-
Electrolux CH 950 - page 1
INSTRUCTION BOOK FOR ELECTROLUX COOKER HOOD CH 950 cod. 436002579_01 - 050131 UK ...
-
Electrolux CH 950 - page 2
...
-
Electrolux CH 950 - page 3
3 Thank you for buying a Electrolux product. T o enable you to use your appliance effectively and safely , please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further in- formation on Electrolux Products, please contact our Customer Ca ...
-
Electrolux CH 950 - page 4
4 IMPORT ANT SAFETY INFORMA TION These warnings are provided in the interests of your safety . Ensure that you understand them all before installing or using this appliance. Y our safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Installation • Any installation w ...
-
Electrolux CH 950 - page 5
5 YOUR APPLIANCE 650 min. ...
-
Electrolux CH 950 - page 6
6 L S1 T1 T2 T3 T4 OPERA TING INSTRUCTIONS The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The appliance can be installed to recirculate or extract contaminated air . Control Panel The hood can be switched on pushing directly onto the requested speed without fi rstly having to select 0/1 button ...
-
Electrolux CH 950 - page 7
7 Before carrying out any maintenance or clea- ning isolate the cooker hood from the mains supply . The cooker hood must be kept clean, as a build up of grease or fat can be a fi re hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. Never use scouring pads or abrasive cleaners. Never use excessi ...
-
Electrolux CH 950 - page 8
8 Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply . Charcoal Filters In the recirculation mode the charcoal fi lters absorb smells and unwanted odours. Enabling the alarm signal • In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date. • T urn ...
-
Electrolux CH 950 - page 9
9 SOMETHING NOT WORKING SERVICE AND SP ARE P ARTS If, having followed these instructions carefully , your cooker hood fails to work properly please carry out the following checks. Symptom The cooker hood will not start The cooker hood is not working effectively The cooker hood has switched off during opera- tion If after all these checks, the fault ...
-
Electrolux CH 950 - page 10
10 GUARANTEE CONDITIONS We Electrolux, undertake that if within twenty four months of the date of the purchase this Electrolux built-in applian- ce or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour , materials or c ...
-
Electrolux CH 950 - page 11
11 INST ALLA TION INSTRUCTIONS It is dangerous to alter the specifi cations or attempt to modify this product in any way . T echnical Information DIMENSIONS HEIGHT OF CANOPY : 70 mm HEIGHT OF CHIMNEY : (UPPER SECTION) 470 mm (LOWER SECTION) 745 mm WIDTH OF CANOPY : 898 mm DEPTH OF CANOPY : 490 mm ELECTRICAL SUPPL Y : VOL T AGE: 220-240 V 50Hz POWE ...
-
Electrolux CH 950 - page 12
12 INST ALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air . Incorrect installation may affect the safety of this cooker hood. Installation Requirements Bef ...
-
Electrolux CH 950 - page 13
13 A: Built-in Electric Hob: 650mm clearance B: Built-in Gas hob: 700mm clearance C: Slot-in Electric Cooker: 685mm clearance D: Slot-in Gas Cooker: 787mm clearance Hob Clearance Height The cooker hood is designed to be fi tted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not ...
-
Electrolux CH 950 - page 14
14 Fitting the W all Brackets W all marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Draw a horizontal line at 650 mm above the hob. • Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning ...
-
Electrolux CH 950 - page 15
15 Fitting the Hood Body Before starting to fi x the hood body , tighten the two screws V r located on the top of the hood body . Hook the hood body onto the two screws item 12a (not supplied). Fully tighten the screws item 12a . Using a screw driver and spirit level, adjust the screws item V r until the hood body is level. Extraction The cooker h ...
-
Electrolux CH 950 - page 16
16 Extraction The charcoal fi lter is not required in this mode and should be removed. Ducting The ducting used must be Ø150mm (6ins), or Ø125mm (5ins) in diameter . If possible duct through the wall immediately above the hood body . For the best performance use the shortest possible duct run and the minimum number of bends. Where fl exible duc ...
-
Electrolux CH 950 - page 17
17 Fitting the Chimney Stack The chimney consists of two sections. The lower chimney measures 740mm and the upper chimney (with the recirculation grilles on either side) measures 465mm. The overall installed measurement is min. 870 - max 1200mm. UPPER CHIMNEY T o fi t the upper chimney section item 2.1 expand the chimney slightly to allow it to be ...
-
Electrolux CH 950 - page 18
...
-
Electrolux CH 950 - page 19
...
-
Electrolux CH 950 - page 20
55 - 77 High Street - Slough BERKSHIRE SL1 1DZ © Electrolux plc 2002 ...
¿Tienes una pregunta acerca de Electrolux CH 950?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Electrolux CH 950, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Electrolux CH 950 probablemente compartirá una forma de solucionarlo.