-
Maretron IPG100 - page 1
Revision 1.2 Page i ® ® IPG100 Internet Protocol Gateway User’s Manual Revision 1.2 Copyright © 2012 Maretron, LLP All Rights Reserved Maretron, LLP 9014 N. 23 rd Ave #10 Phoenix, AZ 85021 http://www.maretron.com Maretron Manual Part #: M003004 ...
-
Maretron IPG100 - page 2
IPG100 User’s Manual Page ii Revision 1.2 Revision History Revision Description 1.0 Original document 1.1 Corrected current utilization figures 1.2 Added documentation on Cloud Services ...
-
Maretron IPG100 - page 3
Revision 1.2 Page iii ® ® Table of Contents 1 General ....................................................................................................................... ......... 1 1.1 Introduc tion .................................................................................................................. .. 1 1.2 ...
-
Maretron IPG100 - page 4
IPG100 User’s Manual Page iv Revision 1.2 Table of Figures Figure 1 – IPG100 Ne twork Diagr am ......................................................................................... 1 Figure 2 – LAN Client/Server Arch itecture Exampl e with U SB100 ............................................ 3 Figure 3 – WAN Client/Server Archit ...
-
Maretron IPG100 - page 5
® ® 1 General 1.1 Introduction Congratulations on your purchase of the Mare tron Internet Protocol Gateway (IPG100). Maretron has designed and built your gateway to the highest standards for years of reliable, dependable, and accurate service. The Internet Protocol Gateway (IPG100) lets you connect Maretron black boxes (MBB100’s), Maretron touc ...
-
Maretron IPG100 - page 6
IPG100 User’s Manual Page 2 Revision 1.2 The Maretron IPG100 is demands of the marine .2 Firmware Revision 00 firmware revision 1.0.0. .3 Features 00 has the following features: 2KServer ® software s you to easily connect to your boat’s er ories for the IPG100: 4' .5 Quick Install G100 involves the fo llowing steps. Please re fer to the i ...
-
Maretron IPG100 - page 7
Revision 1.2 Page 3 ® ® 1.7 General Concepts 1.7.1 Client/Server Architecture The N2KView ® Vessel Monitoring and Control System is based on a client/server architecture. In this context, a server is defined as a component that provides services over a network and a client is defined as a station that requests and uses those services. Within the ...
-
Maretron IPG100 - page 8
IPG100 User’s Manual Page 4 Revision 1.2 Figure 2 by adding an external internet access point he network as shown in Figure 4 – LAN Client/Server Ar chitecture Example with IPG100 Figure 4 sho work and a Figure 3 – WAN Client/Server Archit ecture Example through the Internet Figure 3 extends the example shown in across a Wide Area Network (WA ...
-
Maretron IPG100 - page 9
® ® Figure 5 d stations in e N2KView ® system is the TCP/IP protocol. This protocol is used by the Worl d Wide Web, FTP (File T lar most opera is configur ddress computers are on the ame LAN, you may skip this section. Figure 5 – Single Client Connection to IPG100 shows an example of a single client connection to an IPG100. A DSM800 (or a comp ...
-
Maretron IPG100 - page 10
IPG100 User’s Manual Page 6 Revision 1.2 x, 10.x. via network from an N2KV uter to allow f the with your router for details. s Translation) d to rwar 2KV e If you request a Static IP Address from your ISP when you set up your Internet connection, the ’t make this request, your ISP will assign r lose your Internet connection, your Dynamic IP ddr ...
-
Maretron IPG100 - page 11
® ® If you wish to connect to an N2KServer ® from outside your vessel’s LAN via an Internet connection, you have two choices. First, you c an request a static IP address from the ISP for your vessel; secondly, you ma y register your N2KServer ® ’s IP address with a “dynamic DNS service”, such as the ones offered freely by www.dyndns.org ...
-
Maretron IPG100 - page 12
IPG100 User’s Manual Page 8 Revision 1.2 lease contact Maretron. lease consider the following wh en choosing a mounting location. he ce k, om it. 2.3 Mounting the IPG100 tic • 1 – IPG100 Internet Protocol Gateway • 1 – Parts Bag containing 4 Stainless Steel Mounting Screws • 1 – IPG100 User’s Manual • 1 – Warranty Registration C ...
-
Maretron IPG100 - page 13
Revision 1.2 Page 9 ® ® 2.4 Connecting the IPG100 2.4.1 NMEA 2000 Connec ® tion The NMEA 2000 ® connector can be found on the side of the enclosure. The NMEA 2000 ® onnector is a round five pin male connector (see Figure 7 ). You connect the IPG100 to an EA 2000 ® compatible able) by connecting the female end of the c able to the IPG100 (note ...
-
Maretron IPG100 - page 14
IPG100 User’s Manual Page 10 Revision 1.2 NOTE: icense Keys. The “old” key has a plastic case and carri es a l. The “new” key has a gray metal case and ha s the Maretro n you previously purchased, please contact Mare tron sales to upgrade i t to a “new” key so that you can use it with the IPG100. There are two types of Hardware L “S ...
-
Maretron IPG100 - page 15
® ® 3.1.2 Installation Description This entry al enter any information you like here, such as the dat e the unit was installed, or the location in which it was installed, for later refer ence. Tools such as Maretron N2KAnalyzer ® allow you to view these values later. The default in stallation description is blank text. 3.1.3 Restore Factory Defa ...
-
Maretron IPG100 - page 16
IPG100 User’s Manual Page 12 Revision 1.2 .6 Configuring IP Address tocol) addr ss used by the IPG100. You will need to sk ters on the s, the first three pa rts of the IP address define the network (i.e., ork mu st have the same values), and the last part defines the alue mon value is 255.255.255.0. you do not need to conf igure this parameter. I ...
-
Maretron IPG100 - page 17
Revision 1.2 Page 13 ® ® 5 Troubleshooting If you notice unexpected operation of the Mare tron IPG100, follow the troubleshoo procedures in this section to remedy simple problems. ting Symptom Troubleshooting Procedure N2KView ® Clients cannot 1. If you have programmed the IPG100 is an active DHCP ser successfully connect to the IPG100 2. Ensure ...
-
Maretron IPG100 - page 18
IPG100 User’s Manual Page 14 Revision 1.2 ations 6 Technical Specific Specifications Parameter Value Comment NMEA 2000 ® Connector DeviceNet Micro-C Industry Standard Waterproof NMEA 2000 ® Isolation Opto-Isolated idge No Elec trical Connection Across Br USB Standard USB 1.1 USB Connector USB Type A Industry Standar d Waterproof, for Connection ...
-
Maretron IPG100 - page 19
Revision 1.2 Page 15 ® ® Environmental Parameter Value IEC 60945 Classification Exposed Degree of Protection IP67 Operating Temperature -25°C to 55°C Storage Temperature -40°C to 70°C Relative Humidity 93%RH @40° per IEC60945-8.2 Vibration 2-13.2Hz @ ±1mm, 13.2- 100 Hz @ 7m/s 2 per IEC 60945-8.7 Rain and Spray 12.5mm Nozzle 0min per IEC 609 ...
-
Maretron IPG100 - page 20
IPG100 User’s Manual Page 16 Revision 1.2 nical support for Maretron produc ts, you can reach us in any of the following Telephone: 1-866-550-9100 7 Technical Support If you require tech ways: Fax: 1-602-861-1777 E-mail: support@maretron.com World Wide Web: http://www.maretron.com Mail: Maretron, LLP Attn: Technical Support 9014 N. 23 rd Ave Suit ...
-
Maretron IPG100 - page 21
Revision 1.2 Page 17 ® ® 8 Installation Templa Please check the dimensions befor te e using the fo llowing diagram as a template for drilling the Figure 9 – Mounting Surface Template mounting holes because the printing proc ess may have distorted the dimensions. 3.9” (99.1mm) 4.5” (114.3mm) ...
-
Maretron IPG100 - page 22
IPG100 User’s Manual Page 18 Revision 1.2 ted Warranty years 9 Maretron (2 Year) Limi Maretron warrants the IPG100 to be fre e from defects in materials and workmanship for t wo (2) from the retron’s satisfaction to fail to meet the above lim ited warr s shall be repaired or repla ced at Maretron’s option. Purchaser's ex clusive remedy a ...
¿Tienes una pregunta acerca de Maretron IPG100?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Maretron IPG100, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Maretron IPG100 probablemente compartirá una forma de solucionarlo.