-
Uniden UH-042XR - page 1
UH-042XR Operating Guide ...
-
Uniden UH-042XR - page 2
➤ Do not operate the transmitter of any radio equipment unless all the Radio Frequency (RF) connectors are secured and any open connectors are properly terminated. ➤ Do not operate the transmitter of any radio equipment near electrical blasting caps or in an explosive atmosphere. ➤ Do not let children operate any transmitter -equipped radio e ...
-
Uniden UH-042XR - page 3
Introduction Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 T echnical Support & Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Included in your UH-042XR Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Getting Started Battery Installatio ...
-
Uniden UH-042XR - page 4
The UH-042XR is a portable two-way UHF-CB radio. It is compact, rugged and fits easily in your hand. This hand held UHF radio will give you consistent, outstanding performance in virtually all conditions and situations. T o ensure that you get the most from the UH-042XR ’s features, please read this operating guide carefully before using the unit ...
-
Uniden UH-042XR - page 5
TECHNICAL SUPPORT AND SERVICE Should you find it desirable or necessary to service your UH-042XR , we suggest you contact the Uniden dealer where you purchased your radio. Y our dealer will be able to assist you with the complete service information. If you require service that is within the terms of your warranty , you should present a copy of you ...
-
Uniden UH-042XR - page 6
INCLUDED IN YOUR UH-042XR P ACKAGE 3 Note: If any of these items are missing from the box, contact your Uniden Dealer . Wrist Strap Belt Clip Operating Guide Product Registration Card and other printed materials UH-042XR ...
-
Uniden UH-042XR - page 7
BA TTERY INST ALLA TION Y our UH042XR radio uses 3 AA ALKALINE batteries for power . Please refer to page 18 should you wish to use rechargeable batteries. T o install the batteries: 1. Make sure your radio is off. 2. Release the battery cover clip, then remove the battery cover . 3. Insert 3 AA ALKALINE batteries according to the polarity symbols ...
-
Uniden UH-042XR - page 8
LOW BA TTERY ALERT The LCD on your radio shows a battery meter in the lower right corner . icon indicates a fully powered unit. As the batteries lose power , will flash. When the batteries in the unit are low , the unit will go into a Battery Low/Sleep Mode. The Scan Mode, T ransmit, T ransmit Call T one Mode are disabled. Replace the batteries imm ...
-
Uniden UH-042XR - page 9
➤ When you press any key (except PTT), a short tone sounds. ➤ See the Controls and Indicators page at the back of this operating guide for button and key operations. POWER ON/OFF T o turn the unit ON , rotate the [ON/OFF VOL] clockwise until a “click” is heard. A channel number and battery level should appear on the display . T o turn the u ...
-
Uniden UH-042XR - page 10
SELECTING A CHANNEL Press [ ▲ ] or [ ▼ ] to select the desired channel. Note: If you press and hold the [ ▲ ] or [ ▼ ], channel numbers will scroll rapidly . TO TRANSMIT AND RECEIVE The UH-042XR uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed at the end of this manual ...
-
Uniden UH-042XR - page 11
TO OPERA TE IN DUPLEX MODE Eg. CH01 is being used in your area for repeater purpose. Press [DUP] momentarily . The DUP icon appears. Press [DUP] again to deactivate the duplex operation. UH-042XR will return to simplex operation. DUP icon disappears. SCANNING The UH-042XR has two types of scanning; Open Scanning (OS) and Group Scanning (GS), giving ...
-
Uniden UH-042XR - page 12
Example: CH40 becomes active If the received signal ceases, the unit will wait for at least 3 seconds for the signal to return, otherwise scanning resumes. T o skip the active channel, press [MEM] momentarily . Scanning resumes. T o deactivate SCAN, press the [SCAN] or [PTT] . Note: 1. If SCAN is deactivated while in an active channel, the UH-042XR ...
-
Uniden UH-042XR - page 13
PRIORITY CHANNEL The Priority Channel feature allows user to monitor one of 40 channels in the UH-042XR , monitoring it every 1.5secs during Group Scanning . Choosing a Priority Channel The starting channel, when Group Scanning is initiated, is always the Priority Channel . T o change the priority channel setting while scanning, (eg. PRI Channel is ...
-
Uniden UH-042XR - page 14
CONTINUOUS TONE CODED SQUELCH SYSTEM (CTCSS) CTCSS is a feature that allows a group to talk to each other without hearing other users on the same channel. NOTE : Uniden discourages the use of CTCSS feature until the Australian Communications Authority (ACA) grants the use of CTCSS on CB frequencies. Programming CTCSS Code 1. Select a desired channe ...
-
Uniden UH-042XR - page 15
CTCSS Scan Operation 1. Press [SCAN] to start scanning (GS or OS) mode. 2. During scanning if a signal is sensed on a CTCSS CH, the UH-042XR stops for about 400msecs (decode time) to decode the CTCSS code. If there is no code or the receive code does not match the one programmed on the unit, the unit resumes scanning. On the example below only radi ...
-
Uniden UH-042XR - page 16
BUIL T -IN VOICE ACTIV A TED CIRCUIT (VOX) VOX feature enables user to transmit automatically by speaking on the microphone of the VOX headset (not supplied) without pressing the PTT switch. NOTE: VOX feature will not work without the Headset Microphone. Built in [PTT] of UH-042XR is temporarily disabled, however accidental pressing of [PTT] will c ...
-
Uniden UH-042XR - page 17
T o De-activate VOX 1. T urn OFF UH-042XR . 2. Remove VOX Headset from UH-042XR . 3. Press and hold [VOX] while turning the radio ON. “ VOX ” icon disappears. 4. UH-042XR returns to PTT operation. Note: T urning ON the radio without removing the VOX headset will cause the unit to transmit continuously . DROP-OUT DELA Y While scanning, the UH-04 ...
-
Uniden UH-042XR - page 18
BUSY CHANNEL LOCK-OUT(BCL) This feature prevents accidental transmission on a busy channel. This is recommended on channels where CTCSS is being used. If the channel is “ active ” and the signal is coming from a non or different CTCSS code user the BCL feature will prevent you from transmitting. T o activate BCL Press and hold [BCL] for 1.5 sec ...
-
Uniden UH-042XR - page 19
BACK LIGHT The Liquid Crystal Display (LCD) is backlit for easy viewing at night or in low light situations. The back lighting automatically switches ON every time a key (except PTT) is pressed. It turns OFF 5secs after the last key is pressed. KEYP AD LOCK T o prevent accidental entries, you can lock the keypad. Press and hold the [LOCK] button fo ...
-
Uniden UH-042XR - page 20
BA TTERY LEVEL DISPLA Y The icon in the bottom right hand corner of the screen indicates the UH- 042XR current battery voltage level at all times. The battery level is displayed in 3 levels: LEVEL 3 Battery 100% full LEVEL 1 Battery approx 30% capacity LEVEL 2 Battery approx 70% capacity Almost Empty Note: When [PTT] SW is pressed at Level Empty , ...
-
Uniden UH-042XR - page 21
CHARGING BA TTERIES Warning Notice! Use only the AAD042S optional power adaptor if rechargeable batteries will be used in the UH042XR. • T urn the UH042XR [ ON/OFF VOL] knob off and connect the AC adaptor plug to the mic jack. • Battery charging times vary . A longer time is required to charge higher capacity batteries. • Disconnect the AC ad ...
-
Uniden UH-042XR - page 22
* Emergency calling for both simplex and duplex operation Please do not use this channel in non-emergency cases. # Back-up Emergency Channel Ch. Freq. Usage Ch. Freq. Usage 01 476.425 Simplex/Duplex 21 476.925 Simplex 02 476.450 Simplex/Duplex 22 476.950 Simplex 03 476.475 Simplex/Duplex 23 476.975 Simplex 04 476.500 Simplex/Duplex 24 477.000 Simpl ...
-
Uniden UH-042XR - page 23
• Speaker Microphone (SM-050) • AC Adaptor (AAD-042S) • VOX Headset (VM-052) • Standard Headset (HM-050) General Channels T ransmit 40 (with Duplex Channel Support) Receive 40 Oper . T emp. 0 ˚ C - +55 ˚ C Antenna Fixed Microphone Built-in Electret type TECHNICAL SPECIFICA TIONS OPTIONAL ACCESSORIES Code No. Freq. (Hz) Code No. Freq. (Hz) ...
-
Uniden UH-042XR - page 24
Display Liquid Crystal Display Speaker 36mm Round, 8 Ω Power Source AA Size Battery x 3pcs Size (with antenna) 180(H) x 62(W) x 32(D)mm Weight 150g (with Antenna & without Battery) Operating T ime at 17 hrs (1.2V , 600mAH Ni-Cd Batteries) Duty Cycle 25 hrs (1.2V , 1000mAH Ni-Cd Batteries) 32 hrs (1.25V , 1300mAH Ni-MH Batteries) 38 hrs (1.5V ...
-
Uniden UH-042XR - page 25
UNIDEN UH-042XR UHF CB RADIO Limited One Y ear Warranty Note: Please keep your sales docket as it provides evidence of warranty . Warrantor: Uniden Australia Pty Limited ACN 001 865 498 Uniden New Zealand Limited Elements of Warranty: Uniden warrants to the original retail owner for the duration of this warranty , its UH-042XR UHF CB T ransceiver R ...
-
Uniden UH-042XR - page 26
os/gs mem bcl ctcss vox dup scan 5 4 13 14 15 6 7 8 9 3 2 1 10 11 12 CONTROLS & INDICA TORS 23 ...
-
Uniden UH-042XR - page 27
1. Speaker Jack 2. Microphone Jack 3. On/Off V olume 4. LCD Display 5. Up Button 6. Down Button 7. Microphone 8. Speaker 9. Scan and VOX Button 10. Open/Group Scan and CTCSS Button 11. Memory/BCL Button 12. Duplex and Key Lock On/Off Button 13. PTT (Push-to-talk) Button 14. Monitor Switch 15. Belt Clip A. T ransmit B. Channel Numbers C. Key Lock D. ...
-
Uniden UH-042XR - page 28
© 2000 Uniden Australia Pty Limited/Uniden New Zealand Limited UTZZ01877ZZ ...
¿Tienes una pregunta acerca de Uniden UH-042XR?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Uniden UH-042XR, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Uniden UH-042XR probablemente compartirá una forma de solucionarlo.