-
Electrolux EWG127410W - page 1
EWG 127410 W .............................. .................. ................ ............ .......... ....... EN WA SHING MACHINE USER MANUAL ...
-
Electrolux EWG127410W - page 2
Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information 2 Product description 4 Control panel 5 First use 6 Personalisation 6 Daily use 7 Helpful hints and tips 10 Washing programmes 11 Care and cleaning 13 What to do if... 17 Technical data 19 Consumption v alues 20 Installation 20 Electrical conne ...
-
Electrolux EWG127410W - page 3
INSTALLATION • This appliance is heavy. Care should be taken when moving it. • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. • All packing and transit bolts must be re- moved before use. Serious damage can occur to the product and to property if this is not adhered to. S ...
-
Electrolux EWG127410W - page 4
PRODUCT DESCRIPTION Your new appliance meets all modern requir ements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows to- tal use of detergent and reduces wa ter consumption so saving energy. 1 2 7 8 9 3 4 5 6 10 1 Detergent dispenser drawer 2 Control panel 3 Door opening hand le 4 ...
-
Electrolux EWG127410W - page 5
CONTROL PANEL Below is a picture of the control panel. It shows th e programme sel ector dial as well as the buttons, pilot light and the display. These are presen ted by relevant numbers on the following pages. 1 2 4 5 6 7 8 9 10 3 1 Programme selector dial 2 TEMPERATURE button 3 SPIN button 4 EASY IRON button 5 EXTRA RINSE button 6 DELAY START bu ...
-
Electrolux EWG127410W - page 6
EXTRA RINSE This appliance is desi gned to save energy. If it necessary to rinse the laundry using an extra quantity of water (extra rinse), select this option. Some additional rinses will be performed. This option is recommended for people who are allergic to detergents, and in areas where the water is very soft. DELAY START The programme can be d ...
-
Electrolux EWG127410W - page 7
DAILY USE Load the laundry Open the door by care fully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Make sure that no laundry stays between the seal and the door. There is a risk of wa- ter leakage or damage to the laundry. Measure out the detergent and th ...
-
Electrolux EWG127410W - page 8
SELECT THE TEMPERATURE BY PRESSING BUTTON 2 By selecting a programme, the appliance proposes automatically a default tempera- ture. Press this button rep eatedly to increase or decrease the temperature, if you want your laundry to be washed at a different temper- ature. REDUCE THE SPIN SPEED BY PRESSING BUTTON 3 By selecting a programme, the applia ...
-
Electrolux EWG127410W - page 9
Soil Level Icon Type of fab ric Daily For d aily soiled items Light For slightly soiled items Quick For very slightly soiled items Super Quick 1) For items used or worn for a short time Refresh 1) 2) For refreshing items only Super Re- fresh 1) 2) For refreshing a very few items only 1) We recommen d you to reduce the loa d sizes (see Washing progr ...
-
Electrolux EWG127410W - page 10
Stand by : once the programme has finish- ed after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any but- ton the appliance will come out of the ener- gy saving status. HELPFUL HINTS AND TIPS SORTING OUT THE LAUNDRY Follow the wash code symbols on each garment la bel and the ma nufactu ...
-
Electrolux EWG127410W - page 11
Your appliance incorpor ates a recirculation system which allows an optimal use of the concentrated detergent. Follow the product manufacturer’s recom- mendations on quanti ties to use and do not exceed the «MAX» mark in the de- tergent dispenser drawer . QUANTITY OF DETERGENT TO BE USED The type and quantity of detergen t will de- pend on the ...
-
Electrolux EWG127410W - page 12
Programme - Maximum an d Minimum Tempera- ture - Cycle De scription - Maximum Spin Sp eed - Maximum Fabrics Load - Type of Laundry Options Detergent Com- partment Delicates 40° - Cold Main wash - Rinses Maximum spin speed 700 rpm Max. load kg 3 - Red. load kg 1.5 1) Delicate fa brics normally soiled delicate items. SPIN REDUCTION NIGHT CYCLE RINSE ...
-
Electrolux EWG127410W - page 13
Programme - Maximum an d Minimum Tempera- ture - Cycle De scription - Maximum Spin Sp eed - Maximum Fabrics Load - Type of Laundry Options Detergent Com- partment Wool 40° - Cold Main wash - Rinses Maximum spin speed 900 rpm Max. load 2 kg Washing programme for machine washable wool as well as for hand washable woollens and delicate fab- rics. Not ...
-
Electrolux EWG127410W - page 14
open after a wash will also help to preserve the door seal. MAINTENANCE WASH With the use of low temperature washes it is possible to get a build up of residues in- side the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: • The drum should be empty of laundry. • Select the hottest cotton wa ...
-
Electrolux EWG127410W - page 15
DRAIN PUMP The pump sh ould be inspected regularly and particularly if: • the appliance does not empty and/or spin; • the appliance makes an unus ual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “What to do if...” for more details). Warning ...
-
Electrolux EWG127410W - page 16
8. Replace the filter in to the pump by in- serting it correctly into the special guides. Screw the pump cover firmly by turning it clockwise. 1 2 Warning! When the appliance is in use and depend- ing on the programme selected there can be hot water i n the pump. Never remove the pump cov er during a wash cycle, always wait until the appliance has ...
-
Electrolux EWG127410W - page 17
Important! Every time you drain the water through the emergency emptying hose you must pour 2 litres of water int o the main wash compartment of the detergent drawer and then run th e drai n programme. This will activate t he ECO Valve device avoiding that part of the de tergent remain s unused at next washing. WHAT TO DO IF... Certain problems are ...
-
Electrolux EWG127410W - page 18
Problem Possible cause/ Solution The machine doe s not empty and/ or does not spin: The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. • Clean the drain filter. An option or a programme that ends with the water still in the tub or a that eliminates all th e spinning phases has been selected. ? ...
-
Electrolux EWG127410W - page 19
Problem Possible cause/ Solution The machine vib rates or is noisy: The transit bolts and packing have not been re- moved. • Check the correct installation of the appli- ance. The support feet have not been adjust ed • Check the correct levelling of the appliance. The laundry is not evenly distributed in the drum. • Redistribute th e laundry. ...
-
Electrolux EWG127410W - page 20
Spin Speed Maximum 1200 rpm 1) Connect the wa ter inlet hose to a water tap with a 3/4' ' thread. CONSUMPTION VALUES The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, th e water and ambient temperature. Programmes Load (kg) Energy con- sumption (kWh) Water con- sumption (li- tr ...
-
Electrolux EWG127410W - page 21
2. Remove the power supply cable and the draining hose from the hos e holders on the rear of the appliance. 3. Unscrew the three bolts. 4. Slide out the relevant plastic spacers. 1 2 5. Fill the smaller upper hole and the two large ones with the corresponding plas- tic plug caps supplie d in the bag con- taining the instruction booklet. POSITIONING ...
-
Electrolux EWG127410W - page 22
RAISING THE APPLIANCE Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws, the wood panel must extend beyond the front feet. If possible install the appliance in one of the ...
-
Electrolux EWG127410W - page 23
Warning! Installation should comply with local water authority and building re gulations’ requirements. The appliance must be connected to a cold water supply. A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe oper- ation of the appliance. If you cannot make the cold water con- nection direct from the rising mains, you may be ab ...
-
Electrolux EWG127410W - page 24
3 pin Min. 60 cm (23.6”) Min. 90 cm (35.4”) The drain hose may be extended to a maxi- mum of 4 metres. An additional drain hose and joining piece is ava ilable from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm. If your drain hose looks like th is (see below) you do not require the “U” piece”. ...
-
Electrolux EWG127410W - page 25
Loop Important! Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. IN THE INTEREST OF THE ENVIRONMENT The appliance should be connected to the FOUL drainage system, the water will then be taken to a s ...
-
Electrolux EWG127410W - page 26
SHOWER BA TH BIDET WASHING MACHINE DISHWASHER RAINWA TER ‘RUN-OFF’ SURF ACE WA TER DRAINS & SEWERS UNTREA TED DISCHARGE RIVER RIVER FOUL DRAIN FOUL SEWERS SEWAGE TREA TMENT WORKS TREA TED DISCHRGE SINK TOILET ELECTRICAL CONNECTION Information on the el ectrical connection is given on the rating plate on the inner edge of the appliance door. ...
-
Electrolux EWG127410W - page 27
Should the appliance power supply cable need to be replaced, this MUST be carried out by a Service Centre. The power supply ca ble must be easily accessible after installing the machine. ENVIRONMENT CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to ...
-
Electrolux EWG127410W - page 28
Fig. 2 a) Door The dimensions of the door sh ould be: - width 595-5 98 mm - thickness 16 -22 mm The height X depends on the height of the adjacent furniture's base (Fig. 3 ). Fig. 3 Ø 35 mm 14 mm 16-22 mm 22±1,5 mm 416 mm X 595-598 mm b) Hinges To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth 12.5-14 mm depending on ...
-
Electrolux EWG127410W - page 29
Fig. 6 A B C If the door has to be opened f rom left to right, invert the position of the plates E , the magnet D and the plate C . Mount the counter-magnet D and the hinges A as pre- viously described (Fig. 7 ). Warning! Do not remove the screw B . Fig. 7 A B C E D Recommendations regarding the con- struction and fitting of a base when the install ...
-
Electrolux EWG127410W - page 30
With the appliance installed adjust all four feet ensuring the mach ine is stable, and a clearance of approximately 5 mm is left be- tween the top of the machine and the un- derside of the worktop. A final check for stability should be carried out with the machine on spin with a load, this will identify the need for any further fine adjustment to t ...
-
Electrolux EWG127410W - page 31
electrolux 31 ...
-
Electrolux EWG127410W - page 32
www.electrolux.com/shop 132926440-A -152012 ...
¿Tienes una pregunta acerca de Electrolux EWG127410W?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Electrolux EWG127410W, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Electrolux EWG127410W probablemente compartirá una forma de solucionarlo.