Manual de instrucciones OWC Mercury Rack Pro

24 de páginas No relevante
Descargar

Pasar a la página of 24

Summary
  • OWC Mercury Rack Pro - page 1

    U ser Guide & O wners Manual ...

  • OWC Mercury Rack Pro - page 2

    ...

  • OWC Mercury Rack Pro - page 3

    OWC Mercury R ack Pro mini-SAS T able of Cont ents 1 INTRODUCTION 1.1 SY STEM REQUIREMENTS 1.1.1 Mac Requirements 1.1.2 PC Requirements 1.1.3 Supported Hard Drives 1.2 P A CKAGE C ONTENTS 1.3 ABOUT THIS MANUAL 1.4 REAR VIE W & CABLE CONNECTIONS 1.5 FRONT VIEW & LED INDIC A T ORS 1.5.1 LED Indicators 1.6 RAID MODES 1.6.1 Combine 1.6.2 Disk S ...

  • OWC Mercury Rack Pro - page 4

    1.1 System Requir ements 1.1.1 Mac Requirements Dependent on the interface card you purchase to use with this solution. P lease check the specications of the controller car d to determine system requirements . 1.1.2 PC Requirements Dependent on the interface card you purchase to use with this solution. P lease check the specications of the co ...

  • OWC Mercury Rack Pro - page 5

    OWC Mercury R ack Pro mini-SAS Chapter 1 - Introduction 1.5.1 LED Indicators P ow er Input V oltage Switch External mini-SAS Port Cable Connections: 1 . Plug the power cable in to the wall and into the OWC Mercury Rack Pro . 2 . Verify that the voltage swit ch is set properly for y our country . 3 . Connect your external mini-SAS cable to your exte ...

  • OWC Mercury Rack Pro - page 6

    OWC Mercury R ack Pro SAS Chapter 1 - Introduction 1.6 RAID Modes The OW C Mercury Rack Pro mini-SAS does not have an y R AID functions built in; howe ver most RAID cards y ou will choose to use with the OWC Mercury Rack Pro mini-SAS will. These denitions of dieren t RAID modes are provided to help y ou decide which mode is best for you to us ...

  • OWC Mercury Rack Pro - page 7

    OWC Mercury R ack Pro mini-SAS Chapter 1 - Introduction 1.6.4 Disk Mirroring with Striping (RAID 10) (also known as RAID 1+0) The drives show up as one v olume, but only 50% of the total capacity can be used, depending on the drive with the smallest capacity . R AID 10 creates an e xact copy (or “mirr or ”) of a set of data but also uses a RAID ...

  • OWC Mercury Rack Pro - page 8

    OWC Mercury R ack Pro mini-SAS Chapter 2 - Syst em Setup 2.1 Drive Installation NO TE: If you purchased a prec ongured solution with drives , they will be numbered for proper installa tion in individual drive bays . Please match the drive ba y numbers to the hard drives and their tra ys. T o install your own driv e mechanisms: 1. Open the front ...

  • OWC Mercury Rack Pro - page 9

    OWC Mercury R ack Pro mini-SAS Chapter 2 - Syst em Setup 2.2 Replacing Drives If one of the drives fail, the corresponding activity LED will light up solid red If only one drive is defec- tive and your c ontroller card’ s RAID mode is set to RAID 1, RAID 3, RAID 5, or RAID 10, the data can still be accessed, but we strongly suggest that you repla ...

  • OWC Mercury Rack Pro - page 10

    2.3 Connections to C omputer 1 . Plug the power cable in to the wall and into the OWC Mercury Rack Pro . 2. V er ify the voltage switch is set pr operly for the country you reside in. 3 . Connect the mini-SAS por t to your con troller card . If sold as a precongured solution, your OW C Mercury Rack Pro is preset as a RAID 5, using the “Mac OS ...

  • OWC Mercury Rack Pro - page 11

    2.4 Con verting to Desktop Unit The OWC Mercury R ack Pr o can be conv erted from a rack mounting enclosure to a desktop unit by remo ving the rack pulls from the sides of the enclosur e, and attaching the included rubber feet to the enclosur e. T o remove the rack pulls , simply remov e the 4 Phillips screws on the side of the rack and the rack pu ...

  • OWC Mercury Rack Pro - page 12

    OWC Mercury R ack Pro mini-SAS Chapter 3 - F ormatting 3 FORMA T TING 3.1 F ormatting y our OWC Mer cury R ack Pro on a Macint osh with Mac OS X Click on the “I nitialize ” button. Select the device with no volumes attached to it; in this picture, that would be the 4 TB OWC device . Click on the picture of the drive icon next to the text. ➀ ? ...

  • OWC Mercury Rack Pro - page 13

    Once you ’ve selected the OWC device, y ou will notice the above change in the Disk Utility application. Click on the “P artition” tab in this picture. Y ou then need to choose how man y par titions you wish your OWC Mercur y Rack Pro t o have . For ease of use w e ’ re selecting one par tition here but of course y ou could select more if y ...

  • OWC Mercury Rack Pro - page 14

    Choose a name for the v olume. Y ou will need to repeat this step f or each volume if you selected multiple partitions. Click Apply to nish. ➄ ➅ After a few moments , par titioning will complete and the OWC Mercur y Rack Pro v olume will mount on your deskt op . Y ou can quit Disk Utility , you ’ re all set! OWC Mercury R ack Pro mini-SAS ...

  • OWC Mercury Rack Pro - page 15

    OWC Mercury R ack Pro mini-SAS Chapter 3 - F ormatting 3.2 Removing the GUID P artition S cheme Only for XP , 2000, ME and earlier . (XP 64-BIT, Vista & Windows 7 can continue to the next section) ➆ T ype exit and hit enter . ➇ Close the command prompt window . Y ou may now proceed with forma tting the drive . W ARNING: The clean command wi ...

  • OWC Mercury Rack Pro - page 16

    OWC Mercury R ack Pro mini-SAS Chapter 3 - F ormatting 3.3 F ormatting y our OWC Mer cury R ack Pro on W indows 2000 and later Instructions for other operating systems can be found at h ttp://www.macsales.com/f or mat . ➀ With the driv e connected to the computer and power ed on, right click on the “My Computer ” icon and select “Manage” ...

  • OWC Mercury Rack Pro - page 17

    OWC Mercury R ack Pro mini-SAS Chapter 3 - F ormatting ➃ Your drive will appear similar to how Disk 1 does below. Notice that the space on the lower right reads as “Unallo - cated.” Right click in this space and choose “New Partition.” ➄ The “New Partition Wizar d” will launch. Click “Next ” to continue. ➅ Specify your partiti ...

  • OWC Mercury Rack Pro - page 18

    OWC Mercury R ack Pro mini-SAS Chapter 3 - F ormatting ➇ If you like, y ou can specify the drive letter designa tion for y our new drive. Other wise, one will automatically be assigned . Click “Nex t. ” ➈ Before y ou can use the drive, it must be f or mat - ted. On most sy stems running Windo ws 2000 or later , it is advisable to specify th ...

  • OWC Mercury Rack Pro - page 19

    OWC Mercury R ack Pro mini-SAS Chapter 3 - F ormatting ➀➀ Once you have nished with the formatting wizar d, you will see that y our new drive (repr e - sented as “Disk E” in this case) will display a message of “For - matting. ” This should only take a couple of minutes if you chose the quick format op- tion. ➀➁ After a mo - ment ...

  • OWC Mercury Rack Pro - page 20

    OWC Mercury R ack Pro mini-SAS Chapter 3 - F ormatting Using y our new Stor age Solution on both Macs and PCs? MacDrive takes the guesswork out of sharing les. Whether you ar e trans - ferring les between home and the oce, a class room lab and your dorm room or even on the same computer , MacDrive makes it painless. In fact, you ’ll hard ...

  • OWC Mercury Rack Pro - page 21

    OWC Mercury R ack Pro mini-SAS Chapter 4 - T roubleshooting & Tips 4 TROUBLESHOO TING & TIPS 4.1 T roubleshooting Some of the most simple problems can be traced to po wer , or connec tivity issues. Begin your troubleshooting b y verifying that pow er is plugged into the external stor - age solution, and if connected to a power strip . Make ...

  • OWC Mercury Rack Pro - page 22

    OWC Mercury R ack Pro mini-SAS Chapter 5 - Appendix 5.1 F AQ Q: How do I format m y storage solution? A: OWC has detailed instructions online for most popular operating systems , located at: http://eshop.macsales.com/tech_center/formatting.cfm Q: What le system should I choose when formatting m y drive? A: This will depend on how you want to use ...

  • OWC Mercury Rack Pro - page 23

    OWC Mercury R ack Pro mini-SAS Chapter 6 - Customer Service •Read this manual and review Chapter 4: T roubleshooting & Tips. •Visit our tech c enter for mor e suppor t suggestions, including F AQs. http://eshop .macsales.com/tech_cen ter If you still need support, please have the f ollowing av ailable to you: • The serial number of the en ...

  • OWC Mercury Rack Pro - page 24

    Copyright ®2009-11 Other W orld Computing All Rights Reserved. Other World Computing ’ s Limited W arranty is not transferable and subject to limitations. Copyrights: Copyright © 2009-11 Other W orld Computing, Inc. All rights reserved. No part of this publication may be reproduced, st ored in a retrieval system, or transmitted in an y form or ...

Fabricante OWC Categoría External Hard Drive

Los documentos del dispositivo OWC Mercury Rack Pro que obtenemos del fabricante se pueden dividir en varios grupos. Entre ellos están::
- dibujos técnicos OWC
- manuales de instrucciones Mercury Rack Pro
- hojas de producto OWC
- folletos informativos
- o etiquetas energéticas OWC Mercury Rack Pro
Todos son importantes, pero lo más importante desde el punto de vista del usuario de un dispositivo lo encontraremos en el manual de instrucciones OWC Mercury Rack Pro.

Un conjunto de documentos determinado como manual de instrucciones se divide también en tipos más detallados, tales como: instrucciones de montaje OWC Mercury Rack Pro, instrucciones de servicio, instrucciones cortas o instrucciones de usuario OWC Mercury Rack Pro. Dependiendo de la situación debes buscar el documento que necesitas. En nuestra página puedes consultar el manual de instrucciones más popular del producto OWC Mercury Rack Pro.

Manuales de instrucciones parecidos

El manual de instrucciones del dispositivo OWC Mercury Rack Pro, ¿cómo debería ser?
El manual de instrucciones, también determinado como el manual de usuario o simplemente instrucciones, es un documento técnico que tiene como objetivo ayudar a los usuarios a utilizar OWC Mercury Rack Pro. Las instrucciones normalmente las realiza un escritor técnico pero en un lenguaje comprensible para todos los usuarios de OWC Mercury Rack Pro.

El manual de instrucciones completo de OWC debe contener unos elementos básicos. Una parte de ellos es menos importante, como por ejemplo: la portada / la página principal o las páginas de autor. Sin embargo, lo demás debe facilitarnos la información más importante desde el punto de vista del usuario.

1. Introducción y pistas sobre cómo orientarse con el manual OWC Mercury Rack Pro - Al principio de cada manual se deben encontrar las indicaciones acerca de la manera de usar un manual de instrucciones. Debe contener información sobre dónde encontrar el índice OWC Mercury Rack Pro, preguntas frecuentes o problemas más comunes – son los apartados más buscados por los usuarios de cada manual de instrucciones.
2. Índice - listados de todos los consejos acerca de OWC Mercury Rack Pro que encontraremos en el documento
3. Consejos de uso de las funciones básicas del dispositivo OWC Mercury Rack Pro - que deben facilitarnos los primeros pasos durante el uso de OWC Mercury Rack Pro
4. Troubleshooting - una secuencia sistematizada de acciones que nos ayudará a diagnosticar los problemas más importantes con OWC Mercury Rack Pro
5. FAQ - las preguntas frecuentes
6. Datos de contacto Información acerca de cómo encontrar los datos de contacto del fabricante / servicio de OWC Mercury Rack Pro en cada país si no somos capaces de solucionar el problema por nuestra cuenta.

¿Tienes una pregunta acerca de OWC Mercury Rack Pro?

Utiliza el formulario que se encuentra abajo

Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con OWC Mercury Rack Pro, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con OWC Mercury Rack Pro probablemente compartirá una forma de solucionarlo.

Copia el texto de la imagen

Comentarios (0)