-
Kenwood KDC-3657SD - page 1
GET0857-004A (EF) © 2012 JVC KENWOOD Corporation KDC-4757SD KDC-3657SD CD-RECEIVER INSTRUCTION MANUAL CD-RECEIVER BEDIENUNGSANLEITUNG CD-PECИBEP ИHCTPУKЦИЯ ПO ЭKCПЛУA T AЦИИ CD-РЕСІВЕР ІНСТРУКЦІЯ З ЕКСПЛУ А Т АЦІЇ Изделие изготовлено во Франции Cover_KDC-4757SD_004A_f.indd 1 Co ...
-
Kenwood KDC-3657SD - page 2
i Declaration of Conformity with regard to the EMC Directive 2004/108/EC Manufacturer: JVC KENWOOD Corporation 3-12, Moriya-cho, Kanagawa-ku, Yokohama-shi, Kanagawa, 221-0022, Japan EU Representative’s: Kenwood Electronics Europe BV Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands Konformitätserklärung in Bezug auf die EMC-Vorschrift 2004/1 ...
-
Kenwood KDC-3657SD - page 3
ii The marking of products using lasers The label is attached to the chassis/case and says that the component uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit. Kennzeichnung von Geräten mit Laser-Abtastern Da ...
-
Kenwood KDC-3657SD - page 4
2 CONTENTS BEFORE USE Warning Do not operate any function that takes your attention away from safe driving. Caution Volume setting: • Adjust the volume so that you can hear sounds outside the car to prevent accident. • Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of the output level. Gene ...
-
Kenwood KDC-3657SD - page 5
3 KDC - 4757SD KDC - 3657SD BASICS To Do this (on the faceplate) Turn on the power Press L SRC . • Press and hold to turn off the power. Adjust the volume Turn the volume knob. Select a source Press L SRC repeatedly. Change the display information Press SCRL DISP repeatedly. • Press and hold to scroll the current display information. Faceplate ...
-
Kenwood KDC-3657SD - page 6
4 GETTING STARTED Cancel the demonstration When you turn on the power (or after you reset the unit), the display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB” 1 Press the volume knob. [YES] is selected for the initial setup. 2 Press the volume knob again. “DEMO OFF” appears. Set the clock 1 Press the volume knob to enter [FUNCTION] ...
-
Kenwood KDC-3657SD - page 7
5 ENGLISH | RADIO Search for a station 1 Press L SRC to select TUNER. 2 Press repeatedly to select FM1/ FM2/ FM3/ MW/ LW. 3 Press 4 / ¢ to search for a station. • To store a station: Press and hold one of the number buttons ( 1 to 6 ). • To select a stored station: Press one of the number buttons ( 1 to 6 ) Other settings 1 Press the volume kn ...
-
Kenwood KDC-3657SD - page 8
6 CD / USB / SD / iPod Start playback CD The source changes to CD and playback starts. USB The source changes to USB and playback starts. iPod/iPhone (for KDC - 4757SD ) The source changes to iPod and playback starts. Press 5 iPod to select the control mode while in iPod source. MODE ON: From the iPod * 1 . MODE OFF: From the unit. * 1 You can stil ...
-
Kenwood KDC-3657SD - page 9
7 ENGLISH | Select a song by name (for KDC - 4757SD ) While listening to iPod... 1 Press . 2 Turn the volume knob to select a category, then press the knob. 3 Press again. 4 Turn the volume knob to select the character to be searched for. 5 Press 4 / ¢ to move to the entry position. You can enter up to three characters. 6 Press the volume knob to ...
-
Kenwood KDC-3657SD - page 10
8 AUDIO SETTINGS While listening to any source... 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [AUDIO CONTROL] / [AUDIO CTRL] , then press the knob. 3 Turn the volume knob to make a selection (see the following table), then press the knob. Repeat step 3 until the desired item is selected or activated. 4 Press and h ...
-
Kenwood KDC-3657SD - page 11
9 ENGLISH | DISPLAY SETTINGS 1 Press the volume knob to enter [FUNCTION] . 2 Turn the volume knob to select [SETTINGS] , then press the knob. 3 Turn the volume knob to make a selection (see the table below), then press the knob. Repeat step 3 until the desired item is selected or activated. 4 Press and hold to exit. • To return to the previous hi ...
-
Kenwood KDC-3657SD - page 12
10 TROUBLESHOOTING Symptom Remedy Sound cannot be heard. • Adjust the volume to the optimum level. • Check the cords and connections. “PROTECT” appears and no operations can be done. Check to be sure the terminals of the speaker wires are insulated properly, then reset the unit. If this does not solve the problem, consult your nearest servi ...
-
Kenwood KDC-3657SD - page 13
11 ENGLISH | SPECIFICATIONS Tuner FM Frequency Range 87.5 MHz to 108 MHz (50 kHz space) Usable Sensitivity (S/N = 26 dB) 1.0 μV/75 Ω Quieting Sensitivity (DIN S/N = 46 dB) 2.5 μV/75 Ω Frequency Response (±3 dB) 30 Hz to 15 kHz Signal-to-Noise Ratio (MONO) 63 dB Stereo Separation (1 kHz) 40 dB MW Frequency Range 531 kHz to 1 611 kHz (9 kHz spac ...
-
Kenwood KDC-3657SD - page 14
12 INSTALLATION / CONNECTION Do the required wiring. ( ➜ 13) Dashboard of your car Bend the appropriate tabs to hold the mounting sleeve firmly in place. How to remove the unit 1 Detach the faceplate. 2 Fit the catch pin on the extraction keys into the holes on both sides of the trim plate, then pull it out. 3 Insert the extraction keys deeply in ...
-
Kenwood KDC-3657SD - page 15
13 ENGLISH | RL REAR/SW KDC - 3657SD REMOTE CONT STEERING WHEEL REMOTE INPUT MUTE P . CONT ANT CONT KDC - 4757SD SW FRONT RL REAR Wiring connection Part list for installation Fuse (10 A) Antenna terminal ( ×2 ) ( ×1 ) ( ×1 ) ( ×1 ) ( ×1 ) A Faceplate B Mounting sleeve C Trim plate D Wiring harness E Extraction key Light blue/yellow (Steering r ...
¿Tienes una pregunta acerca de Kenwood KDC-3657SD?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Kenwood KDC-3657SD, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Kenwood KDC-3657SD probablemente compartirá una forma de solucionarlo.