FNB-1 and FNB-2, providing up to 400 Mbps of data bandwidth. These FDDI networks are 100% ANSI FDDI- compliant, supporting SMT (version 7.3), MAC, PHY , and PMD standards. This allows the FNB to traverse multiple MMAC-Plus hubs, or connect to any ANSI FDDI-co ...
-
Cabletron Systems 9W111-08 - page 21
3-3 FNB Interf ace FNB Interface MMAC-Plus modules are designed with one of two attachment policies. One allows dual attachment of a module to either FNB-1 or FNB-2; the second allows dual attachment to both FNB-1 and FNB-2. The 9W1 1 1-08 has one dual attachment to the FNB backplane, connecting to either FNB-1 or FNB-2. The module can insert into ...
-
Cabletron Systems 9W111-08 - page 22
Operation 3-4 ...
-
Cabletron Systems 9W111-08 - page 23
4-1 Chapter 4 LANVIEW LEDs The front panel LANVIEW LEDs, shown in Figur e 4-1, indicate the status of the module and may be used as an aid in troubleshooting. Figure 4-1. LANVIEW LEDs System Status FNB T ransmit FNB Receive W AN Status W AN Activity ...
-
Cabletron Systems 9W111-08 - page 24
LANVIEW LEDs 4-2 The functions of the System Management Bus (SMB) and CPU LEDs are listed in T able 4-1. * At least one W AN port in both groups 0-3 and 4-7 ar e down. The function of the FNB Receive LED is listed in T able 4-2. The function of the FNB T ransmit LED is listed in T able 4-3. T able 4-1. SMB and CPU LEDs LED Color State Description G ...
-
Cabletron Systems 9W111-08 - page 25
4-3 LANVIEW LEDs The functions of the W AN Status LEDs are listed in T able 4-4. The function of the W AN Activity LEDs are listed in T able 4-5. T able 4-4. W AN Status LEDs LED Color State Green Connection, T ransmit clock active, Receive clock active, No Loop Mode detected Y ellow Connection, T ransmit clock active, Receive clock active, Loop Mo ...
-
Cabletron Systems 9W111-08 - page 26
LANVIEW LEDs 4-4 ...
-
Cabletron Systems 9W111-08 - page 27
5-1 Chapter 5 Specifications Safety This equipment meets the following safety requir ements: • UL 1950 • CSA C22.2 No. 950 • EN 60950 • IEC 950 • EMI Requirements of FCC Part 15 Class A • EN 55022 Class A • VCCI Class I • EMC the following requir ements: EN 50082-1 IEC 801-2 ESD IEC 801-3 Radiated susceptibility IEC 801-4 EFT Servi ...
-
Cabletron Systems 9W111-08 - page 28
Specifications 5-2 Ph ysical Dimensions 35.0 D x 44.0 H x 3.0 W centimeters (13.8 D x 17.4 H x 1.2 W inches) W eight Unit: 1.36 kg. (3 lb) Shipping: 1.81 kg. (4 lb) En vironment Operating T emperature 5 to 40 ° C Storage T emperature -30 to 90 ° C Relative Humidity 5% to 95% non-condensing ...
¿Tienes una pregunta acerca de Cabletron Systems 9W111-08?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Cabletron Systems 9W111-08, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Cabletron Systems 9W111-08 probablemente compartirá una forma de solucionarlo.