-
Casablanca Fan Company 32xxA - page 1
1 CIRCUIT BREAKER (TRIP BREAKER FOR THE CIRCUIT YOU WILL BE WORKING ON) FUSE BO X (REMOVE FUSE FOR THE CIRCUIT YOU WILL BE WORKING ON) 18 ″ 84 ″ 70 ″ The blades in each pack are matched for equal weigh t to assure sm ooth fan oper ation. If m ore than one f an is being in stalled, be car eful not to mix blades fr om differen t cartons . ? ...
-
Casablanca Fan Company 32xxA - page 2
2 Calculation of 32° Use the tear-o ff Ceiling Angle T emplate card inserted in the back of this m anu al, it pr ovid es you with a simple ‘g o’ or ‘no-g o’ for in stalling your f an on a sloped ceiling. SLOPED CEILING INST ALLA TIONS MOUNTING RECOMMEND A TIONS 7’ MINIMUM P ole Length Standard Standard 6 ″ 12 ″ 12 ″ 18 ″ 24 ″ 3 ...
-
Casablanca Fan Company 32xxA - page 3
3 Unpacking: Befor e assemblin g and installing your ceiling fan, r emove all parts from the shipping cartons and check them against th e parts listed her e . Befor e discardin g packagin g materi al, be certain that all parts have been rem oved. STEAL TH INST ALLA TION INSTR UCTIONS F AN PREP ARA TION PERMA LOCK™ HARD W ARE S t e a l t h ® ...
-
Casablanca Fan Company 32xxA - page 4
4 CROSSBAR MOUNTING BRA CKET INST ALLA TION JOIST CEILING WIRING CROSSBAR MOUNTING BRA CKET FLA T W ASHER GREEN GROUND WIRE CEILING F AN APPRO VED WIRING BO X RIDGE SIDE DO WN APPRO VED OUT - LET BO X HARD W ARE Note: After removing the old fixture , check the outlet box to insure that it is supported by a joist or beam across its upper surface . ...
-
Casablanca Fan Company 32xxA - page 5
5 CANOPY INST ALLA TION Step 4. Attach th e can opy to the crossbar m ountin g br acket with thr ee o f the 8-32 x 2 1 / 2 ” long canopy screws and lock wash ers provi ded with your Casablanca f an. Han d tigh ten until sn ug against th e ceiling. CANOPY SCREW CANOPY LOCK W ASHER FEED OUTLET BO X WIRES THROUGH CAN- OPY OPENING Note: On sloped cei ...
-
Casablanca Fan Company 32xxA - page 6
6 Step 4. T o hang the fan body in th e canopy , support th e fan at the cen ter of th e glass hold er and top support an d insert the ball in to the canopy openin g. Rotate the f an body until the slot in the ball fits in to the pin opposite the canopy opening. HANGING F AN BOD Y IN CANOPY BLADE HOLDER BLADE TIP BLADE A TT A CHING THE BLADES BALL ...
-
Casablanca Fan Company 32xxA - page 7
7 TIL T THE F AN T O INST ALL LAST CANOPY SCREW B ULB INST ALLA TION CANOPY HA TCH INST ALLA TION CANOPY CANOPY LOCK W ASHER CANOPY SCREW Step 6. Tu ck the wires into th e canopy with the wire nuts pointed upwards , so that the white an d black wir es are on opposite si des of the can opy and all wires are clear of the canopy openin g. Step 7. Inst ...
-
Casablanca Fan Company 32xxA - page 8
8 The wall contr ol installs in the same manner as an ordin ary li ght switch, using an existing junction box and wiring. This contr oller is d esign ed to sign al the fan micr ocomputer as well as perform norm al switchin g operati ons . For this reason the followin g precauti ons m ust be observed: 1. U se only the Casablan ca W-32 wall contr ol. ...
-
Casablanca Fan Company 32xxA - page 9
9 Inteli•T ouch ® Progr ammed into every Inteli-T ouch Series fan is an Automati c Demon strati on Pr ogram. It can be used to fully dem onstr ate an d test the oper ation o f the f an. T o enter the demonstration pr ogram: 1. T urn PO WER o ff for at least three seconds. This will clear the f an mem ory read y for progr amming. 2. T urn PO WER ...
-
Casablanca Fan Company 32xxA - page 10
10 Inteli•T ouch ® The Safe-Exit Progr am gives you about thirty seconds of li ght when you turn the li ghts o ff, enablin g you to exit your h ome bef ore th e ligh ts go out. 1. T urn the PO WE off for at least thr ee seconds . 2. T urn the PO WE on ...
-
Casablanca Fan Company 32xxA - page 11
11 Before Requesting Service: Please follow this tr oubleshooting guide before contacting your dealer for assistance. Caring for Finishes : For cleaning, a so ft brush or lint-fr ee cloth should be used to preven t scratchin g the finish. A vacuum cleaner brush nozzle can r emove heavi er dust. Surf ace smud ges or an ac- cumulati on of dirt and d ...
-
Casablanca Fan Company 32xxA - page 12
12 Step 1. Remove th e two 6-32 x 5/16” screws holdin g the br acket to the h olster . Save screws for later . ...
-
Casablanca Fan Company 32xxA - page 13
13 Install 4 “ AAA ” alkalin e batteries in the space provi ded . Please observe proper polarity placemen t. Replace Battery Door . Open Battery Door by pressin g d own on the insert tab pro - vid ed. Fan Operation TheAdvan•T ouch fan iscontrolled by th e ...
-
Casablanca Fan Company 32xxA - page 14
14 Y ou will ha v e to change the dip switch settings in the remote if you are using more than one fan in the same area and want to contr ol them separately . Step 1. At the cir cuit break er or fusebox, turn th e power off for t ...
-
Casablanca Fan Company 32xxA - page 15
15 TROUBLESHOO TING Before Requesting Service: Please follow this troubleshooting guide befor e contacting your dealer for assistance . Caring for Finishes : For cleaning, a so ft brush or lint-fr ee cloth should be used to preven t scratchin g the finish. A vacuum cleaner brush nozzle can r emove heavi er dust. Surf ace smud ges or an ac- cumulat ...
-
Casablanca Fan Company 32xxA - page 16
16 PRODUCT SPECIFICA TIONS Model Name: Stealth ® Model Number: 32xxA/T Dimensions: A = 10.8" B = 13.25" C = 3" D = 11.5" E = 5.6" W eight: 33 lbs. Motor: XLP-2000 ® Blade Span: 54" Blade Iron Pitch: 14° No. of Blades: 5 T echnology: Advan•T ouch ® W-62 Inteli•T ouch ® W-32 Lightbulb: (1) 100-wa ...
¿Tienes una pregunta acerca de Casablanca Fan Company 32xxA?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Casablanca Fan Company 32xxA, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Casablanca Fan Company 32xxA probablemente compartirá una forma de solucionarlo.