-
Tanaka TPH-2501 - page 1
Owner’ Owner’ Owner’ Owner’ Owner’ s Man s Man s Man s Man s Man ual ual ual ual ual Model Numbers: TPH-2501,TPH-250PF TPH-2501,TPH-250PF TPH-2501,TPH-250PF TPH-2501,TPH-250PF TPH-2501,TPH-250PF TPH-270PF/PN TPH-270PF/PN TPH-270PF/PN TPH-270PF/PN TPH-270PF/PN POLE HEDGETRIMMERS POLE HEDGETRIMMERS POLE HEDGETRIMMERS POLE HEDGETRIMMERS POLE ...
-
Tanaka TPH-2501 - page 2
www.tanaka-usa.com 1 custsvc@tanaka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN Before using this unit: • Read the operator’s manual carefully. • Check that the cutt ing equipment is correctly assembled and adjusted. • Start the unit and check the carburetor adjustment. See “Maintenance”. WARNING Read, understand and follow ...
-
Tanaka TPH-2501 - page 3
www.tanaka-usa.com 2 custsvc@tanaka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN ...
-
Tanaka TPH-2501 - page 4
www.tanaka-usa.com 3 custsvc@tanaka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN 2. Warnings and safety instructions Operator Safety • Always wear head protection with ful l face shield to help protect against falling branches and debris. • Avoid all power lines. T his unit is not insulated ag ainst electrical current. • Gloves sh ...
-
Tanaka TPH-2501 - page 5
www.tanaka-usa.com 4 custsvc@tanaka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN Throttle wire/stop cord Remove air cleaner cover. (Fig. 1-4) Connect stop cords. (Fig. 1 -5) Set outer-receiver (1) (If so provided) into wire guide and put throttle wire through the outer receiver. (Fig. 1 -4) Connect throttle wire end to carburetor. (Fig. ...
-
Tanaka TPH-2501 - page 6
www.tanaka-usa.com 5 custsvc@tanaka-i sm.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN 4. Operating procedures. (Fig. 2-1) WARNING! This unit is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handling fuel. Fuel • Always use branded 89 octane unleaded gas ...
-
Tanaka TPH-2501 - page 7
www.tanaka-usa.com 6 custsvc@tana ka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN Starting (Fig. 2-5) CAUTION! Before starting, make sure the cutting attach ment does not touch anything. 1. Set ignition switch (1) to ON position. (Fig. 2-5) *Push priming bulb (4) several times so that fuel flows through the bulb or return pipe. (If so e ...
-
Tanaka TPH-2501 - page 8
www.tanaka-usa.com 7 custsvc@tana ka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN SAFE OPERATION CAUTION! • Always wear gloves during operati on or maintenance. • Review the area to be trim med. Look for hazards that co uld contribute to unsafe conditions . DO NOT operate unit if any wires (power, telephone, c able, etc.) are closer ...
-
Tanaka TPH-2501 - page 9
www.tanaka-usa.com 8 custsvc@tanaka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN 5. Maintenance MAINTENANCE, REPLA CEMENT, OR REPAIR OF THE EMISSION CONTROL D EVICES AND SYSTEMS MAY BE PERFORMED BY AN Y NONROAD ENGINE REPAIR ESTABLISHMENT OR INDIVIDUAL. Carburetor adjustment (Fig. 3-1) WARNING! The cutting attachment may be spinning dur ...
-
Tanaka TPH-2501 - page 10
www.tanaka-usa.com 9 custsvc@tanaka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN Fuel Filter (Fig. 3-2B) Drain all fuel from fuel tank and pull fuel filter line from tank. Pull filter element out of holder assembly. Replace filter if it appears to be discolored or hardened from use. The filter has a white, felt-like appearance when new. ...
-
Tanaka TPH-2501 - page 11
www.tanaka-usa.com 10 custsvc@tana ka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN Cutter blade (Fig. 4-1, 2) The blades are installed to the cutter guide with three to five bolts depen ding on cutt er length. Those bolts are tightened with a clearance s o that the cutters ca n move smoothly. When clearance is too small: The cutters do ...
-
Tanaka TPH-2501 - page 12
www.tanaka-usa.com 11 custsvc@tanaka-ism.c om Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN Maintenance schedule Below you will find some genera l maintenance instructions. For further information please contact your service dealer. Daily maintenance • Clean the exterior of th e unit. • Check the blade guar d for damage or cracks. C hange th ...
-
Tanaka TPH-2501 - page 13
www.tanaka-usa.com 12 custsvc@tanaka-ism.c om Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN 6. Specifications Note : Sound levels are calculated as the time-w eighted energy total under various working conditions with the following time distri bution: ½ idling, ½ racing. ***All data subject to ch ange without notice. ...
-
Tanaka TPH-2501 - page 14
www.tanaka-usa.com 13 custsvc@tanaka-ism.com Owner’s Manual TPH-2501,TPH-250PF,TPH-270PF/PN Declaration of conformity Tanaka Kogyo Co., Ltd., 3-4- 29 Tsudanum a, Narashino, Chiba, Ja pan TPH-2501/25 0PF Declare under our sole responsibility that the product, pole hedge trimmer model TPH-270PF/PN to which this declaration relates is in conformity ...
¿Tienes una pregunta acerca de Tanaka TPH-2501?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Tanaka TPH-2501, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Tanaka TPH-2501 probablemente compartirá una forma de solucionarlo.