-
Rackmount Enterprise Series - page 1
1-86 6-20 7-66 31 | s ales @rac kmou ntso luti ons. net www .rac kmou ntso luti ons. net ...
-
Rackmount Enterprise Series - page 2
1 © Copyright Para Systems, Inc., 2000 Enterprise Series Owner's Manual 1 . Introduction 2 2 . Controls and Indicators 4 3. Installation 5 4 . Operation 9 5 . T roubleshooting 1 1 6 . Replacing the Battery 12 7 . Obtaining Service 14 8 . Specifications 15 9 . Configurable Parameters & Settings 16 10 . Limited Product W arranty 18 1 1 . De ...
-
Rackmount Enterprise Series - page 3
2 Thank you for purchasing a MINUTEMAN power protection product. It has been designed and manufactured to provide many years of trouble free service. Please read the manual before installing your Enterprise Series UPS. It provides the information that should be followed during installation and maintenance of the UPS and the batteries allowing you t ...
-
Rackmount Enterprise Series - page 4
3 W ARNING: RISK OF ELECTRICAL SHOCK. HAZARDOUS LIVE P ARTS INSIDE THIS POWER SUPPL Y ARE ENERGIZED FROM THE BA TTER Y EVEN WHEN THE AC INPUT POWER IS DISCONNECTED. TO DE-ENERGIZE THE OUTPUTS OF THE UPS: 1. IF THE UPS IS ON PRESS THE ON/OFF BUTTON FOR 1 SECOND 2. DISCONNECT THE UPS FROM THE AC POWER OUTLET 3. TO DEENERGIZE THE UPS COMPLETEL Y , DIS ...
-
Rackmount Enterprise Series - page 5
4 Press and release the ON/OFF/TEST button after one beep to turn the unit ON or OFF (see section 4) On-Line On-Battery Buck Boost The On-Line/On-Battery/Boost and Buck (green) LED illuminates in a steady state when the UPS is on and supplying AC power to the load. The LED blinks and the audible alarm sounds, when supplying battery power to the loa ...
-
Rackmount Enterprise Series - page 6
5 I NST ALLA TION P LACEMENT Install the UPS in a temperature controlled environment that is free of conductive contami- nants. Select a location which will provide good air circulation for the UPS at all times. Avoid locations near heating devices, water or excessive humidity , or where the UPS is exposed to direct sunlight. Route power cords so t ...
-
Rackmount Enterprise Series - page 7
6 English The Desk T op Configuration allows the user to install the monitor , the computer and the UPS in one single stack. There are four self-stick rubber feet provided with UPS. The four rubber feet can be installed on the bottom side of the UPS. Use CAUTION, the UPS is extremely heavy . Once the location of the UPS has been determined, stand t ...
-
Rackmount Enterprise Series - page 8
7 English The T ower Configuration allows the user to install the UPS in the up-right position next to the tower computer . There is a tower bracket kit available for the UPS. Use CAUTION, the UPS is extremely heavy . Once the location of the UPS has been determined, lay the UPS down flat on a desk or a table. Position the UPS so that the tower bra ...
-
Rackmount Enterprise Series - page 9
8 English English C ONNECTING T O A N AC S OURCE Plug the UPS into a two pole, three wire, grounded receptacle only . Do not use extension cords or adapter plugs. CONNECTING TO THE TELEPHONE/NETWORK SURGE PROTECTION CONNECTION IS OPTIONAL. THE UPS WORKS PROPERL Y WITHOUT A CONNECTION. NOTE: CONNECTING TO THE COMPUTER INTERF ACE PORT IS OPTIONAL. TH ...
-
Rackmount Enterprise Series - page 10
9 English T URNING T HE U NIT O N / O FF Press and release the ON/OFF/TEST SWITCH. After one beep the unit will turn on and supply power to the load. The load is immediately powered while the UPS runs a 5 second self test. Press and release the switch to turn the unit off. The UPS will continue to charge the batteries whenever it is plugged in and ...
-
Rackmount Enterprise Series - page 11
10 The communications port is a standard DB9 female with both RS232 and simulated contact closure capability . The Enterprise series units will poll the port and activate the port for RS232 or contact closure in accordance with the type of cable it finds connected to the port. T o change the port configuration requires the unit be turned off and re ...
-
Rackmount Enterprise Series - page 12
11 Weak or bad batteries/bad bat- tery connection Normal operation DC circuit breaker tripped. The Battery Pack's internal fuse is blown The load has exceeded the UPS's capacity The UPS is in either the Buck mode or the Boost mode UPS will not turn on Fault LED is illuminated The Site Wiring Fault LED is illuminated The On-line/On- Batter ...
-
Rackmount Enterprise Series - page 13
12 R EPLACING T HE B A TTERY The Enterprise Series UPS has an easy to replace hot-swappable battery(s). Please read the following warning statements before attempting to service the battery(s). NOTE: If there is a power interruption while replacing the hot-swappable batteries, with the UPS on, the load will not be backed up. W ARNING! THIS UNINTERR ...
-
Rackmount Enterprise Series - page 14
13 B A TTER Y R EPLACEMENT P ROCEDURE PLEASE READ THE CAUTIONS BEFORE A TTEMPTING TO REPLACE THE BA TTERIES Hot-swappable batteries means that the batteries can be replaced without powering down the whole UPS system. NOTE: If there is a power interruption while replacing the hot- swappable batteries, with the UPS on, the load will not be backed up. ...
-
Rackmount Enterprise Series - page 15
14 I F T HE UPS R EQUIRES S ERVICE 1.Use the TROUBLESHOOTING section to eliminate obvious causes. 2.V erify there are no circuit breakers tripped. A tripped circuit breaker is the most common problem. 3.Call your dealer for assistance. If you cannot reach your dealer , or if they cannot resolve the problem call or fax MINUTEMAN T echnical Support a ...
-
Rackmount Enterprise Series - page 16
15 English SPE CIFICA TIONS & Acceptable input voltage Input voltage (on-line operation) Output voltage Nominal input frequency Input protection Frequency limits (on-line operation) Transfer time Maximum load On-battery output voltage On-battery frequency On-battery waveshape Protection Surge energy rating (one time, 10/1000 us waveform) Surge ...
-
Rackmount Enterprise Series - page 17
16 Enterprise Series Date of manufacture 1826 Enabled Enabled UPS output Use this function to uniquely identify the UPS in your net- work configuration Enter the current date when replacing batteries When enabled, the UPS will automatically restart from a low battery shutdown when normal AC returns Enabled - the UPS will emit a short beep when in t ...
-
Rackmount Enterprise Series - page 18
17 Customized Output Receptacle Panels The Enterprise series UPS has a removable receptacle panel. The receptacle panel can be configured with one locking receptacle and two duplex receptacles. This will allow the user to customize the output receptacles for their specific applications. MINUTEMAN will only use UL or CE approved receptacles. Here is ...
-
Rackmount Enterprise Series - page 19
18 LIMITED PRODUCT W ARRANTY Para Systems Inc. (Para Systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship for a period of three years from the date of manufacture. For equipment sites within the United States and Canada, this warranty covers repair or replacement o ...
-
Rackmount Enterprise Series - page 20
19 English DECLARA TION OF CONFORMITY Application of Council Directive(s): 89/336/EEC, 7/23/EEC Standard(s) to which Conformity is declared: EN50091-2, EN60555-2, EN61000-3, EN50091-1 Manufacturer ’ s Name: Para Systems, Inc. (Minuteman Power Supplies) Manufacturer ’ s Address: 1455 LeMay Drive Carrollton, T exas 75007 USA T ype of Equipment: U ...
-
Rackmount Enterprise Series - page 21
20 Notes: English English ...
-
Rackmount Enterprise Series - page 22
Rac kmo unt Sol utio ns, Lt d 915 S. Jup ite r Ro ad Gar lan d, T X 7 5042 www . rac kmo unts olu tion s.n et sal es@ rack mou nts olut ion s.ne t 1-866-207-6631 | Fax: 972-276-6484 ...
¿Tienes una pregunta acerca de Rackmount Enterprise Series?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Rackmount Enterprise Series, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Rackmount Enterprise Series probablemente compartirá una forma de solucionarlo.