-
Woods Equipment 1013460 - page 1
I NST AL LA TION MAN U AL SA VE THIS MANU AL! Include it with the backhoe manual. It contains safety , operation, and repair part information not found in other manuals. 1013460 4-POINT SU B-FR AME MOUN TING KIT for Backhoe Models BH70-X, BH80-X, BH6 500, BH75 00 on New Holland ® Tr a c t o r s T2220, TC29DA, TC33DA, TC34DA FW A or Case IH ® Tr a ...
-
Woods Equipment 1013460 - page 2
2 Introduction SFMK (Re v . 2/20/2008) T O THE DEALER : Assemb ly and prop er installati on of this pro duct is the r esponsi bility of the Woods ® dealer. R ead manua l instr uctions and safet y rules . Make sure all item s on the Dea ler ’s Pre- Delivery and Deliv ery Che ck Lists in the O perator ’s Manual are com pleted befo re rele asin g ...
-
Woods Equipment 1013460 - page 3
Safety 3 4-Point SFMK (Rev . 5/8/2006) SAFETY RULES ATTENTION! BECOME ALER T! Y OUR SA FETY IS INV OLVED! This Sub-Frame Mounting Kit is only fo r the backhoes and tractors specified in the Su b-Frame Mount Installation secti on of this manua l. Any other use or modific ation of this moun ting k it may result in se rious injury or deat h. H ...
-
Woods Equipment 1013460 - page 4
4 Safety 4-Po int S FMK ( Rev . 5/ 8/20 06) SAFETY RULES ATTENTION! BECOME ALER T! YOUR SAFETY IS IN V OLV ED! (Safety R ules co ntinued from previous page) Make su re al l hydraulic hoses , fittin gs, and valves are in good condition and not leaking before st arting power unit or using equipment. Check and route hoses car ef ully to pr event d ...
-
Woods Equipment 1013460 - page 5
Inst allation 5 MAN040 6 (Rev . 9/7/2007) BACKHOE SUB-FRAME INST ALLA TION T ractor Prep aration ■ Only us e 1013 460 4-P oint Sub -Fram e Mount- ing Kit for moun ting Woods BH70-X, BH80-X, BH6500, BH750 0 backho e on New Holl and ® T2220, TC29 DA, TC33DA, T C34DA tracto rs or Case IH ® DX34, Fa rmall ® 31 , Farmall 35 tractors equipped with W ...
-
Woods Equipment 1013460 - page 6
6 Installation MAN040 6 (Rev .9/7/2007) Inst all Front Mount s With W oods LS84 Loader Mount Attach front m ount (32) to the rig ht loade r mount using two cap scr ews (26 ), hardened flat was hers (23) an d hex nuts ( 27). 23. 57817 5/8 Harde ned fla t washer 26. 902 5/8 NC x 2 HHCS GR5 27. 230 5/8 NC Hex nut 32. 1026846 Front moun t (LS 84 only) ...
-
Woods Equipment 1013460 - page 7
Inst allation 7 MAN040 6 (Rev . 9/7/2007) Inst all T ractor Bracket s With W oods LS84 Loader Mount 1. P lace left tractor bracket (2) under left side of tractor . Use a hydrau lic fl oor jack to help rais e and hold tractor bracket i n positi on. 2. A ttach left tractor bracket (2 ) to left loader mount using two cap s crews (26) , hardened flat w ...
-
Woods Equipment 1013460 - page 8
8 Installation MAN040 6 (Rev .9/7/2007) Inst all T ractor Brac kets 1. Place le ft tractor brac ket (2 ) under le ft side of tractor . Use a hy draulic floor jack to help rais e and hold t ractor bracke t in posi tion. 2. Attach left tra ctor br acket to left fron t mount (8) using two ca p screws (26), harden ed flat washer s (23), and h ex nut (2 ...
-
Woods Equipment 1013460 - page 9
Inst allation 9 MAN040 6 (Rev . 9/7/2007) Inst all Cross Brace 1. Remove PT O shield . 2. Attach cr oss br ace (7 ) to re ar of tr actor using tw o cap scre ws (2 4) and har dened fl at wash ers (23 ). 3. Attach to right and left tractor b rackets us ing four (two per s ide) c ap screw s (18) , harden ed fla t washers ( 22), and hex nuts (15). 4. I ...
-
Woods Equipment 1013460 - page 10
10 Installation MAN040 6 (Rev .9/7/2007) T orque Mounting Hardware Att ach Backhoe M ounts to Backho e NOTE: Lea ve a ll har dware l oose until back hoe has been mount ed to the tractor . 1. Attach right backh oe moun t (3) and le ft backhoe mount (4) to back hoe fram e. 2. Secu re into posi tion usin g six (thr ee per brack et) cap sc rews ( 25), ...
-
Woods Equipment 1013460 - page 11
Inst allation 11 MAN040 6 (Rev . 9/7/2007) HYDRAULIC INST ALLATION Keep hands and body away from pres surized lines. Use p aper or cardboard, not hands or other body p arts to check for leaks. W ear safety gog- gles. Hydrauli c f luid under pressu re can easily penetrate skin and will cause ser ious injury or death. Make sure that all opera ...
-
Woods Equipment 1013460 - page 12
12 Installation MAN040 6 (Rev .9/7/2007) Inst all Hydraulic Block and Fittings 1. Locate the hydrau lic m anifold b lock on the righ t side of the tractor just u nder the fende r (Figu re 19) and rem ove th e block -off cap. 2. Attach hydr aulic bl ock (18) to tr actor u sing new o- rings (1 4), thr ee cap sc rews ( 8) and one cap screw (9) p lu s ...
-
Woods Equipment 1013460 - page 13
Inst allation 13 MAN040 6 (Rev . 9/7/2007) Inst all Bulkhead Adapter on Backhoe Mount 1. Attach bul khead a dapter (1 ) to crossm ember between backhoe bracke ts. Secure with nu t sup- plied wit h adapte r . 2. Atta ch elbo w (10) and fem ale qui ck coup ler (1 6) to bulkhe ad adapter as sho wn in Figur e 23. 3. Positi on elbow and quic k couple r ...
-
Woods Equipment 1013460 - page 14
14 Installation MAN040 6 (Rev .9/7/2007) Mount Backhoe to T ractor This mounting kit is designed to provide secure moun ting and adequ ate operator c lear- ance for mo st operators when p roperly inst alled. Check clearance dimensions shown below to be sure you have installed seat bracket corr ectly . In some cases it may be nec essary to ad ju ...
-
Woods Equipment 1013460 - page 15
Inst allation 15 MAN040 6 (Rev . 9/7/2007) Mount Backhoe to T r actor ( Continued) Refer to Figure 26. 5. Using th e back hoe h ydraul ics posit ion th e back - hoe brac kets at a sl ight a ngle, appr oximate ly 5 t o 10 degrees. 6. Raise bac khoe up by l owering stabili zers an d boom secti on until backhoe mou nting pins on backhoe brackets are s ...
-
Woods Equipment 1013460 - page 16
16 Installation MAN040 6 (Rev .9/7/2007) Remove Backhoe from T ractor The only time the bac khoe may be operated from a position other than the operator seat is during backhoe a tt achme nt and remova l. Opera- tor must: • Read Mounting Kit Manual instructions on att aching and removing backhoe and use extreme c are. • Always stand betwee n ...
-
Woods Equipment 1013460 - page 17
Inst allation 17 MAN040 6 (Rev . 9/7/2007) STORAG E Connect Hydraulic Hoses TRACTOR: Conn ect male quic k co upler on end o f hose to femal e quic k coupler at bulkhea d bracke t when back hoe is remov ed from tra ctor . See F igure 28. NOTICE ■ Failure to connect hoses together will result in damage t o tractor hydraulic sy stem. BACKHOE: Connec ...
-
Woods Equipment 1013460 - page 18
18 Part s MAN040 6 (Rev . 9/7/20 07) 1013460 4-POINT SUB-FRAME MOU NTING KIT W ARNING PINCH POINT Keep hands clear . 1006885 31 - PN 1 006885 MODEL NO. SE R IAL NO. W oods Equipment Company Oregon, Illinois, U.S.A. Seria l Numb er Plate R E F P ART QTY DESCRIPTION 1 1013462 1 Right tractor brac ket 2 1013463 1 Left trac tor bracke t 3 1013464 1 Rig ...
-
Woods Equipment 1013460 - page 19
Part s 19 MAN0406 (Rev . 9/7/2007) 1013484 HOSE KIT R E F P ART QTY DESCRIPTION 1 1006144 1 Adapt er , bulkhe ad 3/8 N PTM x 3/4 JICM 2 1009493 1 Hose, 40" x 3/8 NPTM x 9/16 JICF 3 1009495 1 Adapt er , bulkhe ad 3/8 N PTM x 9/ 16 J ICM 4 1010924 1 Hose, 40" x 3/8 NPTM x 3/4 O RBM 5 1013479 1 Hose, 10" x 3/4 JIC F x 3/4 ORBM 6 10135 2 ...
-
Woods Equipment 1013460 - page 20
20 Appendix Bolt T orque & Size Chart s (Rev . 3/28/2007) BOLT T O RQUE CHART Always tighten har dware to these v alue s unles s a different torque value or tighte ning p rocedure i s list ed for a specifi c applica tion . F ast eners must al wa ys be repla ced wi th the sam e grade as sp ecified in the m anual par ts list. Always use the prope ...
-
Woods Equipment 1013460 - page 21
Appendix 21 Bolt T orque & Siz e Chart s (Rev . 3/28/2007 ) BOLT SIZE CHART NOTE: Chart s hows b olt thr ead siz es an d corres pondin g head (w rench ) size s for standard SA E and metric bolts. ABBREVIATIONS AG ........ ............. ....... .......... ............. ...... ..... Agricu lture ASABE ............ ........ American Society of Agr ...
-
Woods Equipment 1013460 - page 22
F-8494 (Rev . 6/23/2005) W ARRANTY (Replacement Parts F or All Models Except Mow’ n Machine TM Zero-T urn Mowers and W oods Boundary TM Utility V ehicles ) W oods Equipm ent Compan y (“WOODS”) w arrants this prod uct to be free from defect in mate rial and workmansh ip for a period of nin ety (90) days from the date of deli very of the prod u ...
-
Woods Equipment 1013460 - page 23
F-3079 (Rev . 4/4/2008) W ARR ANTY (All Models Except Mow’ n Machine TM Zero-T urn Mo wers and W oods Boundar y TM Utility V ehicles) Ple ase En ter In fo rmat ion Be low an d Save for Fu ture Ref eren ce. Date P urch ased: ___ _____ _____ _______ _____ ___ From (Dea ler): ______ _______ _____ _____ _______ _____ _____ ___ Model Number : ___ ____ ...
-
Woods Equipment 1013460 - page 24
P ART NO. MAN0406 © 2005 Woods Equipment Company . All rights reserved. WOODS, t he Woods logo, and "T ested. Proven. Unbeatable." are trademarks of Woods Equipment Company . All other trademarks, t rade names, or service m arks not own ed by W oods Equipment Company that appear in this ma nual are the property of t heir respective compa ...
¿Tienes una pregunta acerca de Woods Equipment 1013460?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Woods Equipment 1013460, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Woods Equipment 1013460 probablemente compartirá una forma de solucionarlo.