-
Teac 36XX - page 1
Co v er s All 35xx and 36xx Series R emote Star ter s -The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle. - CARBON MONOXIDE - Neve ...
-
Teac 36XX - page 2
T a ble of Contents INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Page 2 T able of Content s Page 2 Pre-Inst allation Page 3 Components Feature List Pre-Installation Inst allation Procedures Page 4 Wiring Diagrams Page 5-6 Wire Description Page 7-8 6 Pin Connector 14 Pin Connector Auxiliary Connectors Jumper Positions Quick S t art Inst all Page 9 ...
-
Teac 36XX - page 3
R ecommended Pr e-Installation Procedur es F ea ture List - Control module - 2way & 1way remote transmitter - Antenna with built in - 6 pin main harness Program Button - 14 pin harness - 4 pin harness - 2 pin Harness - 3 pin keyless entry harness - T emperature Sensor (L T Models) - Hood pin safety switch - Installation and Owner Manuals Remote ...
-
Teac 36XX - page 4
R ecommended Installation Procedur es Under Hood Connections - Route the hood pin and tach wire through the firewall into the engine compartment. If possible route the wires through a factory rubber grommet. If drilling a hole through the firewall, BE CAREFUL . Always check for obstructions on both sides of the firewall. After drilling, use a snap ...
-
Teac 36XX - page 5
REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Page 5 W iring Diag r am- 35xx Series T emperature Sensor Input (L T Series) S tarter Output (+) 30amp Output (+) 30amp Output (+) 30amp Input (+) 30amp Input (+) 30amp Output (-)500ma Output (-)500ma Output (-)500ma Output (-)500ma Output (-)500ma Output Negative Input Negative Input Positive Input Pos ...
-
Teac 36XX - page 6
Page 6 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Module Side V iew J umper Selections 12 3 The jumpers control the output from the White wire on the 6- pin harness. This is a 30amp relayed output . T o change the output of the wire access the jumpers by sliding the plastic cover of f the top of the case. Move the jumper to one of the following ...
-
Teac 36XX - page 7
Page 7 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL 6-pin Description T est For Wire 1-Y ellow 30amp S tarter Output This wire will test 0volts in of f, accessory and in the ignition position.12volts during st art only . 2-Green 30amp Heat/Acc Output This wire will test 0volts in the of f position 12- 14volts in the accessory and run positions and ...
-
Teac 36XX - page 8
Page 8 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER 14 Pin Connector - Continued F r om Pr e vious Page 1-Green Door Lock Door Lock Output - Programmable Menu 1 Setting 3. 2-Red 12vlt Output Output For Door Lock Module Only! 3-Blue Door Unlock Door Unlock Output - Programmable Menu 1 Setting 3. 4-Pink 2nd Unlock Output when Unlock button is press ...
-
Teac 36XX - page 9
Page 9 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Step 1 - Connect All Of the F ollowing W ir es 6 Pin P ow er Connector Y ellow 30amp S t arter Output 12volts during st art position only . Green 30amp Heater Output 12volt s in the accessory position off during start and 12volts during run. Red 30amp Power Input Constant 12volt power at ignition ...
-
Teac 36XX - page 10
Page 10 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Manual T r ansmission “M” Models Never install an automatic transmission remote starter into a manual transmission vehicle!!! Doing so may result in serious injury or death. Do not install remote starters in convertible vehicles! The following wires must be connected In addition to the basic ...
-
Teac 36XX - page 11
Page 1 1 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Auto T ac h Lear n 1) T urn the ignition key to the “ON” position. (The park light s will turn on*). 2) S tart the vehicle with the key , The LEDs on the antenna will turn on if a proper t ach signal is detected**, then after 30-35 seconds the p ark lights will flash and the horn (Optional) ...
-
Teac 36XX - page 12
Page 12 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Impor tant T ac h Notes T ach Learning the remote st arter is one of the most important step s in the installation process. Do not tach learn vehicle while the engine is in high idle. T o ensure the best possible tach setting, ensure that the vehicle is at low idle/ normal operating RPM. V ehic ...
-
Teac 36XX - page 13
Page 13 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Entering Pr og r am Mode 1) With the ignition in the OFF position, turn the ignition key from “Of f” to “On” 3 times, ON-OFF-ON-OFF-ON within three seconds. (Leave the key in the ON position) 2) Press and release the Program Button located on the antenna. The park light s will flash and ...
-
Teac 36XX - page 14
Page 14 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER System R eset Quic k View Pr og r amming * See the following p ages for more det ailed programming instructions. Menu 1 -Press Lock 1 Flash 2 Flashes 3 Flashes 1 Ignition Lock Enabled Lock Only Disabled 2 Horn Honk T ype 1 T ype 2 All Honks 3 Lock&Unlock Double Unlock 3 second .75 second 4 U ...
-
Teac 36XX - page 15
Page 15 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Lock Button Setting 1 Ignition Auto Lock 1) Ignition Lock & Unlock Enable 1 Flash/Honk Doors Lock/Unlock with Ignition key . 2) Ignition Lock Only 2 Flashes/Honks Doors Lock when ignition is turned ON only . *3) Ignition Auto ...
-
Teac 36XX - page 16
Page 16 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Menu 2- Additional Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Unlock Setting 1 Secure V alet Mode - Length of time required to set the system into Service Mode 1) Secure V alet 1 Flash/Honk Hold the Program Button for 15 seconds *2) Normal V alet 2 Flashes/Honks ...
-
Teac 36XX - page 17
Page 17 REMOTE V EHICLE S T ARTER INST ALLATION MANUAL Menu 3- Star ter Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press S t art Button Setting 1 S pecial Door Lock/Unlock Operations (Factory Alarm Rearm) . 1) T ype 1 1 Flash/Honk Unlock pulse before start. Lock pulse af ter start and on shut down. 2) T ype 2 2 Flashes/Ho ...
-
Teac 36XX - page 18
Page 18 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Menu 3- Star ter Settings - Continued F r om Pr e vious Page Setting 5 Maximum Crank T ime 1) 10 Seconds 1 Flash/Honk 10 sec max time that the st arter will st ay engaged. 2) 3 Seconds 2 Flashes/Honks 3 sec max time that the st arter will st ay engaged. *3) 5 Seconds 3 Flashes/Honks 5 sec max t ...
-
Teac 36XX - page 19
Page 19 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Menu 4- T ach Settings Setting 1 Auto T ac h Lear n. 1) Perform a System Reset. See p age 15. 2) T urn the ignition key on. (Park lights will turn on). 3) S tart the vehicle, the LEDs on the antenna will come on when a proper tach signal is detected*. 4) After approximately 30-35 seconds the p a ...
-
Teac 36XX - page 20
Page 20 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER A TTENTION: TO A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced. It is the sole responsibility of the vehicle’ s owner to place ...
-
Teac 36XX - page 21
Page 21 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL T r ansmitter Pr og r amming Ste p 1 - Within 3 seconds turn the ignition ON-OFF-ON-OFF-ON - Leaving Key ON Ste p 2 - Press and hold the Program Button - The park light s will turn ON and the siren will chirp once.* Continue to hold the Program Button , the park light s will turn off and the sir ...
-
Teac 36XX - page 22
87 86 85 87a 30 87 86 85 87a 30 Lock Un lock V ehicle Lock/Unlock Switch T o Control Relay or Actuator Green Fused +12V Blue Ground Ne gativ e T ype Door Locks 250ma Ne gativ e Door Loc ks (Mor e T han 250ma) P ositiv e Type Door Loc ks Note: When installing relays always use a fused power source. Blue Green Lock Un lock V ehicle Lock/Unlock Switch ...
-
Teac 36XX - page 23
87 86 85 87a 30 87 86 85 87a 30 Blue Green Lock Un lock Ve hicle Lock/Unlock Switch T o Actuator Fused +12V x x Cut Cut 87 86 85 87a 30 Ground DIA GNOSTICS 13 87 86 85 87a 30 87 86 85 87a 30 Blue Green Lock Un lock T o V acuum Pump Fused +12V x Cut Ground Page 23 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL 5 W ir e / R e v er se Polarity T ype Do ...
-
Teac 36XX - page 24
DIA GNOSTICS If the remote starter does not activate when the st art button is pressed the park light s will flash a diagnostic to indicate what shutdown input has been triggered. For example when the start button is pressed the p ark lights flash 3 times slowly . Looking at the chart below this would indicate that the system is in Service Mode, si ...
¿Tienes una pregunta acerca de Teac 36XX?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Teac 36XX, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Teac 36XX probablemente compartirá una forma de solucionarlo.