-
Fantom Vacuum FC285H - page 1
REPLACEMENT P ARTS IMPORT ANT SAFETY INSTRUCTIONS NAMES OF EACH P ART PREPARA TION BEFORE USE USING THE VACUUM CLEANER USING THE A TTACHMENTS EMPTYING THE DUST COMP ARTMENT CLEANING THE FILTERS CLEARING BLOCKAGES IN THE SUCTION HOSE AND CLEANING THE AGITA TOR ASSEMBL Y REPLACEMENT INSTRUCTIONS TROUBLESHOOTING LIMITED W ARRANTY Contents 1 3 4 6 8 10 ...
-
Fantom Vacuum FC285H - page 2
IMPORT ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - T o reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet when not in use ...
-
Fantom Vacuum FC285H - page 3
2 16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly . 19. Do not pick up items such as pieces of waste paper or cloth which looks as though they may cause the hose to become blocked. 20. Do not clean or store the vacuum cleaner in pl ...
-
Fantom Vacuum FC285H - page 4
Plug shown in figure may diffe r from actual plug attached to unit for your a rea. NAMES OF EACH P ART W ARNING: Operate vacuum cleaner only at the voltage specified on name plate. FRONT REAR Set the O N/OFF switch to " ON " to light the headlight. Headlight Handle Suction Hose A Dust Compartment Carrying Handle Dust Cup Knob ON/OFF Switc ...
-
Fantom Vacuum FC285H - page 5
Handle Upholstery T ool & Dusting Brush Hose Cuff Suction Inlet Caution : Do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the handle PREP ARA TIONS BEFORE USE Attaching th e suction hose A,B & a ttachments 1 2 Set the vacuum cleaner to the upright position. lnsert the handle as shown in the illus ...
-
Fantom Vacuum FC285H - page 6
PREP ARA TIONS BEFORE USE THERMAL SAFETY DEVICE IN MAIN BODY T o protect your vacuum cleaner motor from overheating, a thermal safety device has been built in. If your vacuum cleaner hose or air intake clogs up with dust or dirt, or if your dust bag becomes full and you continue to run the machine, the vacuum will shut off automatically to prevent ...
-
Fantom Vacuum FC285H - page 7
Parallel position This position is used for cleaning under furniture. 6 ADJUSTING THE HANDLE Upright po sition The handle is normally locked in this position for storage or when using the attachments. Push the handle forward until it locks. The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal, Parallel. Place your ...
-
Fantom Vacuum FC285H - page 8
The suction force can be adjusted to several settings between " MIN " and " MAX ". Rug/Floor (T ools) SELECTOR EDGE CLEANING This vacuum cleaner is equipped with an " edge cleaning" functi on f or c leaning ca rpet edges near baseboards and stationary furniture. USING THE V ACUUM CLEANER Nozzle Head HEIGHT ADJUSTMENT L ...
-
Fantom Vacuum FC285H - page 9
Release Button B Attachment Clamp Caution: When using one of the attachments during cleaning, set the vacuum cleaner to the upright position. 1 2 3 USING THE A TT ACHMENTS Press the release button B to disconnect the handle from the vacuum cleaner . Remove the attachments from the vacuum cleaner. Caution: When removing the attachments, pull them in ...
-
Fantom Vacuum FC285H - page 10
USING THE A TT ACHMENTS 9 Hose Attachment Line up notches, push hose in till it clicks. Handle Hose Cuff Suction Inlet Suction Hose A The T urbo Brush is attached on the main body . Open the tool cover and take out the Turbo Brush. T urbo Brush Attachment 1 2 T ool Cover Turbo Brush Inside Turbo Brush ...
-
Fantom Vacuum FC285H - page 11
Projection Groove 1 1 2 3 2 4 1 2 Trapdoor Release Lever Dust Cup Knob Turn the dust cup knob several times in the direction shown(clockwise) to empty the dust compartment. EMPTYING THE DUST COMP ARTMENT Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before cleaning. Emp ...
-
Fantom Vacuum FC285H - page 12
Remove the dust compartment.(refer to page 10) Clean the filter fins free of dirt with the forked end of cleaning utensil as shown. Prefilter Dust Compartment Ribs Main Filter 1 1 CLEANING THE FIL TERS 2 Set the dust compartment to the parallel position.Open the trapdoor,then push the release button C and pull out the main filter. 3 Clean the main ...
-
Fantom Vacuum FC285H - page 13
Bypass V alve (Inside) Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect Cleaning the agitator assembly 1 2 3 CLEARING BLOCKAGES AND CLEANING THE A GIT A T OR ASSEMBL Y the power cord from the wa ll outlet before clearing any blockages in the suction hose and cleaning th e agitator assembly . Clearing blockag ...
-
Fantom Vacuum FC285H - page 14
Place a new flat belt onto the motor shaft and pulley. 1 2 3 4 5 REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the O N/OFF swit ch to the"OFF" position and disconnect the po wer cord fro m the wall outlet before replacing an y of the parts be low . REPLACING THE FLA T BEL T Remove the bottom plate. (refer to page 14) Lift out the agit ...
-
Fantom Vacuum FC285H - page 15
Projection Groove 14 1 1 REPLACEMENT INSTRUCTIONS REMOVING THE BOTT OM PLA TE Set the vacuum cleaner to the parallel position and turn it over . REA TT ACHING THE BOTT OM PLA TE Insert the projection on the bottom plate into the groove on the nozzle housing and set the bottom plate in place. 3 Turn the vacuum over and place in the upright position. ...
-
Fantom Vacuum FC285H - page 16
Filter Cover HEP A Filter 2 2 1 1 Sub-Filter Air Inlet Cover Caution: Be sure that seal on the HEPA filter is inserted towards the inside of the vacuum cleaner. The filter cover should be correctly oriented when it is reattached. Do not reattach it upside down. 3 Insert a new HEP A filter with the seal to the inside of the vacuum cleaner. Reattach ...
-
Fantom Vacuum FC285H - page 17
The filter sensor will go on even the contents still away from the MAX mark as vacuuming a large amount of fine dust. In this case, please clean the filters. (refer to page 1 1) If the suction force is becoming weak or when the cleaner is vacuuming noisily , the filter sensor will go on. 1 2 FIL TER SENSOR Filter Sensor MAX mark 16 ...
-
Fantom Vacuum FC285H - page 18
If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring. Turn the ON/OFF switch to the "OFF" position, disconnect the power cord from the wall outlet, and ...
-
Fantom Vacuum FC285H - page 19
FAN TOM, 94 Main Mill Street, Door 16, Plattsburgh, N.Y . 12901 RETURN TO F ANTOM , 94 Main Mill Street, Door 16 , Plattsburgh , N.Y . 12901 OWNERSHIP REGISTRA TION CARD Please fill out and mail the product registration card wit hin ten (10) days of purchase. The registration will enable us to contact you in the unlikely e vent of a p roduct safety ...
¿Tienes una pregunta acerca de Fantom Vacuum FC285H?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Fantom Vacuum FC285H, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Fantom Vacuum FC285H probablemente compartirá una forma de solucionarlo.