-
Alliance Laundry Systems NX18BVQA6 - page 1
Installation/Operation Supplement www .comlaundry .com W asher -Extractors Cabinet Freestanding Coin Models Part No. 9002062R1EN December 2007 K eep These Instructions f or Future Refer ence. (If this machine changes o wnership, this manual must accompany machine.) ...
-
Alliance Laundry Systems NX18BVQA6 - page 2
...
-
Alliance Laundry Systems NX18BVQA6 - page 3
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT © Copyright 2007, Alliance Laundry Systems LLC All rights reserv ed. No part of the cont ents of this book may be reproduced or transmitted in any form or b y an y means without the e xpressed written consent of the publisher . 9002062 (EN) 1 Installation/Operatio n/Supplement ...
-
Alliance Laundry Systems NX18BVQA6 - page 4
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 9002062 (EN) 2 Installation/Opera tion Supplement Intr oduction Model Identification Information in this manual is applicable to these models: NX18BVP A6 NX18BVQA6 NX18BVXA6 NX30BVP A6 NX30BVQA6 NX30BVXA6 ...
-
Alliance Laundry Systems NX18BVQA6 - page 5
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 3 9002062 (EN) Installation/Operation Sup plement Safe ty Inf ormation Explanation of Safet y Messages Throughout this manual and on machine decals, you will find precauti onary statements (“D ANGER, ” “W ARNING, ” and “CA UTIO N”) follo wed by specif ic instruction ...
-
Alliance Laundry Systems NX18BVQA6 - page 6
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Opera tion Supplement 9002062 (EN) 4 9. Do not install or store the w asher where it will be exposed to water and/or weather . 10. Do not tamper wi t h the controls. 11. Do not repair or re place any part of the washer , or attempt any servicing unless specif icall ...
-
Alliance Laundry Systems NX18BVQA6 - page 7
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 5 9002062 (EN) Installation/Operation Sup plement Specifications and Dimensions General Specifications Model 18 30 Overall Dimensi ons Overall widt h 26 in. (660 mm) 30.7 in. (780 mm) Overall heig ht 40.9 in. (1038 mm) 47.3 in. (1202 mm) Overall depth 29.1 in. (739 mm) 33.1 in. ...
-
Alliance Laundry Systems NX18BVQA6 - page 8
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Opera tion Supplement 9002062 (EN) 6 General Specifications Model 18 30 Drive T rain Inf ormation Number of motor s in drive train 11 Drive motor power 1 HP (0.75 kW) 2 HP (1.5 kW) Cylinder Speeds W ash/re ver se speed 10-50 RPM 10-50 RPM Distrib ution/drain speed ...
-
Alliance Laundry Systems NX18BVQA6 - page 9
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Operation Sup plement 7 9002062 (EN) Figure 1 CFD21N 1 Hot W ater Connections .7 5 in. (19 mm) 5 V entilation T ub 2 Cold W ater Inlet (required) .75 in. (19 mm) 6 Drain Outle t 3 Po w e r I n p u t 7 Cold W ater Inlet (required) .75 in. (19 mm) 4 Emergency Stop Bu ...
-
Alliance Laundry Systems NX18BVQA6 - page 10
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Opera tion Supplement 9002062 (EN) 8 Figure 2 CFD23N 1 Hot W ater Connections .7 5 in. (19 mm) 5 V entilation T ub 2 Cold W ater Inlet (required) .75 in. (19 mm) 6 Drain Outle t 3 Po w e r I n p u t 7 Cold W ater Inlet (required) .75 in. (19 mm) 4 Emergency Stop Bu ...
-
Alliance Laundry Systems NX18BVQA6 - page 11
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 9 9002062 (EN) Installation/Operation Sup plement Installation Dimensional Clearances Ta b l e 1 shows recommended minimum clearances on all sides of the washer-e xtractor . Machine Foundation Thoroughness of detail must be stressed with all foundation work to ensure a stable u ...
-
Alliance Laundry Systems NX18BVQA6 - page 12
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Opera tion Supplement 9002062 (EN) 10 Mounting Bolt Installation (If Required) Figure 3 After the concrete has cured and the anchors are installed, proc eed as follo ws: 1. Place the washer -extractor adjacent to the foundation. Do not attempt to mov e it b y pushi ...
-
Alliance Laundry Systems NX18BVQA6 - page 13
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Operation Sup plement 11 9002062 (EN) Remo ving the T ranspor t Block T o prev ent damage during transportatio n, machine has been equipped with a transport block. T o remove, proceed as follows: 1. Place machine on le vel ground. 2. Remov e service panels and back ...
-
Alliance Laundry Systems NX18BVQA6 - page 14
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Opera tion Supplement 9002062 (EN) 12 Electrical Specific ations V oltage Designation Standar d Electric Heat Model Code Vo l t a g e Cycl e Phase Wire Full Load Amps Cir cuit Breaker AW G / m m 2 kW Full Load Amps Cir cuit Breaker AW G / m m 2 kW 18 P 380-415 50/6 ...
-
Alliance Laundry Systems NX18BVQA6 - page 15
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 13 9002062 (EN) Installation/Operation Sup plement Operation Contr ol P anel Figure 6 CHM482R CHM488R 1 Cycle 1 7 Cycle 7 2 Cycle 2 8 Cycle 8 3 Cycle 3 9 Down Edit/Change ke ypad 4 Cycle 4 10 Up Edit/Change keypad 5 Cycle 5 11 Star t/Enter ke ypad 6 Cycle 6 12 Display CHM482R W ...
-
Alliance Laundry Systems NX18BVQA6 - page 16
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Opera tion Supplement 9002062 (EN) 14 Operating Instructions 1. T urn on main power source (circuit break er). 2. Push black but ton and pull do or handle a way from machine to open door . Refer to Fi g u r e 7 . Figure 7 3. Load to capacity wh ene ver possible. DO ...
-
Alliance Laundry Systems NX18BVQA6 - page 17
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Installation/Operation Sup plement 15 9002062 (EN) 6. If desired, select a different cycle at this point before satisfying vend. The LED indicator for that cycle will light. 7. Add liquid and/or powder supplies to supply dispenser . Refer to Fi g u re 1 1 . a. Add detergent to ...
-
Alliance Laundry Systems NX18BVQA6 - page 18
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 9002062 (EN) 16 Installation/Opera tion Supplement Disposal of Unit This appliance is marked according to the European directiv e 2002/96/EC on W aste Electrical and Electronic Equipment (WEEE). This symbol on the product o r on its packaging indicates that this produc t shall ...
¿Tienes una pregunta acerca de Alliance Laundry Systems NX18BVQA6?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Alliance Laundry Systems NX18BVQA6, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Alliance Laundry Systems NX18BVQA6 probablemente compartirá una forma de solucionarlo.