-
Navico Class B Transceiver NAIS-300 - page 1
N A I S 3 0 0 MANUAL NAVICO NAIS-300 Class B Transceiver English ...
-
Navico Class B Transceiver NAIS-300 - page 2
2 Contents The technical data, information and illustrations contained in this publication were to the best of our knowledge correct at the time of going to print. W e reserve the right to change specications, equipment, installation and maintenance instructions without notice as part of our policy of continuous development and improv ement. No ...
-
Navico Class B Transceiver NAIS-300 - page 3
Contents 3 Contents 1 Introduction 5 1.1 Gener al overview 5 1.2 SimNet/NMEA2000 6 2 I ns t a l l at i o n 7 2.1 Gener al 7 2.2 Mounting 7 2.3 Cabling 8 2.4 SimNet/NMEA2000 cable 9 SimNet (300-N model only) 9 NMEA2000 (300-L model only) 10 2.5 NMEA0183-HS (RS232) 10 2.6 NMEA0183-HS (RS485) 10 2.7 T ransmit disable switch 10 2.8 GPS antenna 10 2.9 V ...
-
Navico Class B Transceiver NAIS-300 - page 4
4 Contents RX 18 4.3 Enable/disable switch (Silent Mode) 18 5 Appendix 19 5.1 Maintenance 19 5.2 T roubleshooting 19 5.3 Accessories 19 5.4 Product specications 2 0 5.5 Dimensions 22 5.6 Service and warr anty 22 5.7 Declar ation of Conformity (EU) 23 ...
-
Navico Class B Transceiver NAIS-300 - page 5
Introduction 5 1 Introduction 1.1 General overview The NAIS-300 is a Class B T ransponder that’ s purpose is to transmit the position and other information about y our vessel, to other AIS equipped v essels. It is housed in a rugged waterproof enclosure to withstand the rigors of the marine environment. Th e NA I S - 30 0 us e s a s op h i st i c ...
-
Navico Class B Transceiver NAIS-300 - page 6
6 Introduction 1.2 SimNet/NMEA2000 SimNet is Navico’ s proprietary high speed data bus network compatible with NMEA2000. It provides intelligent sharing of data and control information between a wide range of marine electronics and instruments. ...
-
Navico Class B Transceiver NAIS-300 - page 7
Installation 7 2 I n s t a ll a ti o n 2.1 General The NAIS-300 is designed to be mounted on a flat surface somewhere out of sight, but easily accessible. However , to determine the best possible location, you need to consider how and where, you are going to run the cabling from the sides of the unit. The NAIS-300 is very simple to install, howev e ...
-
Navico Class B Transceiver NAIS-300 - page 8
8 Installation 2.3 Cabling Once you hav e secured your NAIS-300 to a flat surface, you will need to connect the power , SimNet/NMEA2000 and RS232 cables supplied with the unit. The RS485 cable and switch are not supplied, but would be fitted in the same manner . With reference to the connector wiring, Figure 2.1 and the assembly diagram, Figure. 2. ...
-
Navico Class B Transceiver NAIS-300 - page 9
Installation 9 C h o o s e t h e n i p p le s di r e ct l y a b o v e t h e pa r t s o f t h e c o n n e c to r yo u w an t t o wi r e i n t o a n d c u t o f f t h e t o p s e c t i o n t o t h e re q u ir e d d i a me t e r . P as s the po we r a nd RS 232 c abl es th rou gh th e c r ad le and t hen t hro ugh t he ho le in th e r esp ec tiv e ni ...
-
Navico Class B Transceiver NAIS-300 - page 10
10 Installation NMEA2000 (300-L model only) With the supplied cable connected to the NAIS-300, connect the other end into the supplied T -connector , then connect this into the vessels NMEA2000 network. 2.5 NMEA0183-HS ( RS232 supplied ) Th i s d at a ca b le is us e d t o c o nn e ct th e N A IS - 3 00 to a P C or la p t op in or d er to co n g ...
-
Navico Class B Transceiver NAIS-300 - page 11
Installation 11 The cable can be routed in the molding to drop down directly underneath, or by breaking out the thin traps, the cable can be routed out of the side of the antenna. Alt er nat iv el y , th e ant enn a ma y b e fix e d o n a s tan da rd 1” thr ea ded mo un tin g pol e ( No t s up pli ed) . At ta ch the s upp lie d mou nt ing ba se t ...
-
Navico Class B Transceiver NAIS-300 - page 12
12 Installation Th e mo s t im p o rt a n t f a ct o r i n th e pe r f or m a n ce o f a n y AI S tr an s ce i v e r w i l l b e t h e q u a li t y an d p os i t io n i ng o f t h e an t e nn a . As the range of VHF signals are go verned by line of sight, the antenna should be placed as high as possible, while remaining clear of any metallic object ...
-
Navico Class B Transceiver NAIS-300 - page 13
Installation 13 The antenna cable should terminate in a standard marine PL259 plug fitting. Connect the antenna plug to the socket on the side of the unit and screw the retaining collar down. Figure 2.3. To avoid possible water damage to the transceiver, it is recommended that all cables are looped to provide a drip path. ...
-
Navico Class B Transceiver NAIS-300 - page 14
14 Installation ...
-
Navico Class B Transceiver NAIS-300 - page 15
Configuration 15 3 Conguration 3.1 General Before the NAIS-300 can become fully functional, it will be necessary to load the following information about your vessel into the unit: V essels Name Call Sign MMSI Number V essels Dimensions V essel T ype In order to enter this information, you will need to connect your NAIS-300 to y our PC or laptop ...
-
Navico Class B Transceiver NAIS-300 - page 16
16 Configuration For security reasons the MMSI of the vessel cannot be changed once programmed. Do not programme the MMSI unless you are certain you have the correct information. Please check the number entered carefully. If the MMSI programmed is incorrect the AIS transponder will need to be returned to the supplier for factory reset. Should it be ...
-
Navico Class B Transceiver NAIS-300 - page 17
Operation 17 4 Operation 4.1 General The NAIS-300 has a limited user interface, consisting of a transmit enable/disable switch, (not supplied), and four indicators on the top of the unit, they are: PWR [Green] - P ower/GPS Lock Status/Silent Mode BIIT [R ed] - Built In Integrity T est TX [Y ellow] - T ransmit RX [Blue] - AIS Message R eceived 4.2 I ...
-
Navico Class B Transceiver NAIS-300 - page 18
18 Operation 6 flashes - noise threshold exceeded 7 flashes - voltage supply fault The “ BII T” me ssa ge wi ll re mai n the re un til th e fau lt is cle ar ed by th e N AI S- 300 ci rc uit ry , or the u nit ha s bee n rep ai red . TX After the initial five seconds the LED will then go out. It will light for one second every time the unit tr an ...
-
Navico Class B Transceiver NAIS-300 - page 19
Appendix 19 5 Appendix 5.1 Maintenance P eriodically check that the cables are secure and that the connectors have not work ed their wa y loose. 5.2 Troubleshooting These simple checks should be carried out before seeking technical assistance and may sa ve time and expense. General Symptom Possible Cause Remedy Unit will not switch on F ault y conn ...
-
Navico Class B Transceiver NAIS-300 - page 20
20 Appendix 5.4 Product specications AIS Type Class B for use on non-SOLAS cr aft VHF Receiver R eceiver type Dual TDMA (shared DSC) Sensitivity < -107dBm for 20% PER T ransmit power 2W att T ype Approv al Meets IEC62287-1 GPS Receiver R eceiver type Integral 16 channel receiv er EMC IEC60945 Power V oltage 10.8 – 15.6VDC Current <0.5A S ...
-
Navico Class B Transceiver NAIS-300 - page 21
Appendix 21 NMEA2000 AIS PGNs 129038 Class A P osition R eport 129039 AClass B P osition R eport 129040 Class B Extended P osition R eport 129792 DGNSS Broadcast Binary Message 129793 UT C and Date R eport 129794 Class A Static and V oyage R elated Data 129795 Addressed Binary Message 129796 Acknowledge 129797 Binary Broadcast Message 129798 SAR Ai ...
-
Navico Class B Transceiver NAIS-300 - page 22
22 Appendix 5.5 Dimensions Figure 5.1 - NAIS-300 dimensions Figure 5.2 - GPS Antenna dimensions 5.6 Service and warranty If it is necessary to hav e a unit repaired, please contact your local authorized dealer . F or worldwide warr anty details and a list of authorised Navico agents please refer to the W arranty Card supplied with this unit. NAIS-3 ...
-
Navico Class B Transceiver NAIS-300 - page 23
Appendix 23 English Hereby , Navico AS declares that this NAIS-300 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Finnish Navico AS vakuuttaa täten että NAIS-300 tyyppinen laite on direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen. Dutch Hie ...
-
Navico Class B Transceiver NAIS-300 - page 24
www.navico.com ...
¿Tienes una pregunta acerca de Navico Class B Transceiver NAIS-300?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Navico Class B Transceiver NAIS-300, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Navico Class B Transceiver NAIS-300 probablemente compartirá una forma de solucionarlo.