-
Nuvo 110 - page 1
ASSEMBL Y & OPERA TION MANUAL 110/220 CELLAR n u v o k o o l s p a c e TM ...
-
Nuvo 110 - page 2
~ 2 ~ ~ 3 ~ 1. LOCA TING YOUR WINE CELLAR - Remember , it is not an appliance, it is a piece of furniture 2. AREA FOR ASSEMBLING YOUR WINE CELLAR Choose a clear 12’ by 12’ area with a level oor and carpeting to help reduce scratching of surfaces. 3. T OOLS * Hex wrench (included) * P hillips screwdriver * Carpenter’ s level * Helper or two ...
-
Nuvo 110 - page 3
~ 2 ~ ~ 3 ~ HARDW ARE KIT C B A F E G D H *NOTE : Hardware quantities for Model 220 are indicated in parenthesis. Cam Cap x 20 (x24)* Hex Bolt x 14 Hex W rench x 1 Cam x 20 (x24)* Cam P in x 20 (x24)* Leg x 4 In Cooling Unit Box Hex Bolt (Flange) x 2 P anel Insulation Strip x 1 ...
-
Nuvo 110 - page 4
~ 4 ~ ~ 5 ~ STEP 1 : P ANEL PREP ARA TION 1 P ANEL EDGE H CAUTION : 1. W atch for sharp staples on boxes. 2. DO NOT STEP ON P ANELS 3 . The manual will give a recommended order to open boxes, it saves space and time. 2 H ! Open Box VP1. Install INSULA TION STRIP (H) to Back, T op, and Bottom P anels. PUSH IN FULL Y! I nsert Cam Pins (E) by hand in ...
-
Nuvo 110 - page 5
~ 4 ~ ~ 5 ~ STEP 2 : CABINET ASSEMBL Y Attach T op and Bottom to Back by CAREFULL Y aligning edge holes over Cam P ins and gently push together to avoid damaging cam pins. DO NOT BANG OR SLAP P ANELS T OGETHER!!! Insert Cam, push all the way in under panel level (may require some force) and make sure Arrow points to outside edge, use allen key prov ...
-
Nuvo 110 - page 6
~ 6 ~ ~ 7 ~ STEP 2 : CABINET ASSEMBL Y CONTINUED CHECK P ANEL ORIENT A TION !!! Open Box VP5 or VP2. Insert Cam Pins (E) into SIDE P ANEL ’S predrilled holes both sides down to T AB. (May require some force) Attach SIDES to Back/Bottom/T op by Carefully aligning edge holes over Cam P ins and gently push together to avoid damaging cam pins. CHECK ...
-
Nuvo 110 - page 7
~ 6 ~ ~ 7 ~ Fasten BASE with HEX BOL TS (B) 4 C A B I N E T BOTT OM FRONT BASE 1 3 4 STEP 3 : HINGE,BASE AND LEGS INST ALLA TION Raise cabinet and check for potential air leaks at panel joints from inside. 2 Install four LEGS (F) into BASES fully in. 3 Open Box VP3. Fasten one HINGE (found in door box) to the SIDE of the cabinet with Hexbolts (B). ...
-
Nuvo 110 - page 8
~ 8 ~ ~ 9 ~ 2 1 1 C A B I N E T BOTT OM STEP 4 : SHEL VES BOTT OM T OP P R ES S Open box VP4 Hook SHEL VES into hangers starting from the bottom of cabinet HINT : CENTER SHEL VES ON HANGERS 1 2 Snap SHEL VES into hangers on one side Push the SHEL VES down to snap into opposite side hangers 1 ...
-
Nuvo 110 - page 9
~ 8 ~ ~ 9 ~ LEVEL TO OPENING STEP 5 : COOLING UNIT INST ALLA TION GET HELP BEFORE INST ALLING AND KEEP CHILDREN CLEAR OF CELLAR CONSTRUCTION AREA. Get helper to help guide unit, keep light cord clear of edge inside cellar and to prevent tipping of cellar . MAKE SURE INSULA TION STRIP IS IN CORRECT ORIENT A TION . Run light cord through Cut-out. Sli ...
-
Nuvo 110 - page 10
~ 10 ~ ~ 11 ~ 3 Insert LIGHT COVER to holes pre drilled on front edge of T OP panel. STEP 6 : LIGHT AND LIGHT COVER INST ALLA TION 1 Plug cord to LIGHT 2 Insert LIGHT to LIGHT COVER ...
-
Nuvo 110 - page 11
~ 10 ~ ~ 11 ~ Install T OP HINGE with HEX BOL TS (B) NOTE : Adjust nal position of the door before tightening the bolts and move cellar into place, leaving 4” clearance all around cellar . MAKE SURE CABINET IS AIRTIGHT! Adjust the level by turning (counter clockwise) the LEGS (F) as needed. Use a carpenter’ s level. STEP 7 : DOOR INST ALLA T ...
-
Nuvo 110 - page 12
~ 13 ~ FEA TURES: - Default SET temperature 57º F/14º C (ideal for wine storage). - Calibration option of the temperature sensor . - Display of actual temperature by request. - SET temperature range 52ºF-64ºF . - Digital temperature sensor . - Dual display Fº/Cº. - Settings are stored in memory for power failures. - P re programed software wi ...
-
Nuvo 110 - page 13
~ 13 ~ MAXIMUM CAP ACITIES AND LOADING TIPS Maximum capacities and sample loading arrangements for Vintage K eeper T uscany wine cellars are illustrated below . Note the variations in shelf height, to accommodate the widest variety of bottle types and sizes. Standard Burgundy and Bordeaux bottles are best arranged with necks facing out; some taller ...
-
Nuvo 110 - page 14
TROUBLE SHOOTING GUIDE Although each Vintage K eeper cooling unit has been carefully tested at every stage of manufacture, occasional problems arise, the majority of which are due to rough or careless handling during shipping or installation. Other problems may derive from improper cabinet assembly , power interruption or surge, low line voltage (l ...
-
Nuvo 110 - page 15
LIMITED W ARRANTY AND PRODUCT SUPPOR T ONE YEAR LIMITED W ARRANTY If your Koolspace cooling unit or cabinet fails to perform as designed within one year of the date of purchase, VINT AGE KEEPER INC. warrants that, upon your request, it will be repaired or replaced, at our option, during the one year warranty period. This warranty applies only to th ...
-
Nuvo 110 - page 16
T oll free: 1-888-274-8813 www .koolspace.com 110/220 CELLAR n u v o k o o l s p a c e TM ...
¿Tienes una pregunta acerca de Nuvo 110?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Nuvo 110, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Nuvo 110 probablemente compartirá una forma de solucionarlo.