-
Stanley Black & Decker PD45 - page 1
© 201 1 Stanley Black & Decker , Inc. New Britain, CT 06053 U.S.A. 17472 4/2013 V er . 8 S afety , O pera tiOn and M aintenance USer ManUaL PD45 HYDRAULIC POST DRIVER ...
-
Stanley Black & Decker PD45 - page 2
...
-
Stanley Black & Decker PD45 - page 3
PD45 User Manual ◄ 3 T ABLE OF CONTENTS SERVICING THE ST ANLEY HYDRAULIC POST DRIVER. This manual contains safety , operation, and routine maintenance instructions. Stanley Hydraulic T ools recommends that servicing of hydraulic tools, other than routine maintenance, must be performed by an authorized and certied dealer . Please read the follo ...
-
Stanley Black & Decker PD45 - page 4
4 ► PD45 User Manual SAFETY SYMBOLS Always observe safety symbols. They are included for your safety and for the protection of the tool. LOCAL SAFETY REGULA TIONS Enter any local safety regulations here. Keep these instructions in an area accessible to the operator and mainte- nance personnel. Safety symbols and signal words, as shown below , are ...
-
Stanley Black & Decker PD45 - page 5
PD45 User Manual ◄ 5 SAFETY PRECAUTIONS T ool operators and maintenance personnel must always comply with the safety precautions given in this manual and on the stickers and tags attached to the tool and hose. These safety precautions are given for your safety . Re- view them carefully before operating the tool and before performing general maint ...
-
Stanley Black & Decker PD45 - page 6
6 ► PD45 User Manual T OOL STICKERS & T AGS SAFETY T AG P/N 15875 (Shown smaller then actual size) DANGER DANGER READ OPERA TION MANUAL AND SAFETY INSTRUCTIONS FOR THIS TOOL BEFORE USING IT . USE ONL Y P ARTS AND REP AIR PROCEDURES APPROVED BY ST ANLEY AND DESCRIBED IN THE OPERA TION MANUAL. T AG TO BE REMOVED ONL Y BY TOOL OPERA TOR. SEE OTH ...
-
Stanley Black & Decker PD45 - page 7
PD45 User Manual ◄ 7 HOSE TYPES The rated working pressure of the hydraulic hose must be equal to or higher than the relief valve setting on the hy- draulic system. There are three types of hydraulic hose that meet this requirement and are authorized for use with Stanley Hydraulic T ools. They are: Certied non-conductive — constructed of the ...
-
Stanley Black & Decker PD45 - page 8
8 ► PD45 User Manual HOSE RECOMMENDA TIONS Oil Flow Hose Lengths Inside Diameter USE ( Press/Return) Min. Working Pressure GPM LPM FEET METERS INCH MM PSI BAR Certied Non-Conductive Hose - Fiber Braid - for Utility Bucket T rucks 4-9 15-34 up to 10 up to 3 3/8 10 Both 2250 155 Conductive Hose - Wire Braid or Fiber Braid -DO NOT USE NEAR ELECTR ...
-
Stanley Black & Decker PD45 - page 9
PD45 User Manual ◄ 9 HTMA/EHTMA REQUIREMENTS Flow Range Nominal Operating Pressure (at the power supply outlet) System relief valve setting (at the power supply outlet) Maximum back pressure (at tool end of the return hose) Measured at a max. uid viscosity of: (at min. operating temperature) T emperature: Sufcient heat rejection capacity to ...
-
Stanley Black & Decker PD45 - page 10
10 ► PD45 User Manual OPERA TION PRE-OPERA TION PROCEDURES CHECK THE POWER SOURCE 1. Using a calibrated owmeter and pressure gauge, check that the hydraulic power source develops a ow of 7–9 gpm/26–34 lpm at 2000 psi/140 bar . 2. Make certain the hydraulic power source is equipped with a relief valve set to open at 2100–2250 psi/140 b ...
-
Stanley Black & Decker PD45 - page 11
PD45 User Manual ◄ 1 1 CHARGING THE ACCUMULA T OR ACCUMULA TOR TESTING PROCEDURE T o check or charge the accumulator the following equip- ment is required: • Accumulator T ester (Part Number 02835). • Charging Kit Assembly (P/N 31254); (includes a regulator , hose and ttings). • NITROGEN bottle with an 800 psi/56 bar minimum charge. 1. R ...
-
Stanley Black & Decker PD45 - page 12
12 ► PD45 User Manual T OOL PROTECTION & CARE • Make sure all couplers are wiped clean before con- nection. • The hydraulic circuit control valve must be in the OFF position when coupling or uncoupling hydrau- lic tools. Failure to do so may result in damage to the quick couplers and cause overheating of the hy- draulic system. • Always ...
-
Stanley Black & Decker PD45 - page 13
PD45 User Manual ◄ 13 TROUBLESHOOTING If symptoms of poor performance develop, the following chart can be used as a guide to correct the problem. When diagnosing faults in operation of the tool, always make sure the hydraulic power source is supplying the cor - rect hydraulic ow and pressure as listed in the table. Use a owmeter know to be ...
-
Stanley Black & Decker PD45 - page 14
14 ► PD45 User Manual SPECIFICA TIONS Weight (Standard) ................................................................................................................................. 65 lbs/29.5 kg Weight (Extended anvil) .......................................................................................................................... ...
-
Stanley Black & Decker PD45 - page 15
PD45 User Manual ◄ 15 PD45131 P ARTS ILLUSTRA TION ...
-
Stanley Black & Decker PD45 - page 16
16 ► PD45 User Manual PD45131 P ARTS LIST ITEM P ART NO. QTY DESCRIPTION 1 15190 1 TOP PLA TE 2 1 1588 1 ACCUMULA TOR V AL VE BLOCK 3 04374 4 LOCK NUT 5/8-18 4 00293 1 O-RING 5 15188 1 V AL VE SPOOL 6 07493 1 MALE O-RING PLUG 7 20499 1 CHARGE V AL VE 8 07479 1 ACCUMULA TOR DIAPHRAGM 9 04381 2 BACK-UP RING 10 04379 2 O-RING 11 04378 1 PORTING BLOC ...
-
Stanley Black & Decker PD45 - page 17
PD45 User Manual ◄ 17 PD45132 P ARTS ILLUSTRA TION ...
-
Stanley Black & Decker PD45 - page 18
18 ► PD45 User Manual PD45132 P ARTS LIST ITEM P ART NO. QTY DESCRIPTION 1 07493 1 O-RING PLUG–MALE 2 20499 1 CHARGE V AL VE 3 20387 1 PLUNGER 4 12100 4 STEEL BALL 3/8 DIA. 5 00899 2 HHCS 1/4-20 UNC × 1/2 GR5 6 20386 1 COVER PLA TE 7 04374 4 LOCK NUT 5/8-18 8 20390 1 LIFT STRAP 9 20384 1 SP ACER 10 370351 4 HHCS 5/8-1 1 UNC × 1-3/4 11 20385 1 ...
-
Stanley Black & Decker PD45 - page 19
...
-
Stanley Black & Decker PD45 - page 20
Stanley Hydraulic T ools 3810 SE Naef Road Milwaukie, Oregon 97267-5698 USA (503) 659-5660 / Fax (503) 652-1780 www .stanleyhydraulic.com IMPORT ANT T o ll out a Product Warranty Recording form, and for information on your warranty , visit Stanleyhydraulic.com and select the W arranty tab. ( NOTE: T he warranty recording form must be submitted t ...
¿Tienes una pregunta acerca de Stanley Black & Decker PD45?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Stanley Black & Decker PD45, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Stanley Black & Decker PD45 probablemente compartirá una forma de solucionarlo.