-
Sub-Zero 3 1 5 I P - page 1
I NST ALLA TION &O PERA TION M ODELS 315I AND 315IP I CE M AKER ...
-
Sub-Zero 3 1 5 I P - page 2
SUB-ZERO ® is a registered trademark of Sub-Zero Freezer Company , Inc. As you follow these instructions, you will notice W ARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Sub-Zero equipment. Ther e are two types of potential hazards that may occur during installation. Another footnote w ...
-
Sub-Zero 3 1 5 I P - page 3
3 THANK Y OU Congratulations on the purchase of your Sub-Zero Model 315I ice maker (Model 315IP w ith drain pump). This restaurant-type ice maker is designed for home use. It produces the same high quality clear ice that you would e xpect from Sub-Zero. T he importance of the installation of the Model 315I(P) ice maker cannot be overemphasized. Ins ...
-
Sub-Zero 3 1 5 I P - page 4
4 SUB-ZER O MODELS 315I AND 315IP INST ALLA TION ICE MAKER REQUIREMENTS T o properly make and store ice, the Model 3 15I(P) requires access to air , potable water , 115 V AC electrical supply and a drain. The ice maker must be installed indoors, in a controlled environment. A IR SUPPL Y The ice maker uses a fan to take in room air at the front of t ...
-
Sub-Zero 3 1 5 I P - page 5
5 Dimensions in parentheses are in millimeters unless otherwise specified. SUB-ZER O MODELS 315I AND 315IP INST ALLA TION IMPORT ANT NOTE: The floor under the i ce maker must be at the same level as the surrounding finished floor . I MPORT ANT NOTE: W hen you move the unit using a hand truck or dolly , position the dolly on the side of the unit and ...
-
Sub-Zero 3 1 5 I P - page 6
Dimensions in parentheses are in millimeters unless otherwise specified. 6 SUB-ZER O MODELS 315I AND 315IP INST ALLA TION PLUMBING REQUIREMENTS Rough in the water supply line. Connect a 1 / 4 ” O D copper line to the house supply . Be sure to use an easily accessible shut-off valve between the supply and the unit. This shut-off valve should not b ...
-
Sub-Zero 3 1 5 I P - page 7
7 SUB-ZER O MODELS 315I AND 315IP INST ALLA TION MODEL 315I GRA VITY DRAIN The drain and inlet water tubes must be plumbed before connecting to the ice maker . R efer to the illustrations below . All horizontal runs of drain lines must have a 1 / 4 " (6) per 12" (305) fall. An air gap will likely be required b etween the ice maker drain t ...
-
Sub-Zero 3 1 5 I P - page 8
Dimensions in parentheses are in millimeters unless otherwise specified. 8 SUB-ZER O MODELS 315I AND 315IP INST ALLA TION MODEL 315IP DRAIN PUMP 1) Place the ice maker in front of the installa- tion opening. Adjust leveling legs to the a pproximate height. 2 ) R emove the control knob, control panel and control access panel. 3) Route the water inle ...
-
Sub-Zero 3 1 5 I P - page 9
9 SUB-ZER O MODELS 315I AND 315IP INST ALLA TION INST ALLA TION IMPORT ANT NOTE: T urn on the water supply and check all fittings for leaks. Make sure the e lectrical harness is attached to the solenoid. L et your customer know that the ice maker will not fill with water immediately and that the first batch of ice produced should be d iscarded. All ...
-
Sub-Zero 3 1 5 I P - page 10
Dimensions in parentheses are in millimeters unless otherwise specified. 10 SUB-ZER O MODELS 315I AND 315IP INST ALLA TION INST ALLA TION SIDE P ANELS W ith Model 315I(P), you must securely fasten the side panels to the adjacent cabinets and floor . Panels should be fastened to the floor and walls using ’L ’ brackets (hardware not provided). T ...
-
Sub-Zero 3 1 5 I P - page 11
11 SUB-ZER O MODELS 315I AND 315IP INST ALLA TION INST ALLA TION DOOR P ANEL INST ALLA TION Y ou should be sure of the door panel size and placement before proceeding with the installa- tion. If you have questions, contact your S ub-Zero dealer or cabinet supplier . Instruc- tions regarding sizing of the door panel are provided in the Sub-Zero Desi ...
-
Sub-Zero 3 1 5 I P - page 12
12 Install the door panel by engaging the tabbed bracket to the door first and then sliding the hinge side hardware over the positioning screws. Y ou will have a 1 / 4 " inch adjustment, up and down, side to side, with this hardware. Once you have the door in place, attach the remaining # 8 x 1 / 2 " screws to the hinge side mounting brac ...
-
Sub-Zero 3 1 5 I P - page 13
13 Dimensions in parentheses are in millimeters unless otherwise specified. SUB-ZER O MODELS 315I AND 315IP INST ALLA TION If you are storing or disposing of your old refrigerator or freezer , please do it safely . Remove the doors or tightly secure the doors closed. Child entrapment accidents can be tragic. CONT ACT INFORMA TION Sub-Zero Customer ...
-
Sub-Zero 3 1 5 I P - page 14
14 MODELS 315I AND 315IP FEA TURES Undercounter ice maker Model 315I has a gravity drain, while Model 315IP has a built-in pump to allow water to d rain into adjacent sink 24" (610) depth-true design for a complete integrated look Door accepts custom panels Automatic ice maker provides high-quality , clear ice Ice storage bin capacity of up to ...
-
Sub-Zero 3 1 5 I P - page 15
15 SUB-ZER O MODELS 315I AND 315IP OPERA TION ICE CUBES T he ice cubes are tapered cylinders about 1 1 / 4 " (32) in diameter at the widest end; taper down to 1" (25) wide at the top; and are 1 1 / 8 " (29) h igh. When the ice maker is adjusted properly , there should be a 1 / 4 " (6) indent in the base of the cube. The ice will ...
-
Sub-Zero 3 1 5 I P - page 16
16 SUB-ZER O MODELS 315I AND 315IP OPERA TION HO W THE ICE MAKER USES W A TER T he ice maker begins with a fixed charge of water that is contained in the reservoir . As the water is sprayed against the freezing surface, t he part of water that does not contain mineral impurities will freeze and stick to the ice cup molds. The water containing impur ...
-
Sub-Zero 3 1 5 I P - page 17
17 SUB-ZER O MODELS 315I AND 315IP OPERA TION CLEANING THE ICE ST ORAGE BIN T he ice storage bin should be sanitized occa- sionally . It is usually convenient to sanitize the bin after the ice making system has been c leaned, and the ice storage bin is empty . A sanitizing solution can be made of one ounce of household bleach and two gallons of hot ...
-
Sub-Zero 3 1 5 I P - page 18
18 SUB-ZER O MODELS 315I AND 315IP OPERA TION ICE MAKER CLEANING CLEANING THE ICE MAKING SYSTEM 1 ) O pen the door and turn the ice maker control knob to OFF . Refer to the illustration on page 19 for location of the control knob. 2) Scoop out all of the ice; either discard it or save it in a ice chest or cooler . 3) Pour four ounces of Sub-Zero ic ...
-
Sub-Zero 3 1 5 I P - page 19
19 SUB-ZER O MODELS 315I AND 315IP OPERA TION 1) Open the door and remove the control box c over . 2) Locate the cube size adjustment screw s hown in the illustration below . T o make fuller cubes, turn the screw clockwise about 1 / 4 turn. This will make the freezing cycle l onger . 3) T o shorten the freezing cycle and make cubes that are not as ...
-
Sub-Zero 3 1 5 I P - page 20
20 SER VICE CENTER Contact your Sub-Zero dealer or check the Locator section of our website, subzero.com, for the authorized ser vice center near est you. SUB-ZER O TROUBLESHOO TING GUIDE TROUBLESHOO TING GUIDE P R OBLEM POSSIBLE CAUSE POSSIBLE SOLUTION I ce maker does not I ce maker is unplugged Plug ice maker in operate Breaker tripped or fuse is ...
-
Sub-Zero 3 1 5 I P - page 21
21 SUB-ZER O TROUBLESHOO TING GUIDE TROUBLESHOO TING GUIDE P R OBLEM POSSIBLE CAUSE POSSIBLE SOLUTION U nit operates I ce may be stuck in the evaporator Check water supply – filter may but no ice falling in and the unit is ”frozen up” be restricted storage bin C heck inlet water valve – inlet screen may be restricted or valve does not opera ...
-
Sub-Zero 3 1 5 I P - page 22
22 SER VICE INFORMA TION If you do need service, be sure to have the model and serial number of your unit when y ou call. Y ou’ll find these numbers on the model and serial number plate located on the left sidewall of the reservoir . For warranty p urposes, you will also need the date of installation and the name of your Sub-Zero dealer . Record ...
-
Sub-Zero 3 1 5 I P - page 23
23 S UB- Z ERO F REEZER C OMP ANY P RODUCTS L IMITED W ARRANTY RESIDENTIAL USE ONL Y F ULL FIVE YEAR SEALED SYSTEM W ARRANTY LIMITED SIXTH THROUGH TWELFTH YEAR W ARRANTY ON THE SEALED SYSTEM FULL TWO YEAR W ARRANTY ON TOT AL PRODUCT* FULL FIVE YEAR SEALED SYSTEM W ARRANTY For five y ears fr om the date of original installation, your Sub-Zero w arra ...
-
Sub-Zero 3 1 5 I P - page 24
17307901 8 / 2005 S UB-ZERO FREEZER COMP ANY , INC. P . O. BO X 44130 MADISON, WI 53744-4130 800-222-7820 SUBZERO .COM ...
¿Tienes una pregunta acerca de Sub-Zero 3 1 5 I P?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sub-Zero 3 1 5 I P, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sub-Zero 3 1 5 I P probablemente compartirá una forma de solucionarlo.