-
Speco Technologies EZVR4/8 - page 1
EZVR4/8 DVR SATA HDD User ’ s Manual S peco T echnologies 200 New Highway Amityville, NY 1 1701 800-645-5516 www .specotech.com ...
-
Speco Technologies EZVR4/8 - page 2
2 ...
-
Speco Technologies EZVR4/8 - page 3
3 CAUTI ON RISK OF ELECTRICAL SHOCK. DO NOT OPEN ! CAUTIO N: T O REDUCE THE RISK OF ELECTR I CAL SHOCK, DO N OT R E M O V E CO V E R (O R B A CK ) , NO U S E R S E R V I C E A B L E P A RT S R E F E R SE R V I C IN G TO QU A L I F I E D S E RV I C E P E R S O N N E L. Safety Precautions The lightning flash with arrowhead symbol, within an equilater ...
-
Speco Technologies EZVR4/8 - page 4
4 Before installing the unit, be sure to thor oughly re view and follow the instructions in this User’s Manual. Pay particular attention to the parts that are marked NOTICE . When connecting with external application, first turn the po wer OFF and follow manual instructions for appro priat e installation. 1. This manual contains informatio n for ...
-
Speco Technologies EZVR4/8 - page 5
5 FCC St atement: W A R N I N G This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cau se harmful interference. (2) This device must accept any interference received includi ng interference that may cause undesired operation." * Federal Communications Commission (FC ...
-
Speco Technologies EZVR4/8 - page 6
6 1. The package 2. Un-packed M O D E L N O . : S E R N O . : M A D E I N T A I W A N M O D E L N O . : S E R N O . : M A D E I N T A I W A N 3. T ake the unit out from t he package 4. Put on a flat desk 5. Connect your camera cables to the BNC connecto rs on the re ar . 6. Connect your monitor cable to the BNC connector labeled “Monitor” on th ...
-
Speco Technologies EZVR4/8 - page 7
7 Please operate the keypad function according to the DVR model that y ou purchased S c r e e n m o d e EZVR4 1. : Quad screen mode button 2. CHANNEL 1 : Channel 1 full screen button 3. CHANNEL 2 : Channel 2 full screen button 4. CHANNEL 3 : Channel 3 full screen button 5. CHANNEL 4 : Channel 4 full screen button S c r e e n m o d e EZVR8 1. / : Sp ...
-
Speco Technologies EZVR4/8 - page 8
8 R e c o r d m o d e EZVR4 / EZVR8 1. 24H : 24 hour recording mode 2. 72H : 72 hour recording mode 3 . 2 4 0 H : 240 hour recording mode 4 . 4 8 0 H : 480 hour recording mode 5. 960H : 960 hour recording mode 6 . R E C : Press this button to start recording. Press again to stop. M i s c e l l a n e o u s EZVR4 / EZVR8 1 . M E N U : Press this butt ...
-
Speco Technologies EZVR4/8 - page 9
9 REAR P ANE L CONNECTOR Power cord in 12VDC / 5A, Power Switch (ON / OFF) EZVR4: Camera 1 ~ 4 input BNC type Main monitor output x 2 Audio channel input x 4 and output x 2 – RCA T ype Alarm / Relay / RS485 connector EZVR8: Camera 1 ~ 8 input BNC type ...
-
Speco Technologies EZVR4/8 - page 10
10 B o o t i n g U p D e t e c t i n g t h e h a r d d i s k I n d i c a t o r : Live: Playback: Recording Overwrite Alarm Input Alarm Output HDD inst alled Live screen Live mode Video loss Key lock Forward Reverse Pause ...
-
Speco Technologies EZVR4/8 - page 11
11 Remote controller The keys on the remote co ntrol have the same functions as the front keyboard of the unit. User please operate according to the DVR model that you purchased 4 C H 8 C H ...
-
Speco Technologies EZVR4/8 - page 12
12 Main MENU – Ti me Setu p 1. Press ENTER to select Time Set. Pr ess ENTER again to display the cursor. 2. Use the left or right buttons to select t he item you wish to adjust, then press ENT ER to change the value. 3. Press MENU to return to the previous screen and move the cu rsor to Apply. 4. Press ENTER to confirm. 5. Select On or Off for Da ...
-
Speco Technologies EZVR4/8 - page 13
13 Main MENU – Audio Record Use direction buttons to select Audio Re cord. Press ENTER to select On or Off. Diagram Notice: 1. Audio channel input x 4 and output x 2 2. Audio is always on input 1 when DVR is on QUAD screen of live/playback mode 3. T o hear audio input 1 ~ 4, please select full screen 1 ~ 4 on liv e/playback mode 4. When 960H is s ...
-
Speco Technologies EZVR4/8 - page 14
14 Main MENU – Alarm Input Use direction buttons to select Alarm Input. Press the Enter button to choose the type of sensor input (Normally Open - NO or Normally Closed - NC). To disable the alarm mo de switch to the Off position.. Main MENU – Alarm Out put Use direction buttons to select Alarm Output. Press the Enter button to turn the output ...
-
Speco Technologies EZVR4/8 - page 15
15 Alarm Input The Alarm Signal type depends upon the Alarm Sensor polarity defined as NO (Normal Open) or NC (Normal Close). Alarm Output: Relay: NO + COM or NC + COM Door c losed Door o pen Relay: NO (Normal open) Alarm trigger NO COM NC COM Relay: NC (Normal Close) ...
-
Speco Technologies EZVR4/8 - page 16
16 Main MENU – Auto Re cord Use direction buttons to select Auto Record. Press the Enter button to choose On or Of f. If switched to OFF then Auto Record is disabled. When Auto Record is set to On, the EZVR4/8 will start recording agai n af ter 2 minutes of inactivity after being manually stopped. Main MENU – Over write HDD Use direction button ...
-
Speco Technologies EZVR4/8 - page 17
17 Main MENU – S t atus Bar Use direction buttons to select Status Bar . Then press ENTER to select ON o r Off . If set ON, the status bar will show date-time and status icons . If set Off the status bar will hide date-time and status icons . Main MENU – Language Use direction buttons to select La nguage. Press Enter button to choose a languag ...
-
Speco Technologies EZVR4/8 - page 18
18 Main MENU – Exit Use direction buttons to select Exit. Press Enter button to leave the menu. Playback mode – Note: Instructions a ppear on the screen af ter selecting “Search ” Press SEARCH to enter the playback mode. Press ENTER to select a date and time. Use the left or right arrows to select the item you wish to change, then press ENT ...
-
Speco Technologies EZVR4/8 - page 19
19 Press ENTER to sta rt the searching. W a it until the unit st arts to playba ck. Backup mode Note: Plug in a USB device before st arting the backup Y ou must first playback an event using instructions from the previous p age. When the event you wish to backup appears on the screen, press the BACKUP button to select the start time. Press the BACK ...
-
Speco Technologies EZVR4/8 - page 20
20 Player Sof tware Main Screen Please operate the player software accordin g to the DVR mo del that you purchased Click icon to select the file to play . It will be in .vvf format ...
-
Speco Technologies EZVR4/8 - page 21
21 St arts to play; 1 Open File 8 Fast Forward 2 Fast Reverse 9 Capture (Save to C: Capture & Clipboa rd) 3 Play Reverse 10 Full Screen mode 4 Previous Fr ame 11 Quad Screen mode 5 Pause 12 S plit Screen mode (Only EZVR8 include d) 6 Next Frame 13 Export to A VI format 7 Play AV I Button: .vvf file export to .avi format Select export channel(s ...
-
Speco Technologies EZVR4/8 - page 22
22 Specifica tions Model EZVR4 EZVR8 Input 4 CH Inputs 1.0Vp-p, 75ohm (BNC Type) 8 CH Inputs 1.0Vp-p, 75ohm (BNC Type) Output Main monitor composite video (BNC type ) x 2 S/N Ratio More than 40dB Color 6.7 Million Monitoring Method Channel Display 1 / 4 channel display 1 / 4 / 8 channel display Live Screen Resolution 720(H) x 448(V) Active Pixels(N ...
-
Speco Technologies EZVR4/8 - page 23
23 ...
-
Speco Technologies EZVR4/8 - page 24
24 85-DM4063-A004G B ...
¿Tienes una pregunta acerca de Speco Technologies EZVR4/8?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Speco Technologies EZVR4/8, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Speco Technologies EZVR4/8 probablemente compartirá una forma de solucionarlo.