-
Oricom 50 - page 1
Baby Monitor Secure 50 User Guide ...
-
Oricom 50 - page 2
T ABLE OF CONTENTS W ARNINGS AND SAFETY INFORMA TION 1 GETTING ST ARTED 3 YOUR BABY MONITOR 5 BASIC OPERA TION 8 TROUBLESHOOTING 11 PRODUCT SPECIFICA TIONS 12 GUARANTEE 13 ...
-
Oricom 50 - page 3
1 W ARNINGS AND SAFETY INFORMA TION IMPORTANT Please read this user guide thoroughly before use. Your ORICOM Baby Monitor is designed to be an aid and should not be used as a substitute for responsible and proper adult supervision of a child. The Baby Monitor has been designed to provide some added reassurance in the form of sound transmission for ...
-
Oricom 50 - page 4
2 W ARNINGS AND SAFETY INFORMA TION Battery requirements Each parent unit requires two rechargeable Ni-MH batteries, size AAA 1.2V 800mAh (HR10/44). • Do not dispose of the batteries in a fi re, as they can explode. • Do not open, unscrew or temper with any of your baby monitor units or battery. Always carry out repairs through your authorised ...
-
Oricom 50 - page 5
3 clip battery cover Installation For the Parent Unit 1 Remove the Belt Clip by lifting the clip at the top and sliding it downwards. 2 Then remove the battery cover on the back of the Parent Unit by switching the OPEN switch. Insert the rechargeable batteries (supplied) as marked on the unit and close the cover again. 3 Place the Parent Unit into ...
-
Oricom 50 - page 6
4 5 Press [ ] to turn the Parent Unit on. • Before fi rst use, or if it has been out of use for a long time, the Parent Unit will need to be charged for 15-16 hours. During this time, the Parent Unit will operate from the Charger pod when switched on. Note that the Parent Unit cannot be used without batteries, even if it is placed in the charger ...
-
Oricom 50 - page 7
5 YOUR BABY MONITOR Baby unit (Sender) 1 Night light Key Press to turn On the night light. Press again to turn off the Light. 2 Power On/Off Key Press to turn the Unit ON. Press and hold to turn the Unit OFF. 3 Page Key Press and hold this key, Parent unit makes an audible alert. Useful to call for assistance or to locate a missing Parent Unit. 4 P ...
-
Oricom 50 - page 8
6 YOUR BABY MONITOR Left view of baby unit 6 DC 6V input Connecting to Power Adaptor. 7 8 9 10 6 Parent unit (Receiver) 7 Battery Cover Rechargeable batteries. 8 Belt Clip 9 Volume Up/Down Keys Adjust the Volume at which you hear the sounds in your baby's room. 10 Power Key Press and release to turn it ON. Press and hold to turn it OFF. ...
-
Oricom 50 - page 9
7 Charger Pod 14 Charging Light When Parent unit is placed in the Charger Pod, the red charger light comes ON to indicate the batteries are charging. Light will remain ON to ensure optimum charge is maintained. YOUR BABY MONITOR 12 11 14 11 Power Light Red light when the power is ON. Flashing light indicates rechargeable batteries need recharging. ...
-
Oricom 50 - page 10
8 BASIC OPERA TION Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And also see the green and red sensor lights around the top of the Parent Unit rise and fall with the sound levels. Note: If the connection between the Parent and Baby Units is broken at any time the green ...
-
Oricom 50 - page 11
9 BASIC OPERA TION • To stop the Page alert, press any button on the Parent Unit, or press [ ] again on the Baby Unit. Note: If no button is pressed, the paging tone will stop after 30 seconds. If the Parent Unit volume is off, the Parent Unit volume will reset to mid volume. Night light The Baby Unit has a one touch night light which emits a sof ...
-
Oricom 50 - page 12
10 BASIC OPERA TION 8 lights illuminated fully charged 6 lights illuminated half charged 4 lights illuminated battery is running low 2 lights illuminated (alarm beep sounds) batteries need recharging Note: The parent unit can be used on or off the charger pod. When on the charger pod, the batteries will be recharged at the same time. However, the t ...
-
Oricom 50 - page 13
11 TROUBLESHOOTING Problem Possible cause(s) The red power lights do not turn on when you plug in the power. 1. Check if the units are properly connected to the power supply. 2. Check if the power is turned on. If not, Press [ ] to turn on the power. The green Link light on the Parent Unit is fl ashing and cannot hear the sounds from your baby&apo ...
-
Oricom 50 - page 14
12 PRODUCT SPECIFICA TIONS Feature Speci fi cations Operating Frequency DECT 1.8 GHz Range Up to 300m under optimum conditions. The range is reduced in buildings (up to 50m) as a result of walls, doors etc. Power supply (baby unit) Input: 240 V AC 50Hz Output: 6 V DC , 200 mA, Non rechargeable batteries (baby unit) (not included in the package con ...
-
Oricom 50 - page 15
13 GUARANTEE Warranty Information (Australia) Oricom makes no other warranties or conditions, express or implied, including as to merchantability and fi tness for a particular purpose, except as stated in this Warranty. Any implied warranties that may be imposed by law are limited in duration to the Warranty Period. Oricom warrants that the produc ...
-
Oricom 50 - page 16
Australia Oricom International Pty Ltd Locked Bag 658 South Windsor, NSW 2756 Customer Support Email: support@oricom.com.au Web: www.oricom.com.au Phone: 1300 889 785 Fax: (02) 4574 8898 Customer Support If you suspect your product is not functioning to speci fi cation, before making a warranty claim please use the following resources. - Troublesh ...
¿Tienes una pregunta acerca de Oricom 50?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Oricom 50, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Oricom 50 probablemente compartirá una forma de solucionarlo.