-
QSC Audio 369 - page 1
TD-000232-00 revB WideLine Series Loudspeaker Sy stem User Manual WL218-sw subwoofer line array loudsp eaker DB218-sw dolly board AF218-sw subwoofer array fram e *TD-000232-00* 1675 MacArthur Blv d., Costa Mesa, CA, 92626 US A Main Number (714) 754 -6175 Sales & Marketing (714) 95 7-7100 or toll free (USA only ) (800) 854-4079 Customer Service( ...
-
QSC Audio 369 - page 2
2 IMPORT ANT SAFETY PRECAUTIONS Install in accordance with QSC Audio Product's instructions and under the supervision of a licensed Professional Engineer . WA R NI N G ! Before placing, installing, ri gging, or suspending any speaker product, inspec t all hardware, suspension, cabinets, transducers , brackets and associated equipment for damag ...
-
QSC Audio 369 - page 3
3 Introduction The WL218-sw is a dual 18-inch (457mm) subwoofer designed for su spended or g round stacked use in touring or installed concert a ppli- cations. With an impressive combination of sonic impact, low-frequency extension, and accuracy , the WL218-sw is an ideal compan ion for QSC's WideLine as well as other professional sound reinfo ...
-
QSC Audio 369 - page 4
4 Introduction (continued) DB115-sw Dolly Board 1- Pads 2- Casters 3- Stacking Recesses 4- Latches 5- Handling Cut-outs 6- Handles AF218-sw Array Frame 1- Ground stacking bump ers 2- Center support bar 3- Shackle holes (accept 3/4” (20 mm) screw pin anchor sha ckle) Use only shackle holes f or suspension of array! 4- Rigging plate, retain ing bol ...
-
QSC Audio 369 - page 5
5 Rigging Rigging the WideLine Array is simple and flexible. Enclosures are pinned together with quick-rele ase ball-lock pins. The AF218- sw array frame supports flown array applications and can be inverted for ground stack applications. The enclosures can also be ground stacked without a frame using the stacking feet and recesses integral to the ...
-
QSC Audio 369 - page 6
6 Rigging (continued) NOTE: All hardware/com ponents must be rat ed for the expected loads as determi ned by the Professional Eng i- neer responsible for suspension . Attaching WL218-sw Louds peaker to WL218-sw Loud- speaker 1- With the enclosures on dolly boards and facing downward, posi- tion two enclosures adjacent one another suc h that the fro ...
-
QSC Audio 369 - page 7
7 Rigging (continued) Adjusting the Angle Between Enclosures (Splay) The illustration below shows the rear receiver block of two enclo sures joined by the upper enclosure’ s rear link (enclosures an d ball lock pin lanyards omitted for clarity). Note the link is marked in two locations when extended. The unlabelled white line nearest the en d of ...
-
QSC Audio 369 - page 8
8 Rigging (continued) Array Frame Ground Stacki ng with the AF218-sw The AF218-sw array frame can be used for ground stacking up to four WL218-sw enclosures. There is no recommended proce- dure other then the requirement that all articulated joints, links, and ball lock pins be in their normal position (as if sus- pended) and be fully inserted and ...
-
QSC Audio 369 - page 9
9 INPUT/OUTPUT PIN 2+ 1+ 2430 LBS / 3400 LBS / 1700 LBS / 771 WEIGHT 206 LBS WORKING WL218-sw SUSPENSION OF THIS PRODUCT SHOULD BE DONE BY QUALIFIED PERSONS FOLLOWING SAFE RIGGING PRACTICES. OTHER RIGGING LIMIT ATIONS MA Y APPL Y . SEE WARNINGS IN THE QSC AUDIO PRODUCTS , LLC COSTA MESA CALIFORNIA, MADE IN USA 1+ 1+ 1- 2+ 2- 2- 1- 2+ NL1 NL2 1+ 1- ...
-
QSC Audio 369 - page 10
10 WL218-sw Specifications Configuration: 2 x 18-inch (457mm) ported subwoofer T ransducers: 8 ohm, 18-inch (457mm) cone transducer with 4-inch (102mm) voice coil, ceramic magnet Frequency Response 1 : 38 - 240 Hz (+/- 3 dB) Frequency Range 2 : 31 - 1200 Hz (-10 dB) Impedance: 4 ohms nominal (3.2 ohms minimum at 145 Hz) Continuous Power Capacity 3 ...
-
QSC Audio 369 - page 11
11 DB218-sw Specifications Material: Baltic birch plywood. 0.75-inch (18mm) Finish: Polymer paint, water based Weight: Net: 30 lb (13.6 kg) AF218-sw Specifications Material: Aluminum 6061-T6 Finish: n/a Working Load Limit Information: Dimensions- WL218-sw Component Weight 5:1 Design Factor 7: 1 Design Factor 10:1 Design F a ctor AF218-sw Array Fram ...
-
QSC Audio 369 - page 12
12 Dimensions- DB218-sw Dimensions- AF218-sw ...
-
QSC Audio 369 - page 13
13 ...
-
QSC Audio 369 - page 14
QSC Audio Products, LLC 1675 MacArthur Boulevard Costa Mesa, California 92 626 USA ©2006 “QSC” and the QSC logo are registered with the U.S. Patent and T rademar k Office. How to Contact QSC Audio Products Mailing address: QSC Audio Products, LLC 1675 MacArthur Boulevard Costa Mesa, CA 92626-1468 USA T elephone Numbers: Main Number (714) 754-6 ...
¿Tienes una pregunta acerca de QSC Audio 369?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con QSC Audio 369, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con QSC Audio 369 probablemente compartirá una forma de solucionarlo.