-
APart MA200 - page 1
INFO@AP ART -A UDIO .COM MANU AL MA200 ...
-
APart MA200 - page 2
WWW .AP ART -AUDIO .COM Safety First! • Read all documentation before operating your equipment. • Retain all documentation for future reference. • Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. • Do not spill water or oth ...
-
APart MA200 - page 3
INFO@AP ART -A UDIO .COM Content 1. APart MA200 Mixing Amplier 2. Front Panel 3. Rear Panel 4. Inside Settings 5. Overview Of The MA200 Series 6. How T o Deal With 100V Loudspeakers Systems 7. T echnical Specications 8. Block Diagram 9. Notes ...
-
APart MA200 - page 4
WWW .AP ART -AUDIO .COM The MA200 is a professional 4 zone P A mixing amplier for commercial and industrial applications. Rarely seen on its competitors, all microphone inputs have integrated speech lters and they are high-class transistor-balanced type, allowing good control of hum and noise over long cables. He’s able to drive 8-ohm or co ...
-
APart MA200 - page 5
INFO@AP ART -A UDIO .COM 6 7 8 8 9 10 11 12 13 14 5 4 1 2 3 1) Power switch: Here you can switch the power on and off. 2) Overload indicator: This red LED illuminates when one of the protections have been activated. No or distorted sound will be heard. This will be in case of overheating, being the result of drawing too much power from your ampli? ...
-
APart MA200 - page 6
WWW .AP ART -AUDIO .COM 3. Rear P anel 16 15 18 19 20 31 30 26 28 29 26 32 17 21 23 23 24 24 25 25 26 22 27 15) V oltage selector: Set the local voltage. If any doubt, contact your dealer . The unit is shipped with the selec- tor set to 230V AC. 16) Mains socket: The unit can be connected to the mains circuit by a standard IEC type power cord. This ...
-
APart MA200 - page 7
INFO@AP ART -A UDIO .COM 23) CD stereo input / AUX input, 500mV: Use these stereo RCA inputs to connect a line level source such as CD players, MD players, etc…. Y ou have to make your choice with the selector at the front (see 12). Stereo signals will be summed together . 24) Line 4, input, 200mV/ Mic 4 input. Use only one of these parallel wire ...
-
APart MA200 - page 8
WWW .AP ART -AUDIO .COM 4. Inside Settings JP3 JP4 JP5 JP1 1 Phantom Power MIC1 : JP3 MIC2 : JP4 MIC3 : JP5 MIC4 : JP1 1 Phantom on / off jumper The MA200 has been shipped with these jumpers in the OFF position. For each microphone input a jumper is available. When you put a jumper to the ON position, phantom power will be supplied to the microphon ...
-
APart MA200 - page 9
INFO@AP ART -A UDIO .COM MA200CDR • High quality 200 W atts 100 V olt mixing amplier • Integrated AM/FM tuner and CD/MP3 player • 4 mic (phantom via internal switch), 4 line inputs • 3 level priority system, 24V priority output • Integrated 2-tone chime (adjustable volume) • 4 output zones. (Zone 4: Mic / music selection) • Build i ...
-
APart MA200 - page 10
WWW .AP ART -AUDIO .COM In fact working with 100V loudspeakers is rather simple, when done in the right way . Each 100V loudspeaker has a 100V transformer which can be set to a certain power , for example: 1,5 3 or 6W . As the example shows, the sum of all loudspeaker settings should never exceed the amplier ’s power specications. Never use ...
-
APart MA200 - page 11
INFO@AP ART -A UDIO .COM PHANTOM 2 3 1 PHANTOM 2 3 1 MUTE JP4 PHANTOM 2 3 1 MUTE JP5 PHANTOM 2 3 1 MUTE JP11 MUTE VOX MUTE + - + - + - + - AUX CD TUNER Pre Amp Pre Amp Pre Amp Pre Amp + - CHIME REQ OUT PreAmp OUT PowerAmp IN + - MASTER TONE MUTE + - + - POWER AMP AUTO GAIN CONTROL 100V 70V 50V 8 ohm COM 24V/1A PRIORITY - + + Z1 + Z2 + Z3 DIN5 + MUS ...
-
APart MA200 - page 12
WWW .AP ART -AUDIO .COM FREQUENCY RESPONSE 40HZ 25KHZ (+1/-3 DB) DISTORTION <0,3% @ -6DB, 1KHZ BASS CONTROL +/- 10DB, 100 HZ TREBLE CONTROL +/- 10DB, 10 KHZ S/N amplier: better than 95dB, 22Hz 22kHz line: better than 80dB, 22Hz 22kHz mic: better than 65dB, 22Hz 22kHz LED INDICA TORS limiter active, red signal 100%, yellow signal -25 dB, green ...
-
APart MA200 - page 13
INFO@AP ART -A UDIO .COM MIC INPUT 1; ¼” TRS PHONE JACK A T THE FRONT XLR3 COMBO, DIN5; EURO BLOCK SENSITIVITY 1,5 MV IMPEDANCE 600 Ω S/N ( AT MAX. VOLUME) > 65 dB PHANTOM POWER 14 V (internal jumper) FREQUENCY RESPONSE > 80Hz->15Khz (+1/-3 dB) VOX MUTE trigger level 0,6 mV , 1Khz, mutes mic 2,3,4+music, > 40 dB Mic input 2,3 & ...
-
APart MA200 - page 14
WWW .AP ART -AUDIO .COM SPEAKER SELECTOR ZONE 1 3 on/off ZONE 4 paging on/off music on/off SPEAKER ZONE OUTPUT , EURO BLOCK HIGH Z ZONE 1-2-3-4 100 V SPEAKER OUT ; EURO BLOCK HIGH Z 50 (12,5 Ω) 70 (24,5 Ω) 100 V (50 Ω) LOW Z 8 Ω PHANTOM POWER MIC 1-2-3-4 14 V; internal jumpers PR E A MP OUT LEVEL 1 V RECORD OUT ; RCA MONO LEVEL 1 V PRIORITY ...
-
APart MA200 - page 15
INFO@AP ART -A UDIO .COM 9. Notes ...
-
APart MA200 - page 16
WWW .AP ART -AUDIO .COM ANY SUGGESTION? They are well appreciated and eventually rewarded! Send your ideas or suggestions to suggestions@apart-audio.com MA200 is developed by Audioprof nv Lanteernhofstraat 90 BE-2100 Deurne BELGIUM ...
¿Tienes una pregunta acerca de APart MA200?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con APart MA200, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con APart MA200 probablemente compartirá una forma de solucionarlo.