-
Zanussi ZHC705 - page 1
COOKER HOOD ZHC605 ZHC705 ZHC905 INSTR UCTION BOOKLET ...
-
Zanussi ZHC705 - page 2
2 Thank you for buying a Zanussi product. T o enable you to use your appliance effectively and safely , please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further information on Zanussi Products, please contact our Customer Care Depar ...
-
Zanussi ZHC705 - page 3
3 IMPORT ANT SAFETY INFORMA TION These warnings are provided in the interests of your safety . Ensure that you understand them all before installing or using this appliance. Y our safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Installation • Any installation w ...
-
Zanussi ZHC705 - page 4
4 YOUR APPLIANCE OPERA TING INSTRUCTIONS The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The appliance can be installed to recirculate or extract contaminated air . Cooker Hood Controls The cooker hood functions are controlled by three switches located on the underside of the hood immediately in ...
-
Zanussi ZHC705 - page 5
5 T o Operate Select the required fan speed and light if required. Recirculation In the recirculation mode the contaminated air enters the cooker hood through the grease fi lters. The air is cleaned by passing through the charcoal fi lters before being passed back into the kitchen through the grilles in either side of the chimney stack. Extractio ...
-
Zanussi ZHC705 - page 6
6 Before carrying out any maintenance or clea- ning isolate the cooker hood from the mains supply . The cooker hood must be kept clean, as a build up of grease or fat can be a fi re hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. Never use scouring pads or abrasive cleaners. Never use excessi ...
-
Zanussi ZHC705 - page 7
7 Charcoal Filters In the recirculation mode the charcoal fi lters absorb smells and unwanted odours. The charcoal fi lters cannot be cleaned, we recommend they should be replaced approximately every three months or more often if the hood is used for more than three hours per day . T o Remove/Replace the Charcoal Filters 1. First remove the metal ...
-
Zanussi ZHC705 - page 8
8 SOMETHING NOT WORKING SERVICE AND SP ARE P ARTS If, having followed these instructions carefully , your cooker hood fails to work properly please carry out the following checks. Symptom The cooker hood will not start The cooker hood is not working effectively The cooker hood has switched off during opera- tion If after all these checks, the fault ...
-
Zanussi ZHC705 - page 9
9 GUARANTEE CONDITIONS We Zanussi, undertake that if within twenty four months of the date of the purchase this Zanussi built-in appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour , materials or carriage o ...
-
Zanussi ZHC705 - page 10
10 INST ALLA TION INSTRUCTIONS It is dangerous to alter the specifi cations or attempt to modify this product in any way . T echnical Information DIMENSIONS HEIGHT OF CANOPY : 24cm HEIGHT OF CHIMNEY : (UPPER SECTION) 20cm (LOWER SECTION) 56cm WIDTH OF CANOPY - ZHC 605: 59,8cm WIDTH OF CANOPY - ZHC 705: 69,8cm WIDTH OF CANOPY - ZHC 905: 89,8cm DEPT ...
-
Zanussi ZHC705 - page 11
11 INST ALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air . Incorrect installation may affect the safety of this cooker hood. Installation Requirements Bef ...
-
Zanussi ZHC705 - page 12
12 A: Built-in Electric Hob: 650mm clearance B: Built-in Gas hob: 700mm clearance C: Slot-in Electric Cooker: 685mm clearance D: Slot-in Gas Cooker: 787mm clearance Hob Clearance Height The cooker hood is designed to be fi tted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not ...
-
Zanussi ZHC705 - page 13
13 Fitting the W all Brackets • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Draw a horizontal line at 650 mm above the hob for installation without the back panel, or at height H (H=height of the visible part of the panel) for instal- la ...
-
Zanussi ZHC705 - page 14
14 Extraction (Ducted) The cooker hood is more effective when installed in the extraction mode (ducted to the outside). V enting kits may be purchased through your retailer or DIY store or using the enclosed form, and must be evacuated through an outside vent of ø125 (5ins) or ø150mm (6ins). The ducting used must be manufactured from fire retarde ...
-
Zanussi ZHC705 - page 15
15 Fitting the Upper Chimney • Slightly widen the two sides of the upper chimney and hook them behind the brackets item 7.2.1 ensuring they are correctly seated. • Secure the sides to the brackets using the 4 screws item 12c (2.9 x 9.5mm) supplied. Fitting the Lower Chimney • Slightly widen the two sides of the lower chimney and hook them bet ...
-
Zanussi ZHC705 - page 16
© Electrolux plc 2002 436002529_01 - 050121 ...
¿Tienes una pregunta acerca de Zanussi ZHC705?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Zanussi ZHC705, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Zanussi ZHC705 probablemente compartirá una forma de solucionarlo.