-
Sanyo VCB-3572IRP - page 1
INSTRUCTION MANUAL BEDIENUNGSANLEITUNG MANUEL D’INSTRUCTIONS VCB-3572IRP B/W CCD Camera CCD-Schwarzweißkamera Caméra CCD Noir et Blanc CCD About this manual B efo re in st a ll i ng and us in g the ca m era , pl ea se re ad th is manual carefully. Be sure to keep it handy for later reference. Über diese Bedienungsanleitung Lesen Sie bit te vor ...
-
Sanyo VCB-3572IRP - page 2
CON TENTS PRECAUTIONS ..................................................................................... 2 PARTS NAMES ..................................................................................... 3 CONCERNING AUTO-IRIS LENSES ...................................................... 5 MOUNTING THE LENS ..................................... ...
-
Sanyo VCB-3572IRP - page 3
PRECAUTIONS In case of problem Do not use the camera if smoke or a strange odour comes from the unit, or if it seems not to function correctly. Disconnect the power cord immediately, and consult your dealer (or a Sanyo Authorized Service Centre). Do not open or modify Do not open the cabinet, as it may be dangerous and cause damage to the unit. For ...
-
Sanyo VCB-3572IRP - page 4
PARTS NAMES 1 Video output connector (VIDEO OUT: BNC type) Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector. 2 External sync composite video signal input connector (VS IN: BNC type) Connect to this connector the synchronizing signal output from a synchronizing signal device or the composite signal of a video dis ...
-
Sanyo VCB-3572IRP - page 5
PARTS NAMES 7 Lens mount cap The cap is installed to protect the lens mount section. Remove the lens mount cap before installing a lens (sold separately). 8 Flange-back adjustment screw (FLANGE BACK ADJ.) 9 Flange-back lock screw (FLANGE BACK LOCK) F Camera installation bracket The bracket can be fixed at the top or bottom of the camera. When fixin ...
-
Sanyo VCB-3572IRP - page 6
CONCERNING AUTO-IRIS LENSES DC type auto-iris lens A lens without amplifier circuit that operates only on a DC power source. In general, this type of lens is referred to as DC type coil lens or DC type non-amplifier lens. (Set the A.I. LENS switch to the DC position.) VIDEO type auto-iris lens A lens with amplifier circuit that operates on video si ...
-
Sanyo VCB-3572IRP - page 7
MOUNTING THE LENS Please use a DC type auto-iris lens (sold separately). Checking the lens mount Do not use a lens if length “ L ” is more than 7 mm. If not, that may damage the camera and prevent proper installation. 1 Remove the lens mount cap from the camera. 2 Install the auto-iris lens. CS mount type lens Carefully align the lens mount wit ...
-
Sanyo VCB-3572IRP - page 8
MOUNTING THE LENS Rewiring the lens cable in the lens iris plug 1 Prepare the lens cable. Cut the cable at the plug, then remove approx. 8 mm of the cable sheath and strip about 2 mm from ea ch wire. 2 Install the lens iris plug. Solder the cable to the pins following the correct pin layout (refer to the table and illustrations), then close the plu ...
-
Sanyo VCB-3572IRP - page 9
CONNECTIONS Basic connection for monitoring or recording The peripheral devices (VCR, monitor, lens, etc.) and cables are sold separately. 1 Make the video signal connection between the camera and the monitor or time lapse VCR. 2 Connect DC connecting cord from the AC adaptor to the 12 V DC input terminal on the camera. • When using this unit, th ...
-
Sanyo VCB-3572IRP - page 10
SETTINGS Control name Position a High speed electronic shutter switches (E.S.) All OFF: 1/50 sec b Electronic iris (EI)/Backlight compensation (BLC) switch OFF c Auto-iris lens switch (A.I. LENS) Refer to page 5 DC d Lens iris level volume (LEVEL) about centre High speed electronic shutter setting Normally, the speed setting switches for the high s ...
-
Sanyo VCB-3572IRP - page 11
SET TINGS Electronic iris function setting Use a manual or fixed iris lens and set the lens aperture to the shortest F stop. Set the EI/BLC switch to EI-ON position. Note: Please refer to the specifications for dynamic range of the electronic iris. CAUTION: • The e lec tron ic iris is su itable for n ormal in door us e. Whe n the EI/ BLC switc h ...
-
Sanyo VCB-3572IRP - page 12
SET TINGS Backlight compensation setting Use an auto-iris lens and set the EI/BLC switch to the BLC-ON position, to engage the backlight compensation function. Use an auto-iris lens. Set the EI/BLC switch to the BLC-ON position. If using a VIDEO type auto-iris lens • The ALC volume on the lens should be turned all the way to Av (Average). • If ...
-
Sanyo VCB-3572IRP - page 13
SPECIFICATIONS Camera Scanning system : CCIR standard (625 TV lines, 25 frames/sec.) Interlace : PLL 2:1 interlace Image device : 1 /2 i n c h s o lid s ta te i ma ge de vi ce C CD Picture elements : 795 (H) x 596 (V) Effective picture elements : 752 (H) x 582 (V) Synchronizing system : External sync (Automatic switching) Resolution : 560 TV lines ...
-
Sanyo VCB-3572IRP - page 14
SPECIFICATIONS Dimensions: mm Features and specifications are subject to change without prior notice or obligations. ACCESSORIES 1 C mount adaptor (5 mm).......................................................... 1 pc. The C mount adaptor must be used to be able to install a C mount lens on the camera. 2 Lens iris plug (4-pin) ...................... ...
-
Sanyo VCB-3572IRP - page 15
1AC6P1P1978-- L72H2/XE2(0399NI) SANYO Electric Co, Ltd Printed in Japan L72H 2/XE2 GB 199 9, 3, 2 ...
¿Tienes una pregunta acerca de Sanyo VCB-3572IRP?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sanyo VCB-3572IRP, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sanyo VCB-3572IRP probablemente compartirá una forma de solucionarlo.