-
Panduit PN380 - page 1
DPoE ™ Power System User’s Guide Issue 1.0 Part Number: PN380 February 2005 2005 PANDUIT Corp. All Rights reserved www.panduit.com ...
-
Panduit PN380 - page 2
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Safety Warnings The DPoE Power Patch Panel Power System is for u se in restricted access locations only. It is suitable for mounting on concrete or other non-combustible surfaces. Always observe standard safety precautions d uring installation, operation and maintenance of this p ...
-
Panduit PN380 - page 3
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 The foregoing warranty shall not apply to defect s resulting from improper or inadequ ate maintenance by Buyer. Buyer-supplied firmware or interfacin g unaut horized Modification or misuse, operation outside of the environmental specific ations for the product, or im proper site ...
-
Panduit PN380 - page 4
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 TABLE OF CONTENTS Safety Warnings ............................................................................................................................. i FCC Compliance Statement ............................................................................................. ...
-
Panduit PN380 - page 5
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Table 3: Heat Dissipation ...................................................................................................... ........ 3 Table 4: Recommended AC Circuit Break er and Wire Sizes……………………………………..…4 Table 5: Minimum Recommended DC AWG ...
-
Panduit PN380 - page 6
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 OVERVIEW The DPoE TM Power Patch Panel ( PANDUIT part number DPoE24U1X) provide s a reliable and cost- effective solution for Power over Ethernet (PoE) applications, complaint with the IEEE 802.3af-2003 specifications or the alternate PoE (Cisco Legacy) sp ecifications. Each DPoE ...
-
Panduit PN380 - page 7
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Table 1: DPoE Power Components Available from PANDUIT Corporation PANDUIT Part Number Description Individual power supply DPoEPWRB120 Individual power supply - 120 watt power supply – 48 volt output DPoEPWRCM Managed power chassi s - sup ports 3 rectifiers - equipped with Netwo ...
-
Panduit PN380 - page 8
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Package Contents The DPoE Power system chasses ( PANDUIT p art number DPoEPWRCM or DPoEPWRCU) are shipp ed with the following included items. Table 2: Package Contents Item Quantity Notes DPoE Power System User’s Guide 1 This document. PANDUIT part numb er PN380 Cord Brackets 3 ...
-
Panduit PN380 - page 9
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 R e ctifie rs 12 3 Feed 1 Feed 2 A C In N+1 DC Out Feed 3 Figure 1: Individual AC F eed Wiring Architecture Each individual AC feed should be protected u sing a circuit breaker as listed in Table 4: Recom mended AC Circuit Breaker and Wire Sizes . Table 4: Recommended AC Circuit ...
-
Panduit PN380 - page 10
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 CAUTION: ALWAYS FOLLOW NEC GUIDELINES AND YOUR LOCAL COMPANY PRACTICES WHEN SELECTING DC WIRING AND PROTECTION. Table 5: Minimum Recomm ended DC AWG for 90° C Cabling for Unprote cted Outputs shows recommended wire sizes base d on ampacity. The maximum current rating for the cha ...
-
Panduit PN380 - page 11
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 B u t t s pli ces conn ector s P ower conn ecto r ho us i n g w i th w i r e l eads 48 VDC Su ppl y Po w er Co nne ct o r o n r e a r si de of DPo E Po w er Pa t c h Pa ne l Co nne ct or pi no ut s Figure 3: Connecting to a DPoE Power Patch Panel NOTE: The included power harn ess ...
-
Panduit PN380 - page 12
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Table 5: Minimum Recommended DC AWG for 90° C Cabling for Unprotected Outputs Total Rectif ier Current Rating (A) Wire and Lug Gauge (AWG) using 90 ° C wi re (NEC Table 310.16) 1 10 16 20 14 25 12 30 12 40 10 50 8 75 6 Torque Settings The following table shows recomme nded torq ...
-
Panduit PN380 - page 13
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Table 7: PANDUIT Corporation Contact Information PANDUIT Technical Support Fax: 1-708-444-6993 E-mail: cs@panduit.com For Installation Instructions in Local Languages and Technical Support www.panduit.com/resources/install _maintain.asp Worldwide Subsi diaries and Sales Office s ...
-
Panduit PN380 - page 14
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 I EC320 AC cord Cord Bracket Sec uri ng Screw Figure 5: Cord Bracket Figure 6: Chassis (Rear View) - AC Connections #4-4 0 S cr ews Figure 7: Securing Cord Bracket to Chassis 9 ...
-
Panduit PN380 - page 15
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 DC Output DC connections are acco mplished via the rear termin al blocks and bulk output conne ction as shown in Figure 9: Chassis (Rear View) - DC Connections . GMT-fu sed connections are accompli shed via the rear compression screw termin al block t hat will accept wires sizes ...
-
Panduit PN380 - page 16
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Ethernet Connections The Ethernet port on the back of the DPoE Power Sy stem chassi s is used to provide the conn ection between the NIC card and the manage ment system. Test and Turn-Up Power Up Once all AC and DC connections have been se cured and checked, install each re ctifi ...
-
Panduit PN380 - page 17
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Short Circuit and Current Limit I Limit can be adjusted up to +105% of the rated current of the rectifie r (See Table 4: Recommended AC Circuit Breaker and Wire Sizes ). The system voltage will remain constant up to I Limit at which point the system voltage will drop quickly towa ...
-
Panduit PN380 - page 18
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 This following information is only applica ble to chasses with NIC cards. The NIC card can be connected via a standa rd straight through RJ45 patch cord (such as PANDUIT part number UTPCH3 or UTPSP3), through a hub or router, or via a crossover cord fo r direct connection. Additi ...
-
Panduit PN380 - page 19
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 Parameter Description Default Setting BDT TIME MNT Sets the length of time (minutes) that the battery test will run. 30 min. BDT ALRM Voltage Sets the voltage at which an alarm will be generated if the battery voltage falls below this level during the battery test. 52 VDC BD ABRT ...
-
Panduit PN380 - page 20
PANDUIT DPoE Power System User’s Guide Issue 1.0 Part Number: PN380 15 Parameter Description Default Setting High temperature alarm release (NIC Card only) The temperature value at which the controller will release a HIGH TEMP alarm. (For systems usin g the NIC card only.) 93 °C Password Administrator/User 5001 ...
¿Tienes una pregunta acerca de Panduit PN380?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Panduit PN380, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Panduit PN380 probablemente compartirá una forma de solucionarlo.