-
Silvercrest SEKU 2000 A16 - page 1
E lectric F ir eplace SEKU 2000 A1 6 K OMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www .kompernass.com ID-Nr .: SEKU 2000 A1-05/10-V3 Electric Fireplace Operating instr uctions ...
-
Silvercrest SEKU 2000 A16 - page 2
1 SEKU 2000 A1 GB IE Contents Introduction . . . . . . . . . . . . . . . . . . . . . . 2 Information for these operating instructions . . . . . 2 Copyright . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Limited liabilit y . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 W arnings . . . . . . . . . . . . . . . . . . . . . . . ...
-
Silvercrest SEKU 2000 A16 - page 3
2 Introduction SEKU 2000 A1 GB IE Introduction Information f or these oper ating instructions These operating instructions ar e a component of the SEKU 2000 A1 Electric Fireplace (henceforth designated as the appliance) and they pr ovide y ou with impor tant information about the intended use, safet y , installation and connection as well as oper a ...
-
Silvercrest SEKU 2000 A16 - page 4
3 Introduction SEKU 2000 A1 GB IE W arnings In these operating instructions the follo wing warnings are used: D ANGER A warning at this danger lev el indicates a t hreatening ly dangerous situation. If the dangerous situation is not av oided, it could result in death or serious injur y . Compliance with the instructions in this warning is necessary ...
-
Silvercrest SEKU 2000 A16 - page 5
4 Safet y SEKU 2000 A1 GB IE Safet y In this chapter you ar e being given important safet y information regarding the handling of the appliance. This appliance complies with the statutor y safet y regulations. Incorrect usage can, ho we ver , lead to personal and propert y damage. Do not co ver the appliance! Cov ering the appliance can cause ov er ...
-
Silvercrest SEKU 2000 A16 - page 6
5 Setting up and connecting SEKU 2000 A1 GB IE Defective components may only be r eplaced with original replacement parts. Only by using original ■ replacement parts can it be guaranteed that the safet y requir ements are being complied with. Protect the appliance fr om moisture and liquid penetration. ■ Alway s pull on the plug when disconnect ...
-
Silvercrest SEKU 2000 A16 - page 7
6 Setting up and connecting SEKU 2000 A1 GB IE Inst allation requir ements For the safe and corr ect operation of the appliance, the installation site must satisfy the following r equirements: The appliance must be placed on a fi rm, fl at and horizontal surface. ■ Do not place the appliance in a hot, wet or v er y humid envir onment or close t ...
-
Silvercrest SEKU 2000 A16 - page 8
7 Operating com ponents SEKU 2000 A1 GB IE Operating com ponents NOTICE The operating elements ar e on the front of the appliance, abov e right and behind the ventilation grille. ► T o operate them, fold the ventilation grille for war d. ► ON/OFF switch (Flames) 2 ON/OFF switch (Heating, lev el 1) 3 ON/OFF switch (Heating, lev el 2) 4 T emperat ...
-
Silvercrest SEKU 2000 A16 - page 9
8 Set up SEKU 2000 A1 GB IE Set up Before the appliance can be set up, the fi re surround must be assembled. NOTICE Check the contents to mak e sure ev er ything is there and for visible damage. ► Firstly , become familiar with all par ts involv ed in the assembly . ► Individual par ts of the electric fi replace 2 3 5 6 7 8 4 left side panel ...
-
Silvercrest SEKU 2000 A16 - page 10
9 Set up SEKU 2000 A1 GB IE Screw s and assembly material A B C D E F No.: Designation: Number: A Scre ws 6 x 25 mm 17 B W ood plugs 8 C Double locking pin 4 D Single locking pin 6 E Adapter slee ve 14 F Fixing de vice 2 NOTICE Y ou requir e a screwdriv er for the assembly; this is not supplied. ► The assembly of the fi r e surround is described ...
-
Silvercrest SEKU 2000 A16 - page 11
10 Assembly SEKU 2000 A1 GB IE Assembly Step 1 Scre w three single locking pins D with a screwdriv er into the prepared holes on the left front panel 2 . Place two w ood plugs B into the holes of the front panel 2 . Inser t three adapter slee ves E into the three lar ge holes of the lef t side panel . Thereb y , with the scre wdriver li ...
-
Silvercrest SEKU 2000 A16 - page 12
11 Assembly SEKU 2000 A1 GB IE Then, bring the front panel 4 and side panel 8 together at right angles, so that the locking pins D enter the holes on the right edge of the side panel. When done, scre w all three adapter sleev es E to the right with the scre wdriver until the locking pins are clamped into the adapter sleev es and the panels ...
-
Silvercrest SEKU 2000 A16 - page 13
12 Assembly SEKU 2000 A1 GB IE Step 5 Place the fl oor plate 7 on the fl oor . Now tak e the pre viously assembled unit and carefully place it on the fl oor plate as sho wn in the following diagr amme. Then scre w together the assembled unit with the connection blocks G on the fl oor plate 7 . F or this, use 8 scre ws of the t ype A ...
-
Silvercrest SEKU 2000 A16 - page 14
13 Assembly SEKU 2000 A1 GB IE Step 7 T ake the base plate 6 and inser t 4 wood plugs B into the holes of the plate underside. Then place the base plate 6 on the fl oor plate 7 so that the four w ood plugs fi t into the four holes in the fl oor plate. Rear vie w Fr ont View Installing t he appliance in t he fi re surr ound T o fi nalis ...
-
Silvercrest SEKU 2000 A16 - page 15
14 SEKU 2000 A1 GB IE Handling and operation NOTICE See also "Operating Elements" on page 7. ► In this chapter you r eceive important information for the handling and operation of the appliance. Activate the ON/OFF switch to turn the unit on. The fl ame r eplication lights up. Programme in the desired brightness with the Dimmer 5 . ...
-
Silvercrest SEKU 2000 A16 - page 16
15 SEKU 2000 A1 GB IE Switch the appliance off . Pull the plug from the mains po wer sock et. Loosen the four scre ws on the rear panel and r emove the metal v entilation panel 9 . Carefully r eplace the defective bulb 10 in the light shaft. Scre w the metal ventilation panel 9 back onto the appliance rear . Cleaning W ARNING O ...
-
Silvercrest SEKU 2000 A16 - page 17
16 SEKU 2000 A1 GB IE Malfunction causes and remedies The following table will help with localising and r emedying minor malfunctions: Defect Possible cause Solution The fl ame r eplication does not light up. The appliance is not switched on. Switch the appliance on. The plug is not inser ted. Inser t the plug into the mains pow er socket. The mai ...
-
Silvercrest SEKU 2000 A16 - page 18
17 Appendix SEKU 2000 A1 GB IE Appendix T ec hnical dat a General Input voltage 220 - 240 V ~ Mains frequency 50 Hz P ow er consumption Heating lev el 1 Heating lev el 2 1000 2000 W W Bulb 2 x Bulbs E14 2 x 25 W Ambient temperatur e +5 to +45 °C Humidit y (no condensation) 5 to 90 % Measurements (W x H x D): 100 x 100 x 39 cm W eight appro x. 45 k ...
-
Silvercrest SEKU 2000 A16 - page 19
18 Appendix SEKU 2000 A1 GB IE W arrant y Y ou receiv e a 3-year w arrant y for this appliance as of the purchase date. The appliance has been manu- factured with car e and meticulously ex amined before delivery . Please retain y our receipt as pr oof of purchase. In the case of a warr ant y claim, please make contact b y telephone with our Ser vic ...
¿Tienes una pregunta acerca de Silvercrest SEKU 2000 A16?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Silvercrest SEKU 2000 A16, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Silvercrest SEKU 2000 A16 probablemente compartirá una forma de solucionarlo.